Maintenance & Repairs - March 2007

I have a ford escort when you hit the brake and clutch it dies you have to restart it i've had it in the shop 3 time and still is not fix anyone has any idea what could be making it do this

2007-03-21 14:03:20 · 3 answers · asked by h2005 1

Can anyone tell me what name to buy for brakes / Rotors for a 2000 Nissan Maxima. I was told to try WAGNER BRAKES, are they any good?? Any help or suggestions will help. Thanks.

2007-03-21 13:53:47 · 3 answers · asked by Anonymous

I wanna know how much Miles or years I have to wait to replace the T-belt of my 2004 chevrolett corsa (a brasil model).

I bought it new and being using it for 3 years and 54,000 kilometers.

Thanks all in advance for your answers

2007-03-21 13:53:47 · 5 answers · asked by Carlos Alberto D 2

What is the best website to purchase parts for a 1990 Chevrolet pick-up?

2007-03-21 13:51:56 · 3 answers · asked by Todd F 1

leaving military service , looking to use my gi bill

2007-03-21 13:45:48 · 4 answers · asked by Anonymous

I have a 2000 firebird (v6) warped rear disc brakes. Also, how important is it to bleed the brakes. On my 90's camaro I never bled them and never had a problem. Please help me out.

2007-03-21 13:43:27 · 11 answers · asked by sedition_4_2_0 2

2007-03-21 13:26:33 · 7 answers · asked by duy n 2

I'm trying to replace the driver's side brake light bulb. I have removed the metal screws but it seems like the lens is still being held by plastic clips. If I pull hard will I break anything? ON my Ford Windstar the lens pops off after two screws are removed and is easy to put back on. I'm afraid I'll break a clip or two and not be able to get it back on after I replace the light bulb. Help!

nolan

2007-03-21 13:20:08 · 4 answers · asked by nolan_christy 1

2007-03-21 13:07:01 · 2 answers · asked by ray p 1

2007-03-21 12:57:54 · 4 answers · asked by Anonymous

My garage is baited also. I've left my car outside with no success. I've tried turpentine balls; Irish Spring soap; Bounce dryer pads. I put those sticky mouse pads on the floor of the car. I caught one, but there are more. I left lifesavers in the car, and they ate them.

I tried all the tips from the exterminator. This is so gross. I am afraid a mouse is going to run under my feet while I am driving.

This is the first winter that this has happened. I am allergic to cats so that won't work.

Please give me some sensible solutions.

Thanks

2007-03-21 12:47:17 · 15 answers · asked by ne11 5

I need a picture of brake system to make repairs

2007-03-21 12:42:46 · 4 answers · asked by Donna S 1

just brought a vauxhale cavalier and got a feeling iv been done big time i dont want any help getting moeny back its my own stupid fault just help fixing the darn thing

drove 80+miles to bring it home yesterday and not a problem went out thismorning and the battery was dead so i jumped it off my works van and it wouldent stay running thought to my self bad battory so fetched another £50 got it back fired the car not a problem drove back to the garadge and asked the guy to do an alternator test and he said all was good i was right it was just the battery came to start it after work on the night and battery was flat again so jumped it again and all was good till i came around the corner at home (dont know weather the corner has any baring on the matter) but the raidion blipped off and on and the battory light came on and now wont go out also have a flat battory again!!! any ideas anyone would much apriiciate car was ment to get me out of trouble while i fix my daily driver :-(

2007-03-21 12:37:53 · 5 answers · asked by Anonymous

2007-03-21 12:37:41 · 4 answers · asked by Anonymous

I have a 1998 Chevy s10 pickup and i noticed the antifreeze was low so we put regular green antifreeze in and when we opened the radiator cap the antifreeze in there was orange. I know that orange is used in gm vehicles but what is the difference and was it bad that i mixed the green coolant with the orange.

