Maintenance & Repairs - May 2007

2007-05-28 02:46:09 · 3 answers · asked by kopietzjj01 1

2007-05-28 02:41:58 · 6 answers · asked by rusty t 1

I have a small stone chip in my new car's windshield, not a crack though. I want to remove it. Can I use some sort of rubbing compound, or some sort of remedy? Or do I have to take it to an auto glass repair shop?

2007-05-28 02:35:47 · 3 answers · asked by basscleff 5

I replaced the alternator fuse 80A on bf car (1999 mitsubishi lancer) car started the first time, now does not... is the battery flat and require a charge???

2007-05-28 02:34:37 · 2 answers · asked by kylisphant 2

2007-05-28 00:50:31 · 4 answers · asked by whosperfetc 1

Started the roto-tiller this year with half a tank of old gas mixed with half a tank of fresh. After it was running and warmed up I took the choke off to the run position with the throttle in the high position and the motor pulses up and down continually. The machine was kept in the shop all winter and I did add some fuel treatment to it after it had been run a while. Could it have picked up something in the carburetor or is it something that will work it self out after it has been used for awhile. We have used it for about three hours so far and have started on a fresh tank of fuel with treatment in it also and it is still doing the same thing.

2007-05-28 00:11:29 · 2 answers · asked by Shep 1

2007-05-27 22:48:42 · 8 answers · asked by unisafari 1

2007-05-27 19:25:03 · 1 answers · asked by mione588 1

Hi,

Tonight while driving home from work, I noticed something -- my steering wheel seemed to slack a bit, and my call pulled to the left while accelerating/ driving at cruise speed; did not pull at all while braking, and pulled to the RIGHT while going in reverse to park.

The car is a 2002 Dodge Intrepid SE, 87k, and hasn't had any problems up until now. Can anyone tell me what they think? I HAVE to have my car for work and school, so I'm hoping that whatever is wrong can be fixed inexpensively (Dear God...)

Thanks so much!

2007-05-27 19:19:16 · 7 answers · asked by Denize 1

how can i tell the engine size by vin num 1992 4 cyl gas pickup

2007-05-27 17:40:25 · 7 answers · asked by ballewjoe_01 1

2007-05-27 17:37:56 · 6 answers · asked by Anonymous

The retaining strap bolts broke on me while driving in town. Replace the u joint and the straps but still have a strange vibration at about 2000rpm. There seems to be a little too much slop with the u joint as it sits in the yoke but I don't know if that would cause it. Please help!!!!!

2007-05-27 17:04:00 · 7 answers · asked by Anonymous

2007-05-27 17:00:35 · 2 answers · asked by Anonymous

what site can i go to that doese not cost any money to find out if it has been wrecked

2007-05-27 16:39:32 · 3 answers · asked by gmannwcoast 1

2007-05-27 16:37:32 · 11 answers · asked by divinemadness 4

2007-05-27 16:29:49 · 1 answers · asked by teresawalrath 1

2007-05-27 16:14:40 · 10 answers · asked by Anonymous

My 500's transmission is slipping. It mainly does it when slowing down to fast, or trying to take off or pass to fast. But, it also does it other times too. It has transmission fluid in it, and it is good and clean. The car only has 43,000 miles on it. Of course it does it after the 36,000 miles is up. Any suggestions?

2007-05-27 16:04:44 · 8 answers · asked by Ducci 3

i got 1994 mustang Gt V8 5.0 liters

2007-05-27 16:02:26 · 5 answers · asked by soccer1 1

What are the things that go on the out side of ur door so that u dont deng the car or when something hits them and not the car if u know plz let me know and if u know a place i might be able to look for some new ones.

2007-05-27 15:55:00 · 2 answers · asked by shawnparty3 1

the only way i can get my car to start up is by dumping gas down the carb. what should i do, get a new carb or add an electric fuel pump????

2007-05-27 15:44:56 · 7 answers · asked by Thomas P 1

i need to see the picture of the diagram of a 1988 gm truck wire diagram

2007-05-27 15:39:14 · 4 answers · asked by Anonymous

2007-05-27 15:31:32 · 2 answers · asked by Anonymous

what type of soap should i use to wash my car with? i heard useing dawn dish soap is bad for the cars paint! so is that true? is it ok to use dawn dish soap? or should i buy something that is meant for the cleaning of a car?

2007-05-27 15:29:17 · 6 answers · asked by Dauski 1

i changed out the rod bearings cuz my engine was knocking real loud. Now i cant start it or even turn the crankshaft with a torque wrench! it's froze up. How would i fix it and what new parts should i get? Or should i just save up money and buy a used engine from a wrecking yard?

2007-05-27 15:19:14 · 10 answers · asked by Anonymous

I have put STP in my Gas tank and and my engine oil is still very clean. It seems all the fluids are fine. This is not the first thing that has happend to my car, and I am getting a little upset about this. Can anyone give me some advice, please!

Thanks,

2007-05-27 15:01:19 · 8 answers · asked by Jeffrey S 1

2007-05-27 14:36:03 · 2 answers · asked by nazareth06 1

2007-05-27 14:33:48 · 8 answers · asked by Anonymous

I have a 1998 ford ranger 3,0 and i was was wondering what is the part that the temperature sensor unit hooks to i have it removed and it has a leak but i do not know what it is called if anyone one can help thanks in advance

2007-05-27 14:31:30 · 3 answers · asked by ? 2

If not the belt size, just the distance between the alternator pulley and the crankshaft pulley. I really dont want the hassle of pulling it off and mesureing the distance so i was wondering if anyone has done any similar work and would know. It would be a godsend.

2007-05-27 14:29:31 · 3 answers · asked by Anonymous