English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Maintenance & Repairs - April 2007

[Selected]: All categories Cars & Transportation Maintenance & Repairs

along with replacing my two front end shocks with kyb suspensions, including the gasket for my oil pan, and the alignment for a 1999 honda accord V6.. I live in Southern California.. Did I pay too much?

2007-04-07 17:57:24 · 17 answers · asked by filosofo tacio 5

I have a 1996 Nissan Maxima, and whenever I am driving at a pretty good speed and hit a little bump, my car wobbles. Does anyone know what causes this?

Also sometimes when going over a bump that makes the car bounce, I hear a creaking noise in the front of the car, like something is loose or bouncing around in there. Can anyone help me answer these questions?

2007-04-07 17:52:19 · 5 answers · asked by DannyL 1

i know removing it is illegal but i was just wondering...

2007-04-07 17:45:49 · 7 answers · asked by Anonymous

It came on all the sudden today. I had been driving it about an hour, during this time I filled up with gas, everything seemed to be fine. I went home, then about 30 minutes later left again and the CEL stayed on after cranking and has been on ever since. The only problem I know the car has is a problem with the brakes, I think it is the calipers but haven't gotten it checked out yet. Would this make the CEL come on like this (I thought the CEL only came on when there was a problem with the emissions) or can there be another problem. I drive a 99 Ford Taurus.

2007-04-07 17:31:53 · 10 answers · asked by ltlluci 3

about a month ago i changed fuel filter and air filter but still my car looses ignition or engine??
here's story of one day.
in the morning i started engine and drove my car to first signal and it turned to green light so i stepped accellator and sudden calm (less than 1 second) after car moved as normal. at noon i was driving on the freeway about 70mile and my front car moved to slow at 55miles so i tried pass that vehicle and my car lost ignition? for less that half second and back to normal.
it feels like engine is dropped. there is silence for half second.like cars moving without starting engine. even passenger notice.
after i get off of freeway went to the mall parking lot and i was waiting for one car backing up from a parking space. About 10~20 sec. my car lost ignition. engine stopped. i restarted engine and everything looked okay.
it started happen about 2 month ago once in 1 or 2 days. but now it happens very offten.
i think it happens when gear changing. PH

2007-04-07 17:22:07 · 4 answers · asked by saywhat 1

I need some type of flasher that will make my regular turn signal lights to flash simultaneously. If they sell them at a store, which one? It's okay if I have to buy it online also? any tips on making my own with 2 different flashers on at different times? Thanks in advance!

2007-04-07 14:55:58 · 7 answers · asked by Beto24 1

Have 245/75r16 tires on vehicle now........want to go to a 265/75r16 tire on a E-250 cargo van ,gasoline engine, will this help increase my mpg? if so how much? serious answers only

2007-04-07 14:42:19 · 8 answers · asked by sm 1

I LOOKED ITHEM UP AND IT SAID TORQUE CONVERTER CIRCUIT PROBLEM AND THE OTHER SAID TRANS FAULT MIL REQUESTED IT HAS 144,000 ON THE CAR PLEASE HELP

2007-04-07 12:40:55 · 1 answers · asked by cmaestro24 1

show a pic

2007-04-07 11:46:48 · 6 answers · asked by fordex 1

I was recently was told by a Volvo mechanic that because of the way that Volvo build there engines. I didn't need to change my oil every 3000 miles but instead every 6000 miles. Is this correct?

2007-04-07 11:36:24 · 12 answers · asked by mtk17 2

I want to run a 20 HP 3-Phase AC Electric Motor from a battery bank. The Motor is rated at 240 Volts @ 64 Amps. I want to control the Motor through a variable frequency Drive With 240 volts DC from the Battery Bank of 20 12 Volt batteries. What size batteries should I use to run the motor at nearly full load (50 amps) for one hour?

2007-04-07 11:13:49 · 3 answers · asked by mathusalum 1

somethimes i have no problem at all.
you can feel when the turbo kick in,but suddenly it doesn't kick in.if i turn of the engine and start again its working properly.
any ideas what can this be?
thank very much
i'm looking forvard for answers.
thanks

2007-04-07 11:00:45 · 3 answers · asked by Marian M 1

I have just had an upper and lower motor mount replaced on my 2002 PT Cruiser.

2007-04-07 10:30:52 · 4 answers · asked by gaby 2

I'm the new owner previous owner changed out the heater core cold air when defroster /or heater is on

2007-04-07 10:25:29 · 5 answers · asked by paulski 1

I have an 87 toyota camry 4 cyl. 205,000 miles. I was driving down the freeway when my car lost speed and just made to an exit and as soon as i got to the stop light my car turned off, and the brake pedal got stiff as well as my steering wheel. i got itto turn on again but now i could hear a rattling noise in front. Got it to turn on but after a few yards, it would turn off again.

2007-04-07 10:24:33 · 7 answers · asked by Anonymous

2007-04-07 09:59:39 · 7 answers · asked by jas011273 1

the Oil is pzl 5w30 Bulk by walmart, is it normal to burn that much oil or is it a sign that i should be concerned?

can i prevent it by putting in better quality oil like high mileage oil?

The car is a Nissan Altima 2000 with 195,000 KM

2007-04-07 07:03:34 · 3 answers · asked by Anonymous

A friend bought an old 1985 Jaguar which sounds great until I saw it - It looks like a second class vehicle the way the paint is so dull. The guy at the detail shop says that buffing it wont help, it is the paint. Unfortunately my friend has little money to spend on a $2000 paint job. I wondered if these $300 paint jobs with just shooting on Clearcoat would shine it up so it looks half decent? Anyone have any ideas other that driving it off a bridge?

2007-04-07 06:49:22 · 9 answers · asked by Anonymous

im looking for a tool that will lift my engine out of my car to put a new engine in,but i dont know the name of that equipment/tool...my husband says its an "engine lift" but cant find it...what is it really called?

2007-04-07 06:07:42 · 11 answers · asked by Anonymous

2007-04-07 05:23:00 · 10 answers · asked by flagmagnets 3

Or just a new switch? My key is very worn, and I don't have a spare. I put wd40 in the keyhole and I got it to start yesterday, but today I haven't tried as hard as I did yesterday. BUT, I am going to try really hard to get it running once more to take it to the shop.

Also oklatom, if I get a new cylinder what do you mean about the security?

2007-04-07 05:13:11 · 6 answers · asked by renni1010 2

How do you pick a door lock without the right tools? Like with a bobbypin and things like that...thanks

2007-04-07 05:10:25 · 11 answers · asked by *Brooke* 3

it is visible on inside of filler cap and can see in fill cap hole on engine but is not on dip stick.
how can i remove?

2007-04-07 05:09:08 · 6 answers · asked by doug_servicetek 3

0

I have been observing lately that the gas meter in my car goes down much more slowly duing the first half tank of gas than the second. Is it possible that one gets better gas mileage with the first half compared to the second. I have a 98 Toyota Camry if that means anything. or, could this just be an optical / psychological illusion? Thanks

2007-04-07 04:02:24 · 7 answers · asked by Michael S 2

we checked fuses got a new switch and our park lights still arnt working all other lights work in car does any one know what might be wrong

2007-04-07 03:23:08 · 3 answers · asked by Anonymous

I have Saab 9000CD, about 10 years old, ABS light is on intermittently while driving. The car was in maintenance recently and no fault was found then.

2007-04-07 03:15:21 · 8 answers · asked by Anonymous

fedest.com, questions and answers