Other - Hardware - June 2006

2006-06-11 13:20:48 · 6 answers · asked by Ric W 1

I now know how to assemble my own computers, and I also know how to set up a small network, about 10 computers.

I also know how to use Ghost to copy Windows to all the computers in the network at one go.

I also know how to program and use the router, through not completely and mostly only Cisco routers.

Are all these of any use and what good will these do for me? What can I use them for? Any suggestions?

2006-06-11 05:50:42 · 12 answers · asked by Anonymous

2006-06-11 05:40:05 · 4 answers · asked by ((Gaining knowledge.) 2

2006-06-11 04:18:48 · 10 answers · asked by Savor_Savvy 3

If so is there a list of available camera's that you can use (outside of the eyetoy).

2006-06-11 03:00:01 · 1 answers · asked by King H 6

i have a 40 GB harddisk but the BIOS as well as windows is unable to
show the whole disk space!and it rather shows approx. 33 GB only!So,how
can i make my harddisk to show and work on the 6 to 7 GB disk space

2006-06-10 22:18:55 · 18 answers · asked by REPLY! 1

2006-06-10 21:04:34 · 8 answers · asked by Faith838 1

I am planning to burn copies of my graduation movie onto at least 40 DVDs. I heard from one source that burning them one after another would cause overheating and destroy the DVD burner. Are there any experts out there who can confirm that? If it's true, then is it better to give a 15-30 minute break for my intel iMac after each burning session?

2006-06-10 20:07:49 · 6 answers · asked by The Young Creator 2

i don't know... at certain point, my PC starts with the BIOS and says that the speed and frequency does not match up... but when i'm going to configure it, i can't stoke a bit on the keyboard.... it just hungs up and needs to be restarted... what seems to be the problem?! do i need to buy a new motherboard?!

2006-06-10 15:31:29 · 7 answers · asked by frances 2

Can you please tell me where we can find one cheap?

2006-06-10 15:13:40 · 6 answers · asked by coolmom 1

2006-06-10 12:57:57 · 16 answers · asked by lil chicky 3

its a 48x cd rom drive with infra red control capability.

2006-06-10 11:51:26 · 2 answers · asked by Anonymous

2006-06-10 08:03:18 · 5 answers · asked by marbelladog 1

i am buiding(well sort of repairing) a amd(socket a) mobo,256mb ram,40gb hdd,ect and i have a damaged psu
could i replace the faulty psu(180 watts)for the replacement (200watts)
the replacement psu is out of a compaq deskpro 233mhz pentium 2 and i want to put it into the socket a mobo,is it safe,as its 20watts over and what will happen if it isnt compatible,will it just not boot?
i have other psu,s but they are the old type with 2 identical clips,theyre crap
also can you test a mobo with a voltage meter or something similar to see if it is functioning ok,or is there a tool you can buy for such a job

2006-06-10 07:35:44 · 8 answers · asked by brianthesnail123 7

Ok, this will sound really stupid. I feel as though I'm the last person on earth to have gotten one (actually, I haven't gotten one yet, but I will be!) Could people tell me what I need (e.g. cables or software ?) in order to download music into my (soon-will-be-getting) iPod? (I'm thinking of getting an iPod Nano 2GB. Thanks a bunch! ^_^

2006-06-10 06:53:22 · 5 answers · asked by ☆BB☆ 7

Everytime I try to access any disk on my floppy drive I get the same message. "A:\ is not accessible, No ID address mark was found on the floppy disk." Right clicking gives me the same message also, in fact anything that I do that concerns this drive gives me the same message as above.

Can someone help?

2006-06-10 06:24:02 · 3 answers · asked by awvickers 1

i have an onboard "broadcom netxtreme gigabit ethernet" or that is what is shown under network adapters in device manager.
now, is it enough for starting an Adsl connection or should i buy another modem? (if so what is the best?)

2006-06-10 03:43:27 · 3 answers · asked by Loiterer 2

I backed up al my important data on an external hard drive; but I am wondering how reliable this thing is? What if someday it is dead and I cannot read data from it? Any suggestions? Thanks!

2006-06-10 02:50:41 · 1 answers · asked by sailalpha 1

help...my copy of windows xp is not a genuine copy my computer is telling me do i have to buy another copy or can i get round this..please help

2006-06-10 02:16:42 · 10 answers · asked by MICHELLE S 2

it is imperative that i want to run both isdn connection and lan connection

2006-06-10 00:43:59 · 6 answers · asked by thefishyfish2001 1

I want to make a convertor for IDE 2 USB.But I Didn't found it on web.Help me by give info about it or by give me some link.Notice that i don't want to buy it,I want to make it! I want the datails of it,for example microcontroller in it & its program, connections in bitween circuit datails & ...
Thanks.

2006-06-09 23:52:53 · 5 answers · asked by ALI REZA 1

besides the capacity of storage, will the quality of DVD-RW be better than the CD-RW if i intend to burn a movie?

2006-06-09 23:31:52 · 12 answers · asked by watson b 1

I want to get the new macbook 13" 2.0 Ghz with 80 GB upgrade hard drive, superdrive, 2 GB ram upgrade (bought seperately and installed myself), 20" viewsonic LCD, 20" Viewsonic CRT, 200 GB External Maxtor hard drive, logitech 5.1 surround sound speakers with subwoofer and 4 satteliets and 1 center speaker. I am getting all of this for around 2 grand, so basically im asking if this computer is ideal fro video editing. just let me know, thanx

2006-06-09 22:00:13 · 3 answers · asked by redsox122988 1

I checkt driverguide.com and all i found was an update from the BenQ original site..... :(

2006-06-09 21:23:51 · 2 answers · asked by nenica83 1

what does it mean when one says 512mb ram and 1gb harddisk. what is the difference between ram and harddisk

2006-06-09 19:24:10 · 4 answers · asked by Anonymous

what should i do ? i checked all the wires they are attached properly ? plz help

2006-06-09 18:26:41 · 3 answers · asked by mk99 1

Hello, I have recently purchased an MSI MS-6156 Motherboard. I am currently trying to work out how to connect the powerswitch, restart switch and other LED's to the motherboard. It has no markings on it, about how to insert them. I have draw a picture of what the socket looks like. Please check it here: http://img106.imageshack.us/img106/1673/...

If someone could tell me where everything goes i would be so happy.

Thanks, Daniel

2006-06-09 16:35:42 · 2 answers · asked by Peter 1

i am using the prepaid service. I have 56kbps modem, i know it is low! but i am talking about transfer rate of downloading.

2006-06-09 15:47:19 · 9 answers · asked by Manoo 2

2006-06-09 14:24:39 · 3 answers · asked by tried4life 1

2006-06-09 14:19:59 · 6 answers · asked by Section 8 rehab 1