Maintenance & Repairs - December 2006

They say you can pick it up at any parts store but what is it called?

2006-12-02 09:38:06 · 4 answers · asked by Casey 3

2006-12-02 09:31:08 · 5 answers · asked by Anonymous

Could this be remedied by a garage that does alignments?

2006-12-02 08:11:22 · 9 answers · asked by Jon M 2

my 2000 ford taurus doesnt have any heat..just cold air comes out.

2006-12-02 08:04:09 · 4 answers · asked by HENRY M 2

My 2000 Ford Taurus cigarette lighter doesnt work.I checked the fuse..thats ok..what else could it be?

2006-12-02 08:01:05 · 6 answers · asked by HENRY M 2

2006-12-02 07:53:32 · 7 answers · asked by Allison O 1

2006-12-02 07:26:02 · 9 answers · asked by insanewayne69er 1

I am going to do a tune up and want to know what the people use and what works. Recommendations please. THanks!

2006-12-02 06:49:15 · 7 answers · asked by suavemonkey14 1

What else could be the problem? All fuses and circuits have power.

2006-12-02 06:41:29 · 4 answers · asked by skdawl 1

Is there a way to quiten a noisy rod bearing less dropping the oil pan and changing the bearings? Thanks

2006-12-02 05:55:44 · 9 answers · asked by Anonymous

F250 4 x 4 1988 gas engine.

2006-12-02 05:47:10 · 7 answers · asked by Karen S 2

I took my car to a repair shop...they said I need a throttle position senor..They put that on and I'm still having the same problem...and my check engine light comes on. My problem in the frist place was the transmision...it don't slip but more like adown shifting could anyone please help me with this. Jennie

2006-12-02 05:45:23 · 7 answers · asked by jeanie 1

2006-12-02 05:37:06 · 8 answers · asked by Anonymous

Is this a sensor that need to be replaced or do I have a vacuum leak or something? The bad thing is that it tuned my check engine light on and that is just annoying.

2006-12-02 05:36:09 · 6 answers · asked by FuzzyJared 1

They are small enough not to hamper visibility so safety is not issue. Have heard there is something that might work.

2006-12-02 05:30:56 · 2 answers · asked by murphy 5

I thought that when main bearings go bad, pressure drops when you rev the engine. My pressure is at 0, but it goes up to 20-25 pounds when the engine is revved.

2006-12-02 05:11:31 · 8 answers · asked by jeff_is_sexy 4

I have a 1995 Geo Prizm, replaced fuel pump and fuel filter, car still won't start. Anyone know the problem? Definitely not starter or battery problem.

2006-12-02 05:04:03 · 11 answers · asked by traciemjones9 2

If I turn on the left blinker in my car it doesn't go on and the dash board indicator doesn't go on, and the little clicker noise doesn't sound. When I turn on the right blinker it goes on but blinks faster than normal.

2006-12-02 05:02:41 · 11 answers · asked by FuzzyJared 1

I got a Z28 Camaro with the LT1 2 months ago. After about 1000 miles, the car lost oil pressure on the highway and upon inspection we found that the main bearings had spun on the #7 and #8 cylinders. We rebuilt it - the block was line bored, crank and rods 7 and 8 reconditioned, and new rings and bearings were installed. Now, 1000 miles later, the car has lost oil pressure again.

What could cause the bearings to fail twice in a row like this?

2006-12-02 04:59:14 · 6 answers · asked by jeff_is_sexy 4

2006-12-02 04:58:41 · 8 answers · asked by ryan d 1

someone gave me 4 new old stock bias ply army jeep tires,im going to put them on my 2005 jeep.

2006-12-02 04:34:50 · 6 answers · asked by Anonymous

Replaced brake and drive axle passenger side. All of a sudden instead of 28mpg I'm getting 19. I don't know how to get the obd codes out or what they mean and can find no cheap info. I do know I have a slight problem with the ignition coil but have had this problem for 150,000 miles or more and don't believe it is at the root of my current problem. I am at a loss on where to start with this problem please help in any way possible. Thanks.

2006-12-02 04:14:57 · 5 answers · asked by edward f 1

2006-12-02 04:12:00 · 3 answers · asked by Ray 1

Well I screwed up big time in Bostonlast night some guy was laying on the horn while I was doing a three point turn with my car. Unfortunately I backed up so fast my right rear tire went up and over a ten inch curb at about 5 mph or so and I could hear the exhaust scrape. I drive a full frame 2002 Mercury Grand Marquis. The car seems to drive fine after the curb hop. My question is could I have seriously damaged anything? The only thing weird I notice is my car's steering wheel is slightly off centered even though the car drives straight. Im really worried and not in the best financial shape to fix major damage could anything be seriously damaged???! Thanks in advance

2006-12-02 04:01:03 · 5 answers · asked by Anonymous

2006-12-02 03:56:08 · 5 answers · asked by MJC 1

2006-12-02 03:35:15 · 4 answers · asked by ian m 1

the car is 1997 buick centra

2006-12-02 03:25:44 · 9 answers · asked by jrgdmg 1

is it a myth or is it really true? and if it is true, why???

2006-12-02 03:22:58 · 7 answers · asked by Fishboy 2

My heat dosent work in my car. Im thinking of buying a heater that plugs into a ciggerette lighter. How well does this actually work? Is it worth buying?

2006-12-02 03:13:44 · 3 answers · asked by freakyhazerd 1

my car was out of anti freeze and after sitting outside over night it wouldnt start we got it in the heated garage it did'nt even push the soft plugs out it is getting gas and acts like it is going to start but it wont actually turn over and start....any ideas we cant afford to hire someone thanks for your imput

2006-12-02 03:07:56 · 5 answers · asked by Anonymous