It happens when i come to stop at a light or after i stop (for gas) and crusing down the highway it starts to cut off and i have to restart on road.
I think it is some sensor because i replaced:
Fuel pump - (in tank) It was going bad anyway as it turned out (no fuel pressure - not up to spec) so this was good
TPS throttle position sensor
Ignition Coil
Distributor Coil
Idle Air Cntrol
Rotor/distbutor
Plug wires
Plugs
Air filter.
Of course, It runs much better as these DID need changing but, it still stalls. Seems to be no way to predict conditions that occur to cause the engine
shutdown. I noticed the lights did go out once when it was about to stall. But that doesnt happen every time.
I dont have enough $ to replace all the sensors and / or the EMT computer (unless you know that is what is wrong).
The van usually starts back up but sometimes with difficulty. Sometimes I must turn off the key and try again to get it started. Otherwise, if I start
cranking it then it doesn't fire up. It's like it is not getting fuel, but, see details below for what I have replaced.
Anyway, no codes come back. it failed while on the analyzer and they still couldnt figure it out. I was told a relay could be bad too. I switched all the
identical relays around but no luck.
--------------
The parts I want to try next are expensive so I am trying to narrow this down:
Ignition Switch
Crank position sensor
Cam position sensor
MCU (computer)
2007-12-20
12:16:45
·
5 answers
·
asked by
R/R B
1
in
Dodge