Motorcycles - November 2007

so last night i got crunked and brought my boss along with me by the way i work at target and then i was grinding this hot chick and then i got tired and wanted to go home but i was crunk and couldnt walk home so i got my boss to drive me b/c he is a pacifst who wont drink and likes animals and he was drving me on his moped and i acidentaly threw up on him and he lost control of the moped and crashed into a tree and then proceeded to get all pissed and then i threw up on him again so i decided to walk home.

so am i gonna get fired b/c i like my job and hope he doesnt become pregudiced again me b/c i got a little cr4zy?

2007-11-06 11:21:40 · 26 answers · asked by iuberpwnyou 2

2007-11-06 11:13:53 · 9 answers · asked by Skeptical and Cynical 1

It's on 07 Kawasaki EX250 Candy Persimmon Red

2007-11-06 09:57:44 · 5 answers · asked by sonyab523 2

where can i find an engine rebuild manual for a 2003 kawasaki zx6r?

2007-11-06 09:17:46 · 11 answers · asked by darrell63b 1

2007-11-06 08:42:17 · 9 answers · asked by Steve S 1

I am wondering if i get a sport quad is it posible to put a winch on it. like a 400ex
some people say u can some say no
how do you do it??

2007-11-06 08:19:49 · 4 answers · asked by Anonymous

I cannot start my bike, i suspected the battery but the battery is now fine.. I suspect it to be the carb!

Mainly because the it has been left standing for some time now and i may need to overhaul it.

But before i do, What do you think could be wrong?

Basically, The bike is a kick-start, 1980's single cylinder Suzuki (recently re-built)

I have only one concern with the way it was re-built and that is the TDC position, Would this have major effect on the bike starting, it has good compression but i am unsure of how to get this TDC (top dead centre) position? Would i have to re-build the engine again?

Any ideas, comments, suggestions very much appreciated! Thanks!!

2007-11-06 07:20:30 · 6 answers · asked by Anonymous

I just cleaned out my carb

2007-11-06 07:04:47 · 5 answers · asked by Anonymous

2007-11-06 06:27:28 · 6 answers · asked by Simon M 1

It was acting as if the plugs were going bad, so I changed them out. They were NGK, I replaced with Champion, Gapped at .035. The engine turns over and just keeps turning - no starting. I rechecked the gaps a couple times and I'm sure they are good.

2007-11-06 06:20:50 · 3 answers · asked by Anonymous

2007-11-06 04:52:27 · 13 answers · asked by william g 1

it seems quite a few people on her do just that

2007-11-06 04:33:25 · 31 answers · asked by Anonymous

I paid 5200 for the bike. 16K mi.
it was dropped at a light, but the frame slider picked up most of the damage, the frame slider was replaced and the damage painted over, you can barely tell. No other problems I can see, everything works and a $300 set of hid's came with it.

did I get a good deal, or pay too much?

2007-11-06 04:30:14 · 7 answers · asked by Nate 6

I have a 2003 gsxr 1000 with a leaking front fork. Both the forks were rebuilt about 2k miles ago, and one is leaking again.

I'm a fairly handy car mechanic, but I've never worked on a bike, can I buy a stand and do this myself, or should I take it in?

Since it's already been rebuilt once, should I just buy a new fork/forks???

thanks!

2007-11-06 03:38:51 · 7 answers · asked by Nate 6

i have a craftsman weedwacker 32cc engine mounted on a gas scooter it will only run at full choke and only for 4 to 45 seconds then i have to re-prime it every time its mounted on its side if tat makes a difference

2007-11-06 01:14:52 · 7 answers · asked by jrever 1

zongshen is the name anyone know anything about them

2007-11-05 22:26:50 · 9 answers · asked by Anonymous

I'm paying $ 20 at the Harley dealer for one now and I average 2 oil changes a month in prime time with all the riding I do .Retail outlet or on line -source will do as I reside in Ontario , Canada . Thanks in advance riders , jj

2007-11-05 18:35:14 · 14 answers · asked by Anonymous

when in nuetral, or low gear 1,2,3rd. there is a clattering sound coming from the left side, clutch cover/gear cover, goes away from time to time, clatter is louder when bike has been driven/ Hot. When you pull the clutch lever in sound is gone........ any idea's ????????? clutch job maybe, or worse ?????

