English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Maintenance & Repairs - March 2007

[Selected]: All categories Cars & Transportation Maintenance & Repairs

First i had problem wiith the batter, had it replaced.... then when i turn on the engine it starts but when i step on the gas pedal, the car doesn't move. Put it on reverse and also doesn't move. Also the check engine light appears. Does anyone know what the problem is.? It only has 90000 miles on it.

2007-03-07 10:32:17 · 3 answers · asked by Mai 1

2007-03-07 10:28:10 · 7 answers · asked by mikegagliano 2

I am trying to replace a fuel filter on a 2002 Ford Explorer. The problem I am running into is; The retaining clips are off, but the fuel lines will not slide off the filter. I am wondering if I need to run the vehicle out of gas by disconnecting the fuel pump fuse, If so what number fuse? I have looked all over the internet for repair sites to help out and I can't find a solution in the Haynes Manual for this vehicle. Anyone please help....Any advice would be great.

2007-03-07 10:27:56 · 5 answers · asked by Anonymous

it is a 2003 vectra 1.8ls petrol 5 speed manual the problem with it is that when i press the clutch pedel it goes all the way down very easy and then srings back up they seems to be no pressure on the pedel...... can any1 give me some advise on what it could be and is it a big job thanks

2007-03-07 10:15:54 · 5 answers · asked by Anonymous

i have a 1991 dodge spirit 2.5 non turbo car.. always been good to me and never really had any problems with it it does burn a little bit of oil on my way home from work today the oil lite comes on and it it ticking really loud... i checked the oil and it was a little low.. added some plus some additive to oil to quiet it down any no luck with the noise yet any advice....
thanks in advance dave

2007-03-07 10:10:58 · 5 answers · asked by Anonymous

2007-03-07 10:07:38 · 8 answers · asked by Anonymous

1991 Honda CRX
4 cylinder
It is a cracked head.
When you remove spark plug Antifreeze leaks from where the spark plug was(That's what the mechanic said)

2007-03-07 10:07:15 · 5 answers · asked by Anonymous

In The Beginning: it died on me while i was driving. i was able to start it again but it was idling low. i gave it some gas but it didnt even rev the engine with the gas pedal hitting the floor. I took the alternator & the battery to be checked by 2 different Kragen stores and they both said that the battery & alternator were good. btw, this whole time all lights/cd player/power everything worked. it just didnt start.

Now: A month of not touching the car at all I decide to start it and it WORKS. At first it was running not so smooth and idling at 500 then (i guess to warm up)it started idling at 800-900. 2 laps around my block + 10mins of just running in my driveway between laps, it still runs/starts.

if theres anymore info needed ask away. i need an answer soon.

2007-03-07 10:04:28 · 2 answers · asked by whoofashohoo 1

Is it because there a box of trix that only suckers buy?? Why do they try and race our American Muscle cars? Even with a turbo on that 800 pound go-kart, they still cant keep up with my stock Trans-Am!! I think "wanna-be" when I see guys driving them like race cars. Hey, how much H.P do they get with that 4 foot peice of trunk plastic sticking up in the air??

2007-03-07 10:03:53 · 7 answers · asked by Anonymous

I recenly got a old 84 leather wrapped jauguar steering wheel , that is dar blue in color but it has large spots that are like a tanish white , w/ some timy cracks due to age , what home remedy would restore this , i was thinking mink oil

2007-03-07 09:57:59 · 3 answers · asked by xdimmysayzx 2

My fiance drove her Sebring for about 5 months with way too much fluid in her transmission. As a result the car went into a safemode that kept it in 2nd gear at all times and put a box over every gear on the the dash. At first the transmission would work fine most of the time, but would downshift you into 2nd even at very high speeds. However, it eventually became a problem that happened everytime we started it up, and we eventually realized that it had more than twice the highest hot limit even when the car was completely cold. I have syphoned the fluid down, but we are still having the problem with it staying in 2nd (even after resetting the battery numerous times). I really dont know what else to do, please advise if possible. Thanks.

2007-03-07 09:57:12 · 3 answers · asked by Richard H 1

I changed the timing and all driving belts 2 weeks ago on my Acura Vigor 92. It was going well, until recently. When I start the car, the power pump belt has trouble to drive the power pump. The belt then squeaks very loud until the pump start to be driven by the belt after about 3-5 seconds. The tension is good, and it doesn't do this before. This only happens when I start the car (in cold winter), and once the noise is gone (pump rotates smoothly), there is no sound even when I turn lock to lock at idle. Any one have an idea???

2007-03-07 09:56:10 · 6 answers · asked by e.mechanics 3

okay people, any help would be greatyl appreciated, bottom line is i took my 05 neon to the delearship this morning after it acted up on the road bucking gears and so forth- it's an auto tranny. Now i tell them of situation, say it's only got 22000 miles on it, it's under warranty. fast forwards to 5 pm, i get a call. "this car had been in an accident and had parts in the front end replaced with non chrysler parts, so your warranty is void with this." so, i call other dealership, they say we can't help your car with your extended warranty you bought with us, because it is not a dodge part, and we only cover factory parts as well." so, pretty much, i bought this extended warranty for nothing, as my radiator was already exempt from it. I need help people what can i do? it's 650 bucks to cover a part that should be covered under warranty already. is there something i can do, i am stuck. thanks for the help all.

