Maintenance & Repairs - July 2006

Does cruise control give better or worse fuel economy?

2006-07-26 07:59:11 · 11 answers · asked by lick_my_decals_off_baby 2

2006-07-26 07:56:41 · 7 answers · asked by blakhaze2001 1

2006-07-26 07:49:55 · 4 answers · asked by mom to six 1

2006-07-26 07:48:30 · 8 answers · asked by uqdah2000 2

2006-07-26 07:45:27 · 2 answers · asked by blakhaze2001 1

The dealership wants $$$ because there is a computer chip and the car has to be reset -- i think they're just trying to charge me for an hours worth of labor. Has anyone had any success with just getting a regular copy of the key made?

2006-07-26 07:45:26 · 18 answers · asked by liliskivt 1

I have a 2001 Audi A4 1.8T

2006-07-26 07:42:53 · 11 answers · asked by cruz734 2

2006-07-26 07:42:00 · 6 answers · asked by Michael K 1

2006-07-26 07:36:45 · 3 answers · asked by Genise P 1

1989 ford f250 4x4 460 engine

2006-07-26 07:33:45 · 2 answers · asked by Michael K 1

2006-07-26 07:31:26 · 1 answers · asked by Genise P 1

After starting the car two days ago, the check engine light came on. When I pulled over and stopped, I noticed it was idling very low. On the RPM, the need was hovering just above zero.
Normally, It hovers just above 1(000).

What is strange, is that, despite idling so low, the car does not stall out. Also, when the car is first started, it idles normally and after a few minutes begins to idle very low.

Any idea what's going on? Thanks for the help.

2006-07-26 07:29:27 · 3 answers · asked by Anonymous

Need assistance in fixing this problem. The cluster came from a 1994 trans-am. Everything else works but the tach. I tried removing the little black box located near the ignition coil, (Tach filter), and it still didn't work.

2006-07-26 07:23:47 · 1 answers · asked by Ted T 1

2006-07-26 07:21:46 · 6 answers · asked by Anonymous

I am looking to purchase a 2003 Lexus ES300. I have been burned before by used car repairs. I would like to compare the average repair cost on this vehicle to a 2004 Toyota 4 Runner.

2006-07-26 06:59:31 · 2 answers · asked by Anonymous

I am referring exclusively to parking the car, not in emergencies, etc.

2006-07-26 06:47:56 · 30 answers · asked by O M 2

My 1997 Voyager 3.0L: The check engine light came on. I read the stored code and it is P0140, which is the oxygen sensor behind the Catalytic converter. Should I replace the sensor and how hard is it to do on that engine? Do I need special tools? Is is reachable from under the car?

2006-07-26 06:31:49 · 4 answers · asked by nicomp 4

2006-07-26 05:54:38 · 11 answers · asked by endo1277 2

I am replacing the hub assembly, and the one of the three bolts holding the hub assembly in place is stripped. I have already spent more than I wanted on parts, any inexpensive suggestions?

2006-07-26 05:43:45 · 8 answers · asked by Andy 3

Well here is the problem with my FORD, it just won't shift, I start the car and and play with the shifter (automatic) and it just would not do anything in the tranny. If anyone could tell me what the problem could be, that would be essential.....I asked arround at different shops and the mentioned that it could be the actual transmision......I have a feeling that they are just beating arround the bush.......??

2006-07-26 05:37:16 · 2 answers · asked by Hamed B 1

When I take it on a 50 mile + trip, sometimes the rpm's will go to zero and the engine will die when I put in the clutch and and take it out of gear. Then after it sits over night the rpm's will run really high when I start it, and then after running a little bit, goes back to normal. the check engine light is on when all this happens, and it only SOMETIMES happens. What could this be? Easy fix, or major tune-up needed? oh and is now backfireing a little when it happens. Do I get bad gas sometimes? Or maybe something bigger?

2006-07-26 05:32:23 · 4 answers · asked by cutiepie 2

Only when I start my engine in the morning, or after many hourse of being off, and then I drive a bit will my engine idle get rough/stumble when I apply the brakes.

As soon as I put the gear in Park, while still holding brake down, the idle will get better. The idle will completely smooth out when I then take my foot off the brake, but if i put it back on, it'll get rough again.

I have done a complete fuel injection cleaning and replaced the air/fule filters, spark plugs, and fuel pressure regulator. Any help would be appreciated.

Is it possible this could be the brake booster having a vacuum leak, or any other type of vacuum leak?

Thanks in advance.

2006-07-26 05:17:03 · 2 answers · asked by Ariel G 1

2006-07-26 04:25:24 · 4 answers · asked by Christopher V 2

Please say which country you are from

2006-07-26 03:11:33 · 8 answers · asked by Anonymous

2006-07-26 02:39:04 · 8 answers · asked by EJ L 2

looking to replace a particular part in my car causing noise from my rear end tire. only problem is, i need to see a picture of the underside on a 1991 toyota camry cause i don't know the name of the part.

2006-07-26 02:34:49 · 7 answers · asked by yves h 1

can i use 10w 40?

2006-07-26 02:32:56 · 9 answers · asked by chris r 1

2006-07-26 02:10:44 · 19 answers · asked by henry_o01 1

2006-07-26 01:57:13 · 11 answers · asked by myers 1

2006-07-26 01:46:23 · 5 answers · asked by myers 1