Maintenance & Repairs - August 2006

It is a 1993-1995 Dodge Intrepid.

2006-08-08 15:27:36 · 5 answers · asked by Chris S 1

I have VW Beetle 1969. Req minor repairs and maintenance service. Unsure where to go for repairs. Hoping to find reliable, responsible mechanics in Singapore and/or Malaysia.

2006-08-08 15:26:47 · 1 answers · asked by Mel 1

And what's the life time of AEM Intake

2006-08-08 15:14:08 · 1 answers · asked by Sailor 2

2006-08-08 15:10:05 · 5 answers · asked by myfyn69 2

If the timing belt breaks, will that event destroy the engine? I don't know for sure what type of engine I have, but I know some engines if the timing belt breaks the engine will not be destroyed, but I know in some engines the breaking of the timing belt wrecks the engine (example: 1980's models of the Ford Escort).

2006-08-08 15:08:39 · 3 answers · asked by blue nickel 2

auto repair estimates

2006-08-08 15:06:46 · 5 answers · asked by stress 1

in my chevy cavalier i have everything but my reverse .. is the trans. total done or could it be something in the trans.

2006-08-08 15:01:08 · 7 answers · asked by c@c 1

Does the lack of engine oil add the increase in revs ????
my car engine needle temperature is showing normal ....
but the engine is damn hot...

i'm a little worried ?

any ideas ??

2006-08-08 14:59:31 · 8 answers · asked by megadisc 4

2006-08-08 14:57:59 · 6 answers · asked by josh a 1

do i need to take the door off, do i need a special tool.

2006-08-08 14:38:34 · 3 answers · asked by reds141414 2

Three inch vertical gash from a fender bender.

2006-08-08 14:35:08 · 11 answers · asked by terrill b 1

I work in an automotive center and people have the dumbest questions and if they would look in their manual they wouldn't have to ask the dumb question!
Is it just easier to have someone else read it for you or do they just not understand the manual because things are so much more complicated now days?

2006-08-08 14:32:39 · 5 answers · asked by Anonymous

i have a 1995 Mercury Sable station wagon. the airbag light on the dashboard panel keeps blinking in a 1-3 pattern. is this a code that means something is wrong?

2006-08-08 14:31:09 · 30 answers · asked by momof9 2

I have a 2001 ford mustang gt My car turned off yesterday and when I turned it back on it said check engine. AutoZone told me it was the crankshaft positioning sensor (they used the device they have to check the code ) and I changed it but after a while the light came back on and the sensor got messed up again. What could the problem be? What causes a crankshaft sensor to go bad?

2006-08-08 14:28:23 · 4 answers · asked by need help 2

2006-08-08 14:21:18 · 1 answers · asked by melissa j 1

2006-08-08 14:20:34 · 6 answers · asked by drlfouse 1

bought a 1994 olds and it has to run for about 10 minutes before it will shift into gear. It seems to run fine after that. Haven't driven it much, want to check everything out first. It had only been used a few times in the past year. Any suggestions would be appreciated.

2006-08-08 14:17:53 · 5 answers · asked by MaryFran 2

2006-08-08 14:06:59 · 3 answers · asked by mikey 1

got a 2000 caddy deville new struts front end tight problem im having is ,when going down the road holding steerring wheel car drift to the right but wheel still straightin car . do you think the car has been hit or the gear box is off?

2006-08-08 14:06:04 · 7 answers · asked by k_jeffrey@sbcglobal.net 1

It seems as if I have to get a completely new engine after doing some hydrolock damage to my car... does anybody know where I could get a 2005 Mazda3 SP23 (2.3L) long block, and how much it would cost me, fully installed?

Thanks a ton!

2006-08-08 14:05:17 · 1 answers · asked by Benni 1

I have had oil changes and showed proof to the MFG but they still state it was not taken care of. (yes they are recent) I have taken it to a mechanic and they quoted $650.00 for repairs of a bad piston I just do not want to get taken for a ride. Young and Female and unfortunately
not knowledgeable on car repairs. It cranks over but has a bad knocking noise while running losses power right away. Well I hope I can at least get some info if this is worth the time and $$$. Thanks for reading and thanks if you answer!!!

2006-08-08 14:04:39 · 7 answers · asked by Patty R 1

they said the car was running after the wreck but not real sure if it was

2006-08-08 14:03:53 · 2 answers · asked by Patty S 1

they said the car was running after the wreck but not real sure if it was

2006-08-08 14:03:00 · 10 answers · asked by Patty S 1

2006-08-08 13:45:00 · 4 answers · asked by pat n 1

2006-08-08 13:40:20 · 6 answers · asked by Shorty 2

which is the best off road or just overall

2006-08-08 13:33:52 · 5 answers · asked by Anonymous

2006-08-08 13:29:18 · 7 answers · asked by Nathaniel S 1

I have a '95 Ford Ranger with 255 70R14 tires on 14 inch wheels. Just looks a little puney. Can I put 15 inch wheels with taller tires on it? Has anyone done it? What is the bolt pattern for this truck? Got any other ideas? I don't want a swamp truck, just want to make it a little beefy looking without going overboard. Thanks!!

2006-08-08 13:27:26 · 5 answers · asked by cuttinggrass4u 2

My 1998 plymouth breeze needed rear brakes again after 2 months. I had a break line leak the 1st time. This time they said my hoses were bad.

2006-08-08 13:17:53 · 6 answers · asked by maggie_sue32 1

from front tire gets loud when i going slower and really hear when going fast

2006-08-08 13:16:10 · 7 answers · asked by Anonymous