Cars & Transportation - 25 June 2007

And are there any special tools or anything I need to know? Please answer only if you know.

2007-06-25 11:21:59 · 1 answers · asked by AK NRG 1 in Motorcycles

2007-06-25 11:20:38 · 5 answers · asked by Bryan R 1 in Ford

2007-06-25 10:54:52 · 10 answers · asked by The Champ 1 in Ford

I never heard of one not requiring it, but the manual doesn't say so-- It does call for repalacement of an "engine accessory drive belt" at 120K. Is that the same thing?

2007-06-25 10:50:31 · 3 answers · asked by wme1221 1 in Chevrolet

I would like to view the TSB (Technical Service Bulletin) #97111598008A for the 1995 Nissan Maxima power seat lift adjustment. I cannot find this document. (NHTSA ID #54277)

2007-06-25 10:47:42 · 6 answers · asked by Dan C 3 in Nissan

2007-06-25 10:38:14 · 10 answers · asked by Anonymous in Rail

2007-06-25 10:36:36 · 23 answers · asked by Maria 2 in Other - Cars & Transportation

Please I really need to know!!

2007-06-25 10:33:44 · 20 answers · asked by *Star Child* 2 in Other - Cars & Transportation

The coil on a Honda CR 80h has a primary spec of about 0.4 to 0.6 ohms, the secondary circuit should be 10.6 to about
15.4 k ohms. My primary resistance checks out, but the secondary, plug lead to negative lead on coil, reads only 4 k ohms. Not the required 10.6 minimum. So my question is, this clearly shows a malfunction, but what is it actually wrong with the circuit, it can't be a broken wire inside or i would have no reading at all, if the needle was to shoot up or down, to the 0 and beyond indicates closed circuit of course. I know that, but at a lesser reading, the 4 in this case I take it that there is a continuation although with less resistance to pass the current, (or it volts? ) through the circuit, than the expected higher resistance of 10 .6 +.
so what conditions would indicate the lesser reading, damage? deterioration?
any ideas?

2007-06-25 10:20:50 · 5 answers · asked by Anonymous in Maintenance & Repairs

Recently my mechanic changed out my air intake control valve because my rpms were fluctuating between 400 and 1300 during idle and causing me to stall out because it was running so low. So everything was fine for a couple days but after about a week, the rpms are still fluctuating enough to jerk my truck while I'm in idle but its not stalling it. He told me that I should bring it in so he can reset the computer and that i need to drive 20 minutes in stop and go traffic plus 20 minutes on the highway to train it to my type of driving habits and than wait for the engine to cool and do it once more. Does this sound credible? I am going to end up trying it anyways but I just want some other peoples inquires of my situation.

I drive a 2003 dodge ram 1500 quadcab.

2007-06-25 10:17:18 · 2 answers · asked by scottyknows101 2 in Dodge

I'm looking for a relatively inexepensive amp that will cleanly power my stock speakers. I'm pulling my stock radio and putting in a car pc in it's place, so it will be a line out from the pc's audio card to the amp to drive the speakers. I'm thinking around 40W RMS x 4 is plenty for me. Is there anything good for under $100? I don't want a bunch of crap and hissing noise but I'm not looking at getting a thumping system either. Just clean.

2007-06-25 10:14:12 · 3 answers · asked by Dan A 2 in Car Audio

i need road layout to include traffic lights road markings etc

2007-06-25 10:09:31 · 9 answers · asked by gwyneth t 1 in Insurance & Registration

2007-06-25 10:07:56 · 1 answers · asked by Anonymous in Boats & Boating

How can I get the TN DMV handbook translated from English to Farsi (preferably for free)? I'm trying to help a neighbor! She cannot pass the written exam due to the language barrier.

2007-06-25 10:07:19 · 3 answers · asked by Anonymous in Insurance & Registration

it starts about 30mph.

2007-06-25 10:03:08 · 6 answers · asked by Hermesha M 1 in Maintenance & Repairs

2007-06-25 10:02:15 · 3 answers · asked by sk 1 in Maintenance & Repairs

When making some Tea, how much milk are you supposed to add? Also is it the same if you use whole milk, non-fat milk, or skim milk?

2007-06-25 09:57:42 · 13 answers · asked by AviTech 3 in Safety

too many air filters of different prices to choose from. i dont know if i need to change my air filters i just want to, i was told it helps for more clean power, because thats what im looking for

2007-06-25 09:56:17 · 3 answers · asked by Anonymous in Motorcycles

i have a 99 ford explorer xls with 75 thousand miles on it {but still really good condition} .... i timed myself last night and it took like a little over 5 seconds to get to 60 MPH....IDK but to me if felt like a long time...what is the standard time for an explorer? is 5+ sec good or no??

thanks, katie♥

2007-06-25 09:56:03 · 7 answers · asked by ♥femme fatale♥ 2 in Ford

Is it possible to operate a house boat in the great lakes or is the water to rough for this type of boat?

