Maintenance & Repairs - October 2006

2006-10-09 01:46:54 · 8 answers · asked by roberta r 1

IF YOU KNOW OF ANY SITE THAT WILL HAVE PARTS FOR THIS YEAR AND MODEL, PLEASE LET ME KNOW...THANX

2006-10-09 01:42:35 · 10 answers · asked by David Y 1

2006-10-09 01:41:38 · 8 answers · asked by sharon 2

I believe the spots are tar from the road, but I don't know for sure. The spots are raised and if I scrape one off with my fingernail there's a little brown spot left behind. I have to rub the left over brown spot really hard for a long time to get it to fully go away. At this rate, it'll take me hours to get them all off. Any suggestions?

2006-10-09 01:41:10 · 6 answers · asked by ☆skyblue 7

I have a 1996 Saturn SC with 136,000 miles that burns about a quart of oil every 400 - 500 miles. I use the car to deliver newspapers in and I drive approx 700 miles a week. When I got my oil changed last time the tech. recommended a synthetic oil and said that it should help slow down the burn. IT DIDN'T!. What is the best grade to go with in my situation?

2006-10-09 01:38:37 · 9 answers · asked by Anonymous

How is it applied

2006-10-09 01:36:39 · 4 answers · asked by Anonymous

2006-10-09 01:36:03 · 3 answers · asked by tamarak40a 2

I just rebuilt my LT1 - how many miles/hours should it have before break in is through? Any specific techniques or limitations (what should I set me RPM cap at)?

2006-10-09 01:28:01 · 1 answers · asked by jeff_is_sexy 4

I have a Nissan Micra which has a welded sill.

We had a mouse, (long gone), who kindly packed the sill with peanuts. These are now rotting. We have managed to scrape out most of it, as it is now a thick sticking sludge which is attracting flies.

Does anyone have an idea how to remove the sludge, without cutting open the sills. There is an electrical cable, so I am loathed to use boiling water or steam, unless you know otherwise. We can get access to the sill via a hole slightly larger than the diameter of a hose pipe, by which we have used rags on wires to get the worst out, and have used to funnel to flush the sill in warm water which drains out of the drainage holes, but this doesn't really touch it.

Any ideas

2006-10-09 01:22:28 · 11 answers · asked by Marian 1

i.e. against rust etc;

2006-10-09 01:16:04 · 5 answers · asked by lisaandmax 2

2006-10-09 01:09:53 · 4 answers · asked by Pulsared!! 1

you say its the thermostat, if so would this allow the temp gauge to sit nice at half way and not show signs of overheating? also when it shows its up to temperature on the gauge the cooling fan kicks in!! with a faulty thermostat would this happen??

2006-10-09 01:05:35 · 4 answers · asked by Anonymous

2006-10-09 00:56:11 · 1 answers · asked by Anonymous

i use the normal off the shelf cleaning sprays and paper towels

2006-10-09 00:50:30 · 3 answers · asked by VALENTINO 1

2006-10-09 00:02:50 · 2 answers · asked by Anonymous

I have a 1993 jeep grand cherokee. i have been all over the bottom side of it looking for the drain. all the water is in the passenger side floor. is the drain behind the heat shield?

2006-10-08 23:49:37 · 2 answers · asked by Anonymous

ford mondeo 1.8 1997 makes a noise when steered to the left but not the right

2006-10-08 22:46:32 · 16 answers · asked by g1a2r3yy 1

2006-10-08 22:09:14 · 13 answers · asked by madeirasunboy 1

When i try to start my galant in the morning it has a hard start,i cant drive it immediatel.I must leave the engine running for some minutes before i can drive it otherwise it keeps going off.Finally after i drive it is sluggish.It keps showing the engine light which goes on and off as i drive.I have had to change a relay/fuse several times. Whenever the relay/fuse is burnt the engine is very sluggish.the odometer and speedometer do not run.please help

