English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Maintenance & Repairs - November 2006

[Selected]: All categories Cars & Transportation Maintenance & Repairs

The clutch on my 92 Toyota 4Runner was replaced 10k miles ago and the pedal is sticking in first sometimes. When it does stick, the amount of travel from the floor until the time it engages is significantly shorter than normal. (Normally, it engages approximately 2.5-3 inches off the floor, when it sticks, the clutch engages in less than an inch of leaving the floor) I am able to pull it from this position from underneath with the side of my shoe and it resumes normal operation afterwards...until it does it again. What could be the problem and a possible solution? Thanks

2006-11-10 01:52:12 · 1 answers · asked by Anonymous

the indicators don't work, what could be the problem?it's a used car i just got.

2006-11-10 01:08:32 · 7 answers · asked by W.M.D 1

I've tried the dimmer switch, but nothing changes. Could a bulb be burned out? If so, how do I replace it?

2006-11-10 00:58:24 · 6 answers · asked by Gail N 1

At the same time the clock lost correct time. This happenned overnight. What could be the cause ? I had a remote start put in a month ago and everything has been fine, so I don't think its related to the installation. Qualified technicians requested and Thanks

2006-11-10 00:47:36 · 2 answers · asked by Anonymous

car engine jack hammer jet engine

2006-11-09 23:37:14 · 8 answers · asked by hozefa b 1

2006-11-09 22:04:37 · 19 answers · asked by American Splendor 5

Whats the best thing to clean my leather interior in my car ??

2006-11-09 21:18:36 · 11 answers · asked by st3vi30 2

2006-11-09 18:42:14 · 6 answers · asked by hitesh m 1

this is a general knowledge question

2006-11-09 17:01:42 · 11 answers · asked by Anonymous

He also says I need to replace my intake manifold gasket because there is a lack of upstream heated oxygen. what is heated oxygen?
Should I pay him the $500 bucks?

2006-11-09 15:31:09 · 14 answers · asked by Anonymous

i clean my windows inside and they always leave streaks.do i need a certain type of window cleaner ?

2006-11-09 15:23:13 · 14 answers · asked by kmsangel24 1

I have already changed the oil, filter, plugs, put in stabil for the gas. It starts up when I spray some gas into the carb, but then dies out right away. I have a good flow of gas to the fuel pump, but I think that may after sitting for a while, something might be stuck in the pump. How do I get it running?

2006-11-09 15:22:46 · 5 answers · asked by Anonymous

Ok, so here is the deal:

-Glowing red catalytic converter
-Rattle/ticking noise
-engine running really rough (sounds like tractor)
-smells to be running EXCESSIVELY rich (smoke out the tailpipes)
-Pending CEL for too high voltage on Bank1 sensor 2 O2 sensor
-Extreme loss of power, engine sounds normal but not accelerating as fast as normal

From what I've read, this is either-

a) bad fuel injector
b) bad coil
c) bad cat

Anything else, and any way to narrow it down?

2006-11-09 15:14:49 · 11 answers · asked by ? 2

Where is the emissions sensor located in a
1998volvo S70 and how hard is it to change
and finally the guesstamated cost of the sensor.

2006-11-09 15:07:40 · 7 answers · asked by RudiA 6

2006-11-09 14:53:50 · 6 answers · asked by whrldpz 7

2006-11-09 14:39:04 · 16 answers · asked by bacchus_blue 1

The headlight go out after 20 minutes, but the radio and clock have not been effected so I did not think it was the alternator.

The headlights may come back on as soon as I hit the brakes. The dash lights are also effected.

Thank you for your time.

2006-11-09 14:29:54 · 10 answers · asked by MR. KLEFFFPOO 2

It is an 90 plymouth van that is otherwise fine...is something worn out? I hardly have the strength to close them up anymore...its getting harder to roll them up/down...will it be hard or expensive to fix?

2006-11-09 14:28:20 · 5 answers · asked by paradox is interesting 2

I have a 75' chevy truck, 3/4 ton. If I took all my steering componets out (and I had everyting I needed to make it 4WD) could I put in the 4WD componets, or would my frame support 4WD?

2006-11-09 13:55:33 · 4 answers · asked by wheels47012 3

the widest rim i found is 14" for a 16.5 rim. but people have 44`s x 19.5 wide tires. whare do they get there rim`s.?

2006-11-09 13:43:00 · 3 answers · asked by Brian T 1

need advice: not asshole comments: car will not turn over, not even click. has all power, engine not locked up, has been diagnosed. I have changed; ignition, ignition switch, ignition coil, starter and I REPEAT HAVE had a diagnostic run! and again its a 1990 pontiac firebird witha a 3.1 and if people dont know what a three one is then dont comment

2006-11-09 13:30:57 · 10 answers · asked by stubby 1

I HAVE A 98VOLVOS70 AND THE CHECK
ENGINE LITE COMES ON. I WAS ON THE
ROAD BUT WAS ABLE TO MAKE IT HOME.
AFTER CHECKING THE CAR OVER ALL RAN
AS USUAL NO UNUSUAL NOISES. I DISCON-
NECTED THE BATTERY THEN RECONN-
ECTED IT AND NOW ALL WORKS NORMAL.
NO CHECK ENGINE LITE WHILE DRIVING.
COULD IT BE I NEED TO CHANGE THE
SPARK PLUGS AS I USE THE CAR VERY
LITTLE ABOUT 3500MILES A YR, AND CAN
I DRIVE THE CAR WITHOUT DAMAGING THE
ENGINE WHEN THE ENGINE LITE DOES
COME ON. TKS

2006-11-09 13:29:16 · 10 answers · asked by RudiA 6

I have a 2001 ford ranger with 4liter automatic with 4 wheel drive- all forward gears work fine/fluid is clean-truck has 50,000 miles on it-dealer repaired transmission twice(1st time at 18000 miles) second time at 36000 miles-no longer under warranty-when you shift to reverse nothing happens accept back up lights come on-just replaced valve body by suggestion of ford (no difference)

2006-11-09 13:18:49 · 7 answers · asked by Peachy2 1

fedest.com, questions and answers