2007-03-07 09:45:25 · 5 answers · asked by raynics82 2

My radiator is leaking fluid. I've been putting some in before I go places just to get around and it seems to leak pretty fast. What will happen to my truck if I constantly drive around with no fluid? How about if I drive around sometimes without fluid (not constantly)? Basically is it like I can drive around without fluid sometimes and it wont be awful bad, or is it like it can mess up my motor any time even driving without fluid for even a short period of time? I hope you understand what I am trying to say. Thanks.

2007-03-07 09:41:11 · 16 answers · asked by Anonymous

All 4 tires are the same, but the rear 2 are much more worn than the front 2 which are about a year old and have a good amount of tread depth left. The rear 2 are however much older and have less tread depth although I dont think they need to immediately be replaced. My question is should they be in the back or the front? I am starting to notice more and more skidding sounds but im not skidding. You know the tire squeal when you take corners hard. Im not slipping though but I know its not far off. I dont have the money to replace any they are expensive. Oh yea and if it matters I have an all wheel drive ford explorer (97) its not 4-wheel drive, its all-wheel drive. There is a difference. Thanks!

2007-03-07 09:41:03 · 11 answers · asked by djmixmode 2

2007-03-07 09:39:58 · 7 answers · asked by Christian 3

I put a new thermostate in to my daughters car now we are not getting water into the lower radiator hose I read something about purging it Does anyone know how or what my problem might be I'm almost sure it wasn't like that before.

2007-03-07 09:35:32 · 2 answers · asked by della_brown_99 1

how much is the cost to rebuild an engine in a "94" Saturn CL2? thanks You 4 your time again:)

2007-03-07 09:24:15 · 4 answers · asked by mark v 1

my car has been having some trouble would try and try to start after about 10mins it would turn over then it wouldnt turn unless it was jumped now i took the battery to autozone they said it was bad replaced it and now its not doing anything at all. I jumped it and it started then waited and turned it off then tried to turn it on nothing. Jumped it again and tried the alternator test and it stayed running so i know its not that. Any suggestions?

2007-03-07 09:21:07 · 10 answers · asked by Lee 1

The reason i ask this is because I used to have a 1998 white 6-cylinder Camaro coupe and I hated it completely. I spent all of my saved up $11,000 on that damn thing back in December of 2000 and got rid of it in october of 2006. I took it to a junkyard who told me over the phone before I took it there that I could smash the sh#& out of it and totally have my jollies doing it, but then the general manger apologized saying that I couldn't do that there because of policy issues. The person over the phone lied to me.
I just really wanna buy this thing to drive it around a little to remind of that car I hated for so long and then have my jollies on it, but I don't wanna spend anymore than $500 for the car..


I JUST REALLY WANNA DO TO THAT KIND OF CAR THAT I'VE WANTED TO DO TO MY CAMARO FOR THREE YEARS NOW.

thanks you, i'd really appreicate it,
Steve

2007-03-07 09:15:46 · 1 answers · asked by Anonymous

1999 Mazda B4000 with check engine light on. Error code is lean on both banks.

2007-03-07 09:12:28 · 6 answers · asked by JoelMacDad 6

I have a 1989 Cadillac Fleetwood Coupe DeVille in mint conditions that was given to me by my mother, but it has a bad crankshaft. Every mechanic i've contact in Chicago said the engine is not worth rebuilding so I would like to replace it with a quality used engine. It is a 4.5 motor and I don't have a clue where to purchase a used motor in Chicago.

2007-03-07 08:55:44 · 4 answers · asked by mal735 1

I need to take care of this as inexpensively as possible (ie. no auto shop place hopefully) is it the motor? there is no movement, no noise. nothing. can i get a motor at a parts yard? can i replace it myself fairly easily? any help is appreciated. thank you.

2007-03-07 08:42:02 · 3 answers · asked by rhiannon6305 1

I am goign to be towing my quad out, I have the hitch but I need the square part with the little silver ball that it hooks on to and I cannot remember what that is called?

2007-03-07 08:38:19 · 6 answers · asked by Anonymous

i was wondering with parts and labor how much the cost would be to replace 1 cylinder in a 4 cylinder 1994 saturn thanks 4 your time

2007-03-07 08:35:09 · 4 answers · asked by mark v 1

I am trying to order replacement parts for the car and have found where it list the "left side" and the "right side". Are the sides determined from looking at the vehicle or sitting in it? Ie: Is the "right side" the driver's side or the passenger side?

2007-03-07 08:32:57 · 15 answers · asked by benandminpin 1

Im wondering if anyone has done this themselves or bought something to do it? We are looking at golf carts to drive around in the desert ( live in Arizona)... most of the ones we saw the back seat is rear facing. We want to get that to be forward facing, since we want to take the kids. We dont like the idea that they are sitting rear facing. Does anyone know where you get those parts... or from personal experience... what did you do yourself to get it turned around?

2007-03-07 08:32:33 · 2 answers · asked by JustWondering 3

fedest.com, questions and answers