Cars & Transportation - 16 September 2007

2007-09-16 07:34:44 · 3 answers · asked by ash 1 in Ford

Please give me best suggestions out of experience..
I have shortlisted aveo 1.4LS, Verna xi , and fiesta 1.4Exi,
Please give me best option...
For me Mileage + Looks + performace + reliability of car is much important...
Waiting for genuine suggestions

2007-09-16 07:26:44 · 6 answers · asked by bachhu 1 in Buying & Selling

2007-09-16 07:25:30 · 2 answers · asked by Anonymous in Motorcycles

It would be outside of school until school finishes (8-3) and the temperature would be about 45 to -10 degrees (darn minnesota winters!!)

2007-09-16 07:25:11 · 6 answers · asked by Anonymous in Motorcycles

its outside a shop about 10 minutes away and we had to walk back, my dads panicking thinking its going to be broken in, can someone suggest something, the key wont go into the ignition

2007-09-16 07:23:58 · 6 answers · asked by Anonymous in Maintenance & Repairs

I have a liberty, which is a capable little off roader, with a torquey little 3.7L engine, but its rubbish. endless recalls, worn out leather on the steering wheel, interior that stains when rain hits it, back hatch that sticks closed, wobly windows...i bought this pile new, and i will NEVER buy an american car, let alone a jeep again.

2007-09-16 07:15:49 · 11 answers · asked by Anonymous in Jeep

I have a 83 yamaha maxim. recently it stopped starting. now it starts everytime, but won't idle properly. it revs up to 3000 and holds there. if i try to put it in first, it cuts off. and won't even let me shift between gears.

2007-09-16 07:08:53 · 5 answers · asked by sh0cker2679 1 in Motorcycles

i just bought a 05 wrangler and it has a 4 inch lift. it has 32 x 11.5 x 15 tires on 15 x 8 rims. can i put 33 x 12.5 x15 tires on these rims and if so would i have to change gears or anything else. or should i stay with the smaller size tire

2007-09-16 07:08:45 · 3 answers · asked by bajo 1 in Jeep

I'm trying to fiind a yacht company that starts with a "F" Could annyone list the companys that have that. Thanks.

2007-09-16 07:07:15 · 9 answers · asked by Anonymous in Boats & Boating

i have an 03 jeep liberty 2.8crd diesel and sounds very rumbly/even a bit rough at tickover sometimes sort of rumbles a bit doesnt knock,and only done 50k drives fine starts fine just sounds a bit rough at idle has anyone encountered this at all is it something to be concerned about,i know its twin cam,but would that make it run a bit rumbly,revs up fine and no problems,as yet

2007-09-16 06:56:04 · 4 answers · asked by answerwheniknow! 3 in Jeep

I have FWD and I was wondering if popping the clutch would hurt the stock clutch

2007-09-16 06:45:47 · 13 answers · asked by one_hourphoto 1 in Maintenance & Repairs

I own a 2003 Focus SE and it has around 88thousand+ miles on it. I get my usual oil changes and maintenance when something goes wrong but what else should I be doing to keep it as long as I can. The transmission is starting to feel a little harder when I run it, but it's still running ok. It just doesn't run like it used to. Any help or tips on what I should do to keep the maintenance up? Thanks for any tips.

2007-09-16 06:45:45 · 5 answers · asked by Anonymous in Maintenance & Repairs

2007-09-16 06:40:58 · 4 answers · asked by Domenic A 1 in Maintenance & Repairs

My car keeps over heating and the mechanic intalled a new thermostat, but he attached it with sealant. Now my car is still over heating.

2007-09-16 06:39:59 · 4 answers · asked by ? 4 in Maintenance & Repairs

i have a 1997 mercedes e320. i diagnosed the code, it said cylinder 3 , and 5 misfire. what could cause this? thanks guys!

2007-09-16 06:27:49 · 10 answers · asked by Tamas T 1 in Maintenance & Repairs

* pedal is a little spongy and travels a little further than normal
* there is a whooshing sound when I press on the pedal. it's loud and located right where the arm goes through the firewall.
* when I take the vacum line off of the power booster the brakes get rock hard and if i really stand on it the brakes do stop the car.
* i gravity bled and did the old pump and drain bleeding and noticed no air in the lines.
Any help is much appreciated. Thank you in advance.

