Maintenance & Repairs - September 2007

Now, I had this done on one of my vehicles and it cost me about 700 bucks. I really can't believe that everyone driving around changes their timing belts at 60k. Of course, I realize that if it breaks, trouble will follow. Still, it seems to me that this recommendation is playing on people's fears.

2007-09-14 12:29:31 · 13 answers · asked by whitejd43 2

my friend has a late model ford probe which had many leaks and milky oil he purchase water glass from a pharmacy and now drive the car without an oil change.he checked the milky oil after some drive time and the oil was clean.

2007-09-14 12:24:55 · 2 answers · asked by Anonymous

I read a lot of question on how or can we make the odometer show less mileage or reverse mileage. What I like to know is, Is there a way to make your cars odometer show more KM or Mileage than you normally use.

2007-09-14 12:16:35 · 6 answers · asked by Roger 1

I refilled the fluid and a week later it seems to have disappeared -- so, something is leaking. I think the worst news would be if it's the compresser. What are the other possibilities of where it's leaking fluid? How much is this likely to cost to repair? I live in the Atlanta area.

2007-09-14 11:53:33 · 5 answers · asked by Corinnique 3

My husband is trying to fix his brakes and apparently the rotors are rusted to something preventing him from replaceing the pads...I have heard allot of hammering and I know they are using somekind of spray lube...and scraping rust...any of you Yahoos have a suggestion maybe something that worked for you? It's a Ford expedition if that helps

2007-09-14 11:40:43 · 6 answers · asked by Jennifer 3

I purchased a 1991 Civic that needs both rear power window motors replaced. I found the same car at a salvage yard and tried to pull the motors but cannot figure it out. I removed all of the screws holding the motor to the door but there is one more bolt connecting the motor to the window. The problem is I cannot reach it because the window in in the "closed" position. How can I lower the window so that I can access the bolt? OR, how do I remove the bolt with the window closed?

2007-09-14 11:30:13 · 1 answers · asked by David L 3

2007-09-14 11:11:45 · 6 answers · asked by Anonymous

2002 car doesn't use any oil, until we get to about 1 plus years without changing it (only do <2000 miles.year). Then it will go down 1/6 of quart per 1000 miles driven.. No leaks.

2007-09-14 11:06:56 · 4 answers · asked by Anonymous

that there are front end and steering problems in the older models? Anyone here have one and know anything about any common mechanical issues. The car we are purchasing has 33K on it. Its an SE model with 2.7 litre engine. Thanks! Have a great day!

2007-09-14 10:57:21 · 3 answers · asked by Anonymous

I have a 2001 GMC Jimmy, 4.3 Lt, automatic.The engine has gas and new spark plugs.It has spark but won't start. When you crank it, it almost starts.Could it be weak spark ? Anyone know what could be wrong ?

2007-09-14 10:51:57 · 5 answers · asked by Clayton G 1

I wanted to know how to build a 1-2 cylinder, simple, enigine I can build at home. do you know how or know any websites or books i can find that information in?

2007-09-14 10:50:49 · 2 answers · asked by j Jay 3

I think it's a conspiracy with manufactures and dealers.

2007-09-14 10:47:25 · 14 answers · asked by lu_dicrous 3

They said they alter the aerodynamics of my 'squarish' car. If it saves on petrol, that will be a help. Anyone tried them?

2007-09-14 10:24:38 · 25 answers · asked by poppy vox 4

How do I know if mine is plugged up?
My truck is a 1995 Dodge Ram with V-6 and 239,000 miles
I believe it has been running rich cause the pait near exhaust pipe has a tan color and smells a little rich in exhaust fumes.
If it is severly clogged up can I run a pipe off Y pipe straight back to a cheap muffler?

2007-09-14 10:13:11 · 4 answers · asked by Anonymous

My breaks operate very rough when initially driving the vehicle, then after a few minutes the ABS Light comes on and stays on, resulting in smooth break operation what can be causing this problem?

2007-09-14 10:12:46 · 1 answers · asked by Anonymous

2007-09-14 09:14:10 · 5 answers · asked by Anonymous

I have 198* jeep cj7 with a 258 inline 6 and i'm trying to figure out what year it is. I'm rebuilding the engine and the casting number is giving me either 79' 80' or an 81'. the jeep has a SR-4 4spd transmission and a Dana 300 transfer case but it has no vin # complements to a YJ body conversion. So what i'm asking here is what are the differences in the engines of those years and/ or would it make any differences in the kits? Also any extra informations and informative websites would be greatly appreciated. Thank you in advanced

2007-09-14 08:51:38 · 2 answers · asked by nick_dyke4x4 2

My boyfriend has a Ford Aerostar and when he hits the brakes the tail lights come on but not when he turns them on to drive at nighttime. He bought the bulbs for it and replaced them but its still not working. Perhaps its not the bulb? Maybe a fuse? Someone help me!

