Maintenance & Repairs - January 2007

I was able to get the c-clips off the 3/4" shaft (my winch fairlead rollers) with my c-clip pliers, but they won't go back on. I've done lots of these doing printer repairs and brakes, but this size won't go back on. It's just too tight. I suspect it is grade-8 and it slips off the plyers before I can open it enough to put it back on. Any tips for doing this or should I chuck the darn shafts in the lathe: center-drill and tap, then just bolt a washer over one end.

thanks
James B

2007-01-11 07:41:14 · 3 answers · asked by James B 3

Does anything really BAD happen? Could the car blow up?

2007-01-11 07:40:43 · 9 answers · asked by Anonymous

Misfire on 5th Valve 2001Cougar V6 DOHC

My check engine light is on and the vehicle & is misfiring on the 5th valve. I had my brother hook my car up to the computer and the code it was throwing was a misfire on valve 5. I have a 2001 mercury Cougar V6 Sport DOHC with 63400 miles on the car. I have always completed the scheduled maintenance on the car. I will be replacing the Spark plugs and wires with OEM parts. I use good gas 89 Octane Chevron, I also use redline fuel injector cleaner. I did pull the spark plug out and it looks like it was running lean. I had cleaned the plug and put it back in the car. We rest the computer and the check engine came back on again after 50 miles. The wires look ok but not to sure how to tell indefinitely with the wires besides replacing them. I need more direction with this if it isn’t plugs and wires. I was told it could be the coil pack also. This is not covered by warranty. Any Help would be appreciated. The system is a DST system not cap and roo

2007-01-11 07:37:39 · 3 answers · asked by rhiannonnightqueen 2

2007-01-11 07:37:16 · 7 answers · asked by justin p 1

Okay so about a week ago i was driving on a hill and the "check engine" light on my 2000 Celica went on. As i accelerated it wouldnt respond like it usually does, its as if it was stuck on 50mph, and the rpms highly accelerated by themselves.

I kept driving the car, as i wanted to get home. I didn't get a chance to go get it checked out, so i left it like that. Two days later i used it again and the light went off. But i still feel that theres something wrong with the car. Like when i turn the car on while on parking the RPMs are at 3000, and later it goes down to 1000 after i put it on R or D.

Also, when i'm getting on the highway and i accelerate to get to 60mph it takes a while to get there, its as if it gets stuck.

Any ideas on what the problem could be?

2007-01-11 07:33:11 · 4 answers · asked by Jan85 1

My truck seems to have problems with its RPM`s
I start the truck and it will sputter around 200 rpm then reach 1000
I then drive the truck with no problems, let off the gas and it will immediatly drop down to 200 or 0 rpm the lights will dim and pop back up to 1000 or 750. It will also stall if idling for more than a minute or so.

Then next day I use the truck no problems 750 to 1000 during use.
The Day after 200 RPM -0 RPM problems again.

Im stumpped I thought it was the battery, the alternator, vaccuum leak .......I hope the engine isnt going to crap out its only got 47000 miles and is in mint condition

If anyone has any guess feel free to share

2007-01-11 07:27:06 · 3 answers · asked by Anonymous

The radio, clock, light on the top, remote are not working for my car, the dealer told me the wiring harness got broken.They can order one for $180, replace it for $180
question: 1: where to buy cheaper part
2: any guidance to replace it?
thank you

2007-01-11 07:26:17 · 2 answers · asked by PeterXu 1

on GM vehicals that come out with dexcool coolant from factory, can they be converted to ethyleen glycol anti freeze without problems ?

2007-01-11 07:23:14 · 4 answers · asked by Everett A 1

I have a 2001 Ford Taurus. I just went to leave and take it to the shop to get new tires and an oil change and when I tried to start it, it rolled over and the radio came on like it was going to start and as soon as I stopped pushing the key forward it died but the radio stayed on. Does anybody know why? Could this be a battery problem or possibly the oil? I am past due for an oil change which is why I was taking it there now. Any help?

2007-01-11 07:22:09 · 9 answers · asked by bmontgomery1104 1

I've had it checked--no leaks--not burning oil--what gives?

2007-01-11 07:21:07 · 2 answers · asked by LolaCorolla 7

As I found Transmission oil leaking on my driveway, I went to mechanic.
First time he thought it is gasket so he changed Pan gasket, applied silicone but it still leaked.
Second time he changed all lines (3 pipes) between Radiator and Transmission but still Transmission oil is leaking. Anybody can guide what could be the reason for oil leak?
~Ash

2007-01-11 07:16:55 · 3 answers · asked by asit3 1

The bearings on the front wheels of my Fiat Punto need changing and the local garage is backed up for weeks (they've had my Ducato motor home since November). Can anyone talk me (well hubby really) through how to do it?