2007-11-05 12:40:45 · 4 answers · asked by Brandon 1

A lot about jackets, some about boots and gloves but nary a mention about armored pants. Is it that riding pants are'nt fashionable enough? I don't think I've seen many worn. While I'm here, do you get many waves from Goldwing riders? Do they think their in a class by themselves?

2007-11-05 09:37:23 · 15 answers · asked by Bob 5

2007-11-05 07:39:14 · 14 answers · asked by . 1

I want to know if anyone can tell me where i can buy studs for my motorcyle. I wouold like to put studs on my seat and saddle bags. I also need some kind of tool to apply the studs

2007-11-05 05:54:56 · 6 answers · asked by zane b 2

Could the switch itself be bad? Once in a blue moon it will start using the button, otherwise I have to push start. What else could be causing my problem?

2007-11-05 05:02:30 · 6 answers · asked by Michael L 1

I have and honda vfr supposly 1983 but the chasis says nc21! and the engine says nc13..

is it normal? or is a robbed bike?

what model is really my bike?? help?

2007-11-05 04:35:36 · 2 answers · asked by =) 2

2007-11-05 04:15:26 · 9 answers · asked by edvigil79 1

BIG thanks for all the previous responses.One more concern,which all parts of my motorbike should i cover prior to washing it.Any Diagrams would certainly help.

2007-11-04 22:15:27 · 10 answers · asked by indys 1

Long live the 2 stroke!

2007-11-04 17:06:37 · 11 answers · asked by Montesa 3

Am learning how to ride a motorcycle and am wondering when am slowing down can I wait to change the gears when am at a complete stop or do i have to decrese the gears one by one. I live where there is alot of traffic and it is pain in the behind if i always downshift while slowing down every minute or less. I thought it'll be easier for example if am in 4th gear, I'll stop the bike in the 4th gear...and then shift it back to the first. Will this wear out the clutch quickly?

2007-11-04 16:11:25 · 13 answers · asked by Anonymous

i live in new york state and snow is predicted for this week.
i know some riders live in better climates and can ride all
year long you guys and girls are very lucky. i could ride
alittle bit longer but i hate the thought of salt and whatever
on my bikes. anyways it's been an awesome summer.
ride safe.

2007-11-04 12:38:36 · 18 answers · asked by Anonymous

Turns over slowly, fried ignition? No lights and dash with jump from charger. Any suggestions? Thanx.....zakley

2007-11-04 12:08:52 · 5 answers · asked by zakley 1

So a number of us are fairly regular on here and I thought it would be nice to find out what you guys all have. Biking went beyond being just a passion with me years ago and now I am kind of obsessive compulsive and thus tend to get them and hold on to them too. I am sure all will have an opinion on what they like however I feel no one has to justify there choice to anyone but below is my current stable

Ducati 999 (2006)
Ducati ST2 (1997)
Triumph T140ES (1981)
Honda 400-4 (1979)
Maico 250 Twin Shock (1981)
CEZET 175 wuth PAV Trailer (1974)
BSA Bantam (1971)
Yamaha YSR50 x 2 - (1980/81)
Suzuki GS425 - (1979)
Yamha RD350LC - (1981)
Honda CB250N - (1979)
Honda CB250RS - (1982)
JAWA350 x 2- (1977)

There is not a single one that has not brought a smile to my face and in my book a real biker likes ALL bikes, irrespective of make, model, style or any other genre.

2007-11-04 08:59:37 · 38 answers · asked by ShuggieMac 5