I am not sure where i've went wrong... I've bought a lovely new 300gb hard drive, and went to install it into my system, replacing my older 80 gb hard drive. On opening the system, however, I discovered that the hard drive already in the pc was connected with a narrow flat cable, unlike the normal wide flat ones i've seen.... (I didnt install this, a local pc shop did) Is this IDE? Anyway... I have used Norton Ghost to clone my old smaller hard drive to my new larger hard drive, and all seemed well until i removed the older hard drive, set the new one to "master" (by moving the jumper, is this correct and complete?) and tried to boot up... it wouldnt boot and wanted a cd to boot from....
This is my second attempt at this, the first time worked fine on my friends pc, but this one is not playing ball at all... Is it because of the IDE? How can I rectify this, please?
Many thanks in advance, I know many of you are far more intelligent than me...lol xxx
2006-12-10
22:03:14
·
3 answers
·
asked by
iamqueentracy
3