2007-09-14 08:48:00 · 2 answers · asked by Sexxy Annie 2

.. now the truck turns over but wont start.. also the volts meter says 0.. like my hud.. nothing works when i turn the car on.. on. is my fuel pump not getting electricity? my stereo works... power seats work.. windows work...

2007-09-14 08:46:59 · 2 answers · asked by midi_junkie 3

I took my car to a shop that I've had oil changes & also prior inspection. My car is used but excellent condition; purchased 2 yrs ago, new brakes & more. Owner of shop told me how impressed he is w/condition of car. I drive it short distances only; my office is 5 miles from home so have little mileage since purchase. Owner was out for this 2nd year inspection last week so his son worked on my car. After a short time he showed me the brake pads were worn but that all else was in good condition. I told him to replace the pads. Over an hour later I went to pay the bill & it was nearly $400.00. I found he not only replaced the pads but rotors as well. I told him I had not authorized him to do anything but replace the pads. He said that even though they were in good condition they were a little worn on one side & that they do not like to turn the rotors as "they use to do in the old days" so they replace the rotors too & that I should I should know this. I had to pay or not get my car back

2007-09-14 08:43:30 · 8 answers · asked by LAURA C 1

For Example I have heard Wix, Mobil 1, K&n in no order are excellent.

2007-09-14 08:40:12 · 6 answers · asked by Anonymous

I took my 2003 Toyota Camry 2.4L in for an oil change. The parts store said it takes a PH4386 they have been using a PH4967. What is the difference, should I be worried?

2007-09-14 08:39:48 · 3 answers · asked by Anonymous

I have a 1999 Toyota Sienna that developed a problem with the digital clock, interior lights and external, electric door locks at the same time. Is there a fuse or something that is common between these? Where would it be located or what else should I check. Thanks!

2007-09-14 08:28:44 · 1 answers · asked by Rick 2

During oil changes I keep getting the "do you want high mileage oil?" of course it is more exepensive but do I need it? (150K)
Also thanks to all who answered my last question.

2007-09-14 08:03:52 · 10 answers · asked by Bill R 1

the wheels are all locked tight it seems to be something with the steering is it possible? its mainly after 60 or after hitting a bump on the road, what could it be it shakes really really hard i have to move the wheel from side to side so itll drive ok again but its starting to be more common what could it be? i know for sure its not a bump on the wheel because it only happens sometimes, and its not due to the wheels being loose ive checked and rechecked but thats like the best way to describe it my friend said something about the steering being bad what could it be exactly?

2007-09-14 07:39:21 · 8 answers · asked by Anonymous

Just trying to setup a new auto repair shop really small size about 12 cars as daily turnouts or throughputs, what are the most relaible and user friendly/inexpensive shop management softwares commonly used?Auto shop owners, can you give helpful inputs please? Thanks.

2007-09-14 07:12:25 · 5 answers · asked by Anonymous

Such as Midas, etc......

Also, is it true that a customer should not have to pay a dime when getting something fixed under warranty? I went to my local Mitsubishi dealership, and they told me I had to pay 120 bucks before. I dont know whether I get that money back or what?

2007-09-14 06:58:38 · 7 answers · asked by carmelballer@sbcglobal.net 2

Engine is a 1970 460 Ford Big Block. I noticed that all of a sudden I have a very noisy rocker arm assembly on the left bank (drivers side). So I pulled the valve cover to have a look, and sure enough, one rocker arm was no longer seated on its push rod. As soon as I touched the push rod, it slipped out of its seat and fell into the block. Can't even begin to see it. Any motor heads have any suggestions?

2007-09-14 06:42:57 · 3 answers · asked by Paul 1

I cant get to the battery to conect jump leads. Distance to be moved only 15 yards.

2007-09-14 04:50:35 · 6 answers · asked by Anonymous

Almost everytime it rains or the roads are wet, my Sedona makes a schreeching sound for about 1-4 seconds, usually when I am slowing down, but not necessarily with my foot on the brake - sometimes it happens when I've taken my foot off the accelerator, but not touched the brakes yet. Only happens every once in a while. Had the brakes done about 5 months ago - new brakes - any suggestions on what this noise might be?

2007-09-14 04:47:43 · 3 answers · asked by zan 2