2006-10-08 21:02:35 · 3 answers · asked by Bobsinclair 2

I'm going to buy a ford Taurus 97 GL with 90 k miles on it but seems to me that the ex owner hasn't change the timing belt for this car. some people beleive it has to be changed at 60 k miles some other at 100, 000 some people say it has timing chain which doesn't need to be replaced at all. what do u know about it

2006-10-08 21:00:37 · 6 answers · asked by moral910 2

Out of gas,won't start,reset switch

2006-10-08 20:47:06 · 3 answers · asked by Anonymous

I'm replacing the headlight switch, for that there's a release button and the knob and shaft pull free. to access the nut to remove the switch you have to remove the finish panel. To remove the finish panel, you have to get the windshield wiper knob out of the way. There's a slot on the knob where a little alan screw might be lying behind, but I can see no little screw and I was so furious after an hour of trying to get the thing off, I actually tried to just bust it off or force it off and the f@#$%er wouldn't even break off. I'm sure it's very simple. please help. thanks.

2006-10-08 20:30:12 · 7 answers · asked by jemrx2 4

A friend of mine has a 1953 Oldmobile 98 Holiday. some one stole the flywheel while his motor was out at the shop being restored. and i am having a hard time finding one to replace it.can anyone out there help me.

2006-10-08 20:17:40 · 7 answers · asked by sfvftherwood 1

TATA Indica V2 Xeta Delears offer More discounts & gifts for Corporate Buyers Then for Individual Buyers

This is not the Case with TATA it is the same with Maruti / Hundai Etc.. Why do thay Differenciate between Coorporate & Individual Buyers are we not giveing the same money as Coorporate buyers I recently Zeroed in on Tata Indica V2 Xeta GLS Model & enquired with the dealers the

Individual buyer gets
1) One year Free Insurence
2) Basic Fittings Like Mud Flap / Dicky Mat

Bit the coorporate buyer Gets
1) One Year Insurence
2) Basic Fittings Like Mud Flap / Dicky Mat Etc..
3) Remot Central Lock
4) Mp3 Player
5) Other Discounts

Why does TATA Motors discriminate between Coorporate & Individuals buyers Either give the Same offer to every buyer or don't give any offer at all to any body

2006-10-08 20:15:03 · 2 answers · asked by Sunder P 1

i have a misfire in my 89 toyota supra. i didn't list all the stats last time and i had several answers which didn't seem quite right. its a 7m-ge engine, non turbo, 3.0 liter inline 6. i believe one cylinder is misfiring and i know which one it is. i just want to know what might have caused this, what should be done to fix it, and how much that will cost. thanks

2006-10-08 19:43:00 · 4 answers · asked by b4dmuthafuka 2

I thought it was the rotors but the pedal does not shake at all. Can it be the tie rods or anything else??????????

2006-10-08 19:23:15 · 7 answers · asked by Hozb718 2

took the engen out and now it is time to put it back in but the engen wont fit with the trany thay stuck about 1/8 in apart what do i have to do to get it to fit
it is an outomatic and same parts that came out of the car

i know i spell bad

2006-10-08 19:15:21 · 3 answers · asked by Anonymous

i have an 89 toyota supra non turbo wit a 7m-ge engine. the engine has a misfire on 1 cylinder but im not sure what caused it, how to fix it, or how much that'll cost. the check engine light does come on when it misfires. any info on this would be greatly appreciated. thanks

2006-10-08 19:05:16 · 3 answers · asked by b4dmuthafuka 2

I have a Toyota Corolla with 105K miles. It started one month ago in the morning: Once in a while the car would not start on first turn. Last week it started happening more often. lights are on and there is a faint click from the front.
Starter? Alternator or something else?

2006-10-08 18:44:00 · 19 answers · asked by Anonymous

My car has a cracked windshield (a stone hit it), it does not effect my driving in any sense. It's just estechically unpleasing. I have to get my car inspected this month. Do you think it will pass? Does anyone know about how much it should cost to replace?

2006-10-08 18:36:21 · 7 answers · asked by viennagirl 2