Maintenance & Repairs - February 2007

I'm pretty sure I have a blown headgasket, but there is so little room to work on this engine.

Can the head gasket be changed without pulling the engine out of the car.

2007-02-17 11:22:20 · 3 answers · asked by You may be right 7

2007-02-17 11:21:37 · 5 answers · asked by jbrick800 1

1990 Honda Civic automatic(about 86,000 miles): unable to pull the key out of ignition at first try after shifting into park and turning engine off; and, also unable to shift out of park some times. (At same time these two problems arose, the steering wheel stopped clicking into lock position when engine was shut off.)

2007-02-17 11:18:35 · 7 answers · asked by billg 1

i got a new clutch in may of '06. so i think the clutch should be good. it has been attcking act up for some time now,(not going into gears easily, i had to force it to shift), and now it is stuck, when the power is off i can switch gears, but when i turn the car on i can not go into any gears. (it is a Mitsubishi Eclipse) im taking it some where on Monday, i just would like some advice before i go.

pleae and thank you!!

2007-02-17 11:09:44 · 5 answers · asked by cmg52580 1

I am not sure if the sound is normal but if someone could let me know what they think it would be great.

2007-02-17 11:01:49 · 3 answers · asked by Hyundai 97 1

It had backfired from the time that I bought it. The bogging down thing has gotten worse. I know that I need a new gas tank cause I replaced the fuel pump and fuel filter and it got better for a little while. New plugs and rotor. Guess I should of bought a new dist cap also but I was just hoping that the rotor was the problem.

2007-02-17 11:01:48 · 6 answers · asked by tripsnpig 3

Ford Tempo 1993 New Radiator and therm

2007-02-17 11:01:17 · 9 answers · asked by SANDRA S 1

dakota rim is 16x8 ram is 16x7, same bolt patern

2007-02-17 10:52:23 · 2 answers · asked by Anonymous

I START MY TRUCK AND NOTICE TRANNY FLUID GOING ON THE GROUND, I LOOK UNDER THE TRUCK AND NOTICED IT COMMING OUT OF A HOLE ON EACH SIDE OF THE TRANNY IN THE MIDDLE NEAR THE TOP OF IT, DOES ANY ONE KNOW WHAT CAUSES IT.

2007-02-17 10:48:43 · 2 answers · asked by buddy 1

I need to raise a wheel so that I can change it The truck might be laden

2007-02-17 10:35:54 · 6 answers · asked by dadseimaj 4

it is a 1994 buick skylark limited edition, 2.3 quad 4 cylinder motor I only see the bolt toward the top, and 1 in the bracket in back, but after looking at the new one it has a space for 3 bolts,

2007-02-17 10:29:32 · 2 answers · asked by hbettag 2

2007-02-17 10:09:43 · 5 answers · asked by bathcapt57 1

I have lost my key for this car. I know that I can have the car towed to the nearest dealer( 30 miles away) and have a key made & programmed for the car if the code was stored when the car was manufactured. That process would cost more than $100. This car is used as a newspaper route car. I don't really care about the sescurity system--I don't need it. My fondest hope is that the security system can be disabled. Any ideas or suggestions will be appreciated.

2007-02-17 10:04:27 · 3 answers · asked by Bill S 2

1996 mercury villager

2007-02-17 09:43:52 · 8 answers · asked by kate b 1

Im thinking of opening a shop in miami, i would like to know the procedures and if it is profitable

2007-02-17 09:25:58 · 4 answers · asked by Da Chief305 2

gasket has gone,but the car still runs what would happen to the car would it heat seize on me ive got to make a 400 mile round tripp in it next week thanks

2007-02-17 08:59:10 · 17 answers · asked by babasi66 1

The belt squeaks and it is very annouying and I was wondering if someone could tell me how to replace it such as pictures or diagrams. I have no clue where to start but if you could just please tell me how to replace it. (I hate squeaky cars)

2007-02-17 08:48:46 · 3 answers · asked by Anonymous

2007-02-17 08:41:37 · 3 answers · asked by Anonymous

Standard '91 Honda Accord Transmission problem

2007-02-17 08:41:07 · 7 answers · asked by gina la bonita 1

same thing after driving for about 30 to 45 min

2007-02-17 08:06:50 · 8 answers · asked by Charlene63 1

heard of steel seal on the internet it is expensive want too no if it is worth it

2007-02-17 07:58:03 · 3 answers · asked by tyvetblue 1

i have a mitsubishi mirage 96 i need to find the fuel pump to see if its the problem the car isnt getting gas does anyone know where its located

2007-02-17 07:57:42 · 3 answers · asked by Anonymous