2007-03-21 12:30:37 · 11 answers · asked by whit 3

My front bumper on my truck is begining to show signs of rust. What's the best way to remove the current rust spots and keep future rust from occuring. I was thinking of knoking off the current rust with a wire brush and coating it with a thin layer of vaseline but I don't know if that'll work.

2007-03-21 12:24:57 · 7 answers · asked by opp7248 1

The problem is not literally the clutch. It is more along the lines of the slave/master cylinders. Both are almost brand-new. When I let the clutch up just an inch, maybe less, I am already moving. Also, while I am driving I have a very difficult time shifting into the next gear. My slave cylinder doesn't seem to be engaging as much as it should. I have had this problem before, which is why I replaced the cylinders. I have bleed it, and then I completely emptied it and started over by filling it and pumping it full again.

What else should I do?

2007-03-21 12:14:39 · 9 answers · asked by dicanus1 2

I wabt to take the governor off and the day time running lights can you tell me how?

2007-03-21 12:13:22 · 3 answers · asked by Josh H 1

2007-03-21 12:12:38 · 4 answers · asked by farmer boy 1

so far i have changed the cap and rotor, plugs and wires, fuel filter, oil change, new air filter and it still runs horrible. It only has 151,000 miles on it. It is very slow on acceleration and it guzzles gas only about 9 mpg. next im changeing the pcv valve and the oxygen sensor. Any ideas on why its running so bad or other things i could do to it. thanks

2007-03-21 12:11:42 · 4 answers · asked by Nick C 2

Can anything bad happen if I don't install an intercooler with my turbo?

2007-03-21 12:10:21 · 7 answers · asked by Kenny 3

anyone know any step by step instructions on changing a starter on a 91 explorer?

2007-03-21 12:10:08 · 2 answers · asked by Loved_by_the_Best 1

I have a 93 aerostar 3.0 engine and I've gone thru many problems, it just stopped running and will turn over but not start.
I've been bouncing around error codes.
started with 64-IAT indicated 123 C (254 F) I circuit grounded.
replaced sensor retested and got
114-IAT sensor out of range - IAT and
116-Engine Coolant (ECT) sensor out of range - ECT
tracked down a problem with the ignition control module and replaced that, still not starting, retested and got error code
543-Fuel pump monitor circuit shows no power - Power / Fuel Pump Circuits
I can hear the pump running when I turn the key and I am not receiving any other codes other than 543 this code did not come up until replacing everything else
any ideas
Thanks
R

2007-03-21 12:06:29 · 2 answers · asked by stikclik 1

2007-03-21 11:59:50 · 4 answers · asked by Anonymous

new HEI mod pick up coil & ECM coil & wires ok replaced coil to distibuter wires EST wire good no shorts have power to injectors, reference wire good no shorts by pass wire good no shorts injector wire to ECM good no shorts
Have beat head against wall for two weeks help

2007-03-21 11:54:34 · 6 answers · asked by J L 2

I have 2 kids and I want good tires for my car, can anyone tell me what to buy?? I had CONTINETAL TIRES put on back in 2005 and now i need new ones agian, so I would not use that brand ever again.

2007-03-21 11:43:42 · 2 answers · asked by Anonymous

ceramic or metallic?

2007-03-21 11:39:56 · 10 answers · asked by Conqi 5

I just changed my oil about a week ago, changed air filter, and noticed that when I am on the highway, the Oil Pressure is about 70 PSI? Never seen it that high? suggestions on if its bad, and what to do???

2007-03-21 11:37:06 · 3 answers · asked by Russell O 1

my 86' bronco has a striaght six, and i looking to put a bigger engine in it, and I'm wondering a friend of mine has a '75 bronco engine, which is a 302 what im wondering is would that old engine fit and work in my truck, and what type of transmission do i need to buy, do i need to buy a '75 transmission to go with it would it matter....and what things would i need to do differently if i need to at all, in order to install it? or can i install it normally like any other engine.

2007-03-21 11:30:45 · 2 answers · asked by Whitney D 1

2007-03-21 11:30:32 · 5 answers · asked by mapleleafs101364 3