Maintenance & Repairs - March 2007

2007-03-13 15:12:03 · 3 answers · asked by ushutup9999 1

I need a special equipment rathr then ordinary hand-pressed breake.

2007-03-13 15:09:51 · 7 answers · asked by hos-hos 1

My engine is a GM 3800 series II Before i replaced the bearings, the engine had a loud clanking/knocking sound. I replaced the bearings, changed the oil. There's no knocking when i start the engine However, the knocking isnt completely gone. I hear the knocking when i try to accelerate. The other thing i noticed, is my oil pressure gauge goes almost to the red zone, like its losing oil pressure. The other thing i noticed about my other gauges , is that they all seem to get really low, especially when i come to stop. Any suggestions? I love my bonneville and i dont want to get rid of it, but my last resort s to put her out to pasture

2007-03-13 15:09:27 · 6 answers · asked by Anonymous

2007-03-13 14:59:57 · 4 answers · asked by Anonymous

2007-03-13 14:58:45 · 5 answers · asked by Brad 1

2007-03-13 14:56:35 · 6 answers · asked by anglicky 1

2007-03-13 14:35:20 · 3 answers · asked by koma 6

Is the auto labor charges are greater than parts ?Please let me know about Auto repair charges ?
For me labor charges -600 ,parts -200$
which is expensive for labor .
Is labor charges are huge in US?

2007-03-13 14:28:29 · 11 answers · asked by rbharath21 1

I am looking for a cheaper place to buy GM car parts then my local dealarship. I need a part that is not available throught the parts store and can only be bought at the dealship. i know that they are marking up the price alot and was wondering if there is a cheap place to buy parts online

2007-03-13 14:24:14 · 4 answers · asked by slimnottygirl 2

I have a 95 Camaro with a dead 3.4 that has already been jerked. I'm building a carburated 350 that should have over 400 lbs. ft. of torque and the stock Camaro T-5 is not rated for that. I've also ripped out the PCM, so I'm guessing I'll have to install a new speedometer. T-56 are a hot item and are selling used for $1000 and up, and I don't know if I can use my speedo without the PCM anyways. I just want an overdrive stick shift but don't want to spend thousands. Thanks alot

2007-03-13 14:18:23 · 5 answers · asked by Matthew S 1

I noticed that the back tire of my Scion xA looked really low. I went to fill it up but it was very confusing. The owner's manual said inflate to 29 PSI. The tire said maximum inflation 44 PSI. (Quite a difference.) So here are the questions:

1) Should I trust the tire (44PSI) over the manual (29 PSI) because maybe they equipped it with a different tire?
2) When they say "max" (same on my bike tire) do you usually fill it close to the max or far below it?

Thanks

2007-03-13 14:10:21 · 10 answers · asked by Doon 2

The engine light is on and I had it checked with Autozone for uplink sensor which is the sensor that measures the O2 coming out of the engine and into the exhaust.
Additional information: it is a 2001 Hyundai Tiburon 2 litter engine.

2007-03-13 14:08:12 · 2 answers · asked by ◄|| G ||► 6

2007-03-13 14:01:13 · 3 answers · asked by anna a 1

It appears that the fuel cap sensor is going off and despite me changing the gas cap it is still lights up. Shops are asking for $80 diagnostic but I think the issue can be solved much easier and I don't have the money.

2007-03-13 13:53:55 · 2 answers · asked by ◄|| G ||► 6

I have been traveling a lot lately and I think my truck is burning oil. It's a older vehicle 1993 toyota sr5. It had a new engine put in it over 3 yrs. ago. 40,000 miles. Any suggestions on how to check and fix this problem

2007-03-13 13:35:53 · 8 answers · asked by John Crow 1

i have a black car with dried water spots, how can i get rid of the spots?

2007-03-13 13:27:20 · 8 answers · asked by phil39560 1

Give me all the suggestions you have.

2007-03-13 13:11:57 · 4 answers · asked by Bubbo 1

hi, i have a black toyota corolla 93, there is little rust appearing on the front fenders and rear panels above tyres and a small spot on roof, u know canadian snow and salt(:

it looks like surface rust. what should i do to prevent it from getting worse and from spreading.

the hood also has rust

need help

thanks

2007-03-13 13:06:46 · 5 answers · asked by cuteman 3

I am assuming I need to access the ignition switch. I have done things like adding OEM fog lights and I know where the alarm system is located under my dash. Any help please!

2007-03-13 13:00:51 · 2 answers · asked by Anonymous

I have a 2003 Toyota Corolla that has hit 99,000 miles. I have kept it in excellent shape, including oil changes every 5000 miles.

All I know is that it accelerates very poorly (just happened today), and the moment I take my foot off the gas, the car slows down tremendously. I'm really afraid to drive it. I'm taking the car to the dealership asap tomorrow morning.

Any ideas as to what could be wrong and the cost of repairs? I know it's asking a lot with such little information (sorry, I'm really worried about it!) THANK YOU!!!

2007-03-13 12:51:05 · 7 answers · asked by Jess1023 1

i have a 1973 chevelle laguna, it has a rebuilt 350 motor in it. Its probably got under 200 hp on it. Pretty much everything is stock, except for that we have a 4 barrel carb on it. other than adding headers and dual exhaust wat can i do. And i want to keep it under or near 1,000 dollars

2007-03-13 12:48:21 · 9 answers · asked by Anonymous

2007-03-13 12:42:27 · 4 answers · asked by r77r7r 2

i know that i can sign up for the tests and whatnot...but what do I do about actually becoming educated so that I can take the tests? is there a book that I buy? an online course?

2007-03-13 12:38:18 · 4 answers · asked by coryengle 2

I have a short after the engine dist box on a 92 f150. I have pulled all fuses, breakers, and relays one at a time.

2007-03-13 12:37:34 · 2 answers · asked by Harley H 1

2007-03-13 12:22:24 · 1 answers · asked by haupt80 1

2007-03-13 12:20:03 · 2 answers · asked by distantmountain99 1

My 2003 Toyota Corolla has 99,000 miles on it. I was told that I could let the car go about 2000 over the due date for an oil change. It's currently over 1500 miles since the due date (making it 4500 since last oil change).

I only drove it an extra 5 miles home when the problem occurred. It doesn't accelerate easily, and if I let go of the gas for even a second, the car slows down tremendously.

I'm getting the oil changed tomorrow morning first thing, but I'm afraid I can't make it to the Toyota dealer, which is about 10 miles away. How many miles do you think my car can make?

What kind of repairs / costs will be necessary for repairs if it breaks down? (Sorry, very worried.)

2007-03-13 12:18:18 · 5 answers · asked by Jess1023 1

I drive a ghetto looking car. my right door doesnt open and my left 1 opens only from the inside. i dont care how she looks because she has inner beauty (runs perfect) but i think she deservse a paint job at lease. i want to do it myself at work (security/free time). so can anyone give me a step-by-step detail how to do it for cheap. where do i buy the martials? exc.

2007-03-13 12:07:25 · 5 answers · asked by dfksone 2

2007-03-13 12:05:01 · 5 answers · asked by CuteewitaBootie 2

I have a 2003 Pontiac Grand Am with a 2.2L 4-cylinder engine. I don't care if I have to take things off (emission controls) I have a base knowledge of cars, so if you say I should increase/decrease the idle etc. I can do that. Thanks!!!

2007-03-13 11:57:22 · 5 answers · asked by Anonymous