2007-06-25 09:55:59 · 3 answers · asked by Anonymous in Boats & Boating

man on bike is going fast on a residentioal road and a car is turning to go out of his driveway and accidently hits him hard with his bumper he doesnt have a insurance and the biker doesnt have a licence to drive a bike does each other fix their own car or what do you think they should have done any good suggestions are taken well

2007-06-25 09:51:47 · 26 answers · asked by Anonymous in Safety

I got a small scratch on my new black 760 sedan, anything i can do without taking it to a paint shop?

2007-06-25 09:50:57 · 5 answers · asked by ghafoors2005 1 in BMW

Here is my problem. I recently had to get another vehicle, for work. Due to past credit problems, charge-offs, and repos I had to go this route. Keeping my job was important to me, so at the time I had no choice. Now my eyes are open to what a ripp-off this is. Completed my downpayment of $800 although I told them I only had $300 to put down, which they accepted. My payments are $169.77 twice a month, for a 2000 Saturn that had 105,000+ miles on it. Will be paying on this car for 3yrs. After finally "really reading" the contract I was all but happy about my choice. How do I get out of this situation legally? Know defaulting will not help my credit situation, but it's already bad. What can I do? Am really in need of some sound advice, cause this is really hurting me financially.

2007-06-25 09:46:22 · 7 answers · asked by g_davis58 2 in Buying & Selling

get a 4 door honda civic that's a stick shift? Should i just get one in automatic? I want a stick shift but i think it would be wierd.

Also would it be weird to put a spoiler on one. Not like a huge one just like a regular small one.

2007-06-25 09:45:00 · 6 answers · asked by Anonymous in Other - Cars & Transportation

How do i get it off so i can replace the speakers

2007-06-25 09:44:29 · 2 answers · asked by Chardonnay 2 in Car Audio

I have a 1996 Buick LeSabre, custom edition. When I start the car the first time, the engine doesn't start. When I start the car the second time, the the engine revs up and the car shakes, makes weird noises (dananana....putt putt putt) but the engine is still running. The "check oil" and the "check engine" light comes on. Then when I go to press down on the brake (which is heavy) and switch gears...the car makes a loud boom noise and the engine shuts off. I have 110,888 miles on the car. I recently got an oil change, a new coil pad, and a new battery. I need help from an expert...I am low on cash. Does anyone know what is wrong with the car?

2007-06-25 09:42:35 · 5 answers · asked by Anonymous in Maintenance & Repairs

I'm travelling far from home, so I don't have access to my NADA Classic/Collector car price guide, nor do I have much access to the web right now to do a thorough search. Looking for the following info:

1) Value for a 1972 Mustang. Its a 4 Speed, the VIN is 52F05Q238254 (the first character might be a J instead of a 5, not sure, there was some dirt on the windshield). The only code I was able to clearly get off the block was 13728548 (off the manifold). It appears to have a 2 Barrel Carb. The hood indicates it has a 351 engine, which looks about right from what I could see looking at the engine itself.

In any case, I'd like a range of value, from its present condition to what it might be worth fully restored.

2007-06-25 09:41:19 · 5 answers · asked by 2007_Shelby_GT500 7 in Ford

well... got 1.8 16v gti 1998 escort in petrol... few hours ago i got splashed by a lorry and the wave (honestly) went over the roof... it died in the middle of a roundabout... i couldn't start it again... opened a boot to find some smoke coming out from under an oil cap and from coolant tank... by now i found the leak in cooling system and disconnected (wires ripped out) water pump... the battery's fine... oil's still ok... it turns but doesn't start... i checked the coil and spark plugs... everything is dry and looks ok... what the hell happenned... and what might be a reason i can't start it now??? cheers for any help...

2007-06-25 09:36:32 · 3 answers · asked by what happenned to ya? 1 in Maintenance & Repairs

I want to increase the brake's stopping power of my 2000 Honda Accord. Even though I have new brake pads from the dealer, it is not as powerful as the brakes of my BMW 325. What can I install to improve its stopping power?

2007-06-25 09:32:22 · 8 answers · asked by bodi 2 in Honda

I have an '03 Ford Focus with a Duratec engine.

2007-06-25 09:26:46 · 7 answers · asked by Bill Spry 4 in Maintenance & Repairs