my engine is running hot, it was overhauled just a short while ago,
the water is up, I changed the thermostat, one odd thing is that
the temp. gauage reads normal but when I put on a remote infra red temp. sensor it reads 210 to 220 after going around the block
several times. when I put on the head gaskets I know that the
notation front is up front on the head gaskets. It is about 90 degrees here today but the engine should not run much more than
200 degrees, the engine has never boiled over just shows hot
when I use the hand held temp. reader.
any ideas? bob
2006-08-20
09:05:37
·
5 answers
·
asked by
robert k
1
in
Maintenance & Repairs