2007-09-16 06:24:18 · 3 answers · asked by Anonymous in Maintenance & Repairs

im wanting to add a K&N air filter to my '67 289 mustang but idk wut it will add or if i will gain anything by it......so what will it add or anything...thanks

2007-09-16 06:24:02 · 2 answers · asked by Anonymous in Ford

What is the maximum compression ratio I can run before I have to start using higher octane fuel? I found a chart that says anything over 7:1 must use 92 or greater octane rating. However, I just read an article with a builder that used 9.1:1 pistons on 87 octane. Someone want to clarify on this for me? I've also been trying to figure out all of the particulars of a camshaft. I understand everything that can be changed on them, but I don't know how all of the variables affect power and drivability. For example, I was told not to use anything over 230*/230* duration if I wanted to keep the engines drivability (which I do). Is that accurate? What is the maximum overlap I should look for, and how much lift on the cam lobes should I look for?

2007-09-16 06:17:25 · 2 answers · asked by anasasisxenophontis 2 in Maintenance & Repairs

Ok. My Brother and I were working on my 81' El Camino.

I forgot to remove the battery cable. Apparently the carb'ed 305 took the place a fuel injected motor maybe... becuz the wiring harness had massive amounts of plugs unplugged. and you only need the basics for a carb'ed car. one of the plugs arc'ed and the car hasn't been able to start since. I think it fried the starter, I replaced it. Still no go.

2007-09-16 06:15:33 · 6 answers · asked by Anonymous in Maintenance & Repairs

How long does it take to get them after you buy a brand new car

2007-09-16 05:59:16 · 5 answers · asked by Anonymous in Insurance & Registration

i was on a motorcycle and a car hit me and i was sent to the hospital, i dont have insurance cause i had just bought the bike from a private owner. do i have a case against the other driver even thou i dont have insurance?

2007-09-16 05:58:49 · 2 answers · asked by jimjam v 1 in Insurance & Registration

I have a 22' trailer weighs about 4500 lbs. Tow it with a 2000 Escalade which is a Denali with different emblems. I have heard that because of the gearing in a SUV as apposed to a pickup I will likely lose my transmission if I keep towing with it. Is this true? If it is what would be the solution? Lower gears in the front and rear differencials? A shift kit in the transmission? Or changing the transmission to a medium duty truck transmission?

2007-09-16 05:56:38 · 7 answers · asked by puttndutchman 3 in Maintenance & Repairs

and its not the battery cause i got it tested?

2007-09-16 05:41:39 · 25 answers · asked by candyland849 1 in Maintenance & Repairs

by a cop, if you get a ticket, how much is this ticket worth, or is it just a ticket to get you to go fix it and no fines are attached to it. doesnt make sense levying a fine on someone who didnt know one of his headlights failed.

2007-09-16 05:40:36 · 8 answers · asked by Anonymous in Maintenance & Repairs

Am really confused as to which one to pick. Currently I own a Splendour...planning to sell that off and get a new one. Please help.

2007-09-16 05:31:04 · 8 answers · asked by Venky 1 in Motorcycles

Where is the fuel filter located on a 2004 2.4T S60?
Can it be changed by an amature mechinic?

2007-09-16 05:24:58 · 1 answers · asked by Gatsby216 7 in Volvo

2007-09-16 05:08:46 · 5 answers · asked by Anonymous in Maintenance & Repairs

i have a 1990 Toyota Sr5 Pickup the wires are cut for the front drivers side turn signal and im not sure how to re run wires or anythin or what i would have to do to fix this problem i need it fixed it runs out of inspection the end of this month id apreciate if someone could help me out a little with answers thanks

2007-09-16 04:54:47 · 6 answers · asked by Toyota90 1 in Maintenance & Repairs

2007-09-16 04:47:37 · 6 answers · asked by Anonymous in Other - Cars & Transportation

I have a 1992 Subaru Legacy and I am trying to replace the timming belt myself. I have removed everything but I am stuck in removing the crankshaft pulley. Can anyone please give me some advise on how to remove it since it keeps rotating everytime I try to unlock the nut in the middle of the crankshaft pulley.if there are cheap tools, where can I get it and what is the name of the tool that I should use/buy. Thanks, I preciate your input.

2007-09-16 04:46:26 · 5 answers · asked by ashrabs 1 in Maintenance & Repairs