Maintenance & Repairs - October 2006

does any one know the torq specs on the rod bearings for a 1998 dodge intrepid 2.7?

2006-10-14 09:50:56 · 2 answers · asked by snakey21_1999 2

I mess up the radiator treats where the oil lines goes and I was planing to buy and oil cooler since its more cheaper than replacinng the radiator and lines.

2006-10-14 09:13:35 · 4 answers · asked by Fer562 1

.... the approximate cost of having both front to rear brake pipes replaced?
I have a Hyundia Accent, just had it serviced today and was told it would need doing. Thought what they quoted seemed a bit excessive but don't really know what i should expect to pay.

2006-10-14 09:06:08 · 6 answers · asked by L D 5

I have a Bonneville that starts and then almost dies. After that it will usually kick back up and run fine. It has faded and almost died at an intersection. I replaced the fuel filter, but not both of them. Any help, before I start putting money in it

2006-10-14 08:13:47 · 5 answers · asked by wadew77 1

BMW 525 1 ... K reg ... 1993 model ...

2006-10-14 08:02:57 · 2 answers · asked by Anonymous

It has been like 5500 miles since my last one. They say 3000 but is that really necessary?

2006-10-14 08:00:31 · 16 answers · asked by Anonymous

My mechanic says i need to replace the wiper control unit which is installed in the dash board.
Any ideas where to get this part?

2006-10-14 07:59:17 · 2 answers · asked by avihaiburstin 1

1988 Camaro RS 2.8 litre multi port injection. Replaced fuel pump. Car runs and drives but I smell stong odor of gas from engine compartment. Also car tries to die and has died when I come to a stop. Didn't have this problem prior to replacement of pump. Any ideas?

2006-10-14 07:46:37 · 2 answers · asked by justmeamore 1

i have a 2004 honda civic dx vp thats auto matic. i plan on adding a turbo and i think a turbo automatic would be faster than a stick is it true. is there any sites that compares them or say the pros and cons of each.i wanna know because i like my auto but all the people i know preffer sticks.why?

2006-10-14 07:36:11 · 10 answers · asked by Integra_Type-R 2

2006-10-14 07:29:17 · 22 answers · asked by rookie 1

hi, i want to know how many miles should you wait before replacing the hoses on your vehicle and what hoses are the most important ones that should be changed?? thanks.

2006-10-14 07:14:18 · 5 answers · asked by NJ82 2

1963 chevy does it look different?

2006-10-14 06:54:34 · 2 answers · asked by whynot 4

the car is an 83 camaro with a msd ignition and vacume advance on the distributor should i run the advance or no and what should the timing be at if i set it at 8deg then hook up the advance my mark goes almost strait up on the engine

2006-10-14 06:52:13 · 2 answers · asked by rick e 1

My car's camber is becoming more and more negative. It is noticably causing the tires to wear on the inside edge more than the outside edge. I have heard that most front wheel drive cars do not have adjustable camber, I just want to know if my car is any different. If not, hopefully replacing the wheel bearings (which need replaced anyway) will fix my camber issues. Thanks for your help!

2006-10-14 06:29:02 · 7 answers · asked by bigmac85987 2

my dealer could not pin point the problem. he said it shouldn't be a problem...what a joke. any answers to what it might be?

2006-10-14 06:16:27 · 5 answers · asked by bgreve1 2

2006-10-14 05:47:36 · 12 answers · asked by shadowsug 1

2006-10-14 05:42:46 · 4 answers · asked by Anonymous

My grandad has just locked his keys in the back of his L-reg mondeo estate, is ther an easy way to get in without causing damage?

2006-10-14 05:42:02 · 12 answers · asked by stewart p 1

2006-10-14 05:26:59 · 12 answers · asked by Beckey H 1

2006-10-14 05:26:21 · 7 answers · asked by luke 1

what is the best way to remove all the rust?

2006-10-14 05:19:30 · 4 answers · asked by Anonymous

2006-10-14 05:15:40 · 6 answers · asked by Daniel P 1

changed it but still get a check light.

2006-10-14 05:12:04 · 4 answers · asked by Sherlie G 1

I have a cracked winshield that has spread nearly across the entire windshield. Since it is not in my line of sight, it does not impact my ability to see and drive safely. It is an older car so I don't want to replace it if I don't need to.

2006-10-14 05:02:57 · 6 answers · asked by Andy 1

2006-10-14 05:02:53 · 2 answers · asked by Richard C 1

2006-10-14 05:00:51 · 9 answers · asked by Lisa L 1

where is my sending unit?

2006-10-14 04:53:02 · 4 answers · asked by Tom H 2

2006-10-14 04:41:07 · 16 answers · asked by Anonymous

i need a driveshaft for a chevy s10 1996 truck

2006-10-14 04:32:21 · 2 answers · asked by bassetluv 4

2006-10-14 04:11:14 · 11 answers · asked by jkins 1