Okay,
I have a 1998 Ford Explorer. 4.0 engine.
The check gage light came on, the needle was on H.
I flushed the radiater.And put in new fluid.
Still runs hot. When I go to cut the car on in the morning the needle is on cold, then after driving about 5mins it goes to the middle where it always is, then after 10mins it goes to the H, then it goes between the middle and H, so I would say still hot.It stays that way for a while then repeats everything over again.I only speed up to about 45mph or slower, I haven't tried to go over. I cut the A/C off, but makes no difference if I run it or not, still heats up.Do I need a new thermostat or what?? Everything under the hood sounds the same to me.Could it a be leak?Please Help!! Thanks.
2007-09-20
12:57:00
·
11 answers
·
asked by
Anonymous
in
Maintenance & Repairs