2007-01-11 07:13:10 · 7 answers · asked by Anonymous

2007-01-11 07:07:24 · 8 answers · asked by Cynthia 1

Ford focus, 2002

2007-01-11 06:39:20 · 11 answers · asked by beerfiend29 1

I spray starter fuel in the air intake it will start but die out after a few seconds

2007-01-11 06:34:54 · 8 answers · asked by Ric D 1

i dont know what to do as there are loads of other vehicles around the car also. I have called police as im concerned it may blow up or something.
Just need someone to tell me if it would blow up or anything..

thank u

2007-01-11 06:33:03 · 15 answers · asked by Anonymous

I would like to know if the adjustment washer that comes with the pickup from factory works for some adjustments or i need to replace with other one with new size o calibration, also, i need the adjustment procedure

2007-01-11 06:07:59 · 7 answers · asked by munozv 1

My brother in law parked this car 3 years ago running, and now it won't start. Does nothing but whine when you turn it over. We have replaced the fuel filter, plugs, wires, fuel injectors...basically put over 300 bucks in this thing, any ideas?

2007-01-11 05:26:52 · 6 answers · asked by jstar104 2

2007-01-11 05:15:20 · 4 answers · asked by carlosfearn 1

My Civic has a cylinder that is not working so I am only driving on three. Is this safe to do or should I get it fixed?

2007-01-11 05:10:33 · 18 answers · asked by Anonymous

2007-01-11 05:05:12 · 5 answers · asked by brian m 1

I have a 94 Toyota Celica. Recently, I cannot depress the brake pedal when the car is in park and the ignition is off (only sometimes). As soon as I start the ignition, the brake pedal depresses and everything is fine. The, the other day, I noticed that if I brake hard, the BRAKE dashboard light comes on. I've never noticed this before, but I may just be more sensitive to it. (I do NOT have anti-lock brakes, and I do believe that this light is supposed to come on if the brakes are in danger of locking.)

Any thoughts on what might be wrong and how quickly I should get it to the mechanic.

Otherwise the car is in good shape. It's 120,000 miles and has passed inspection, etc.

2007-01-11 04:59:27 · 5 answers · asked by Amalthea 3

2007-01-11 04:51:50 · 9 answers · asked by pooey 1

and we have noticed that when we take the foot off the brake pedal the car does not''pull'' forward, as do all other automatics, infact we have to press quite hard on the gas pedal for the car to begin moving,...once the car is driving though there seems to be no problems with the changing of gears,..only when pulling off from a stopped position.
does anyone know what may seem to be the problem, or can offer any advice ?
thanks

2007-01-11 04:34:11 · 4 answers · asked by cassey s 3

2007-01-11 03:49:30 · 10 answers · asked by Anonymous

I know it's up to me.. I have a new car, dark blue, and dirt and dust accumulate quick, especially after parking out at nights with the houston humidity and condensation, even in 'winter'! Every several other days there's a 30-70% chance of rain, so annoying! In some ways I feel it's not worth my $13, but it's not good to let all that dirt sit on top of paint anyway, right? Thx in advance and please don't suggest coin wash, they're dangerous around here.

2007-01-11 03:43:17 · 23 answers · asked by Ms. Curious 2

my 1997 Vauxhall Vectra has engine ECU light on during driving. I had diagnose from specialist dealer and he told it said fault code 02 and need to replace sensor and even possibly change whole ECU box. What was the problem of my car?
How much it will be chaning ECU box?

2007-01-11 03:33:53 · 7 answers · asked by Anonymous

I have a Chevy Express Van 2001 with Vortec V8 5.7 . and i need this part . where I can get it . Thanks

2007-01-11 03:24:45 · 2 answers · asked by Anonymous

My 2005 Elantra which used to give 28mpg now gives only 15-16 mpg in the city and abt 25mpg on the hwy. It has abt 32,000miles on it. Will a regular tune-up take care of this or is it a bigger trouble? Should I use premium fuel?

2007-01-11 03:17:21 · 2 answers · asked by am I nuts? 1

piston stuck in cylinder,,if you can help i can give you direct contact ,,i am flying cuba 24th jan ,,this is why im trying help,,do all have sleeved cylinders,how can tell if standard bearings ,where can i find relevant info,,needs exhaust elbow?can piston come uphill,im not there just trying sort,more on reply

2007-01-11 03:17:06 · 2 answers · asked by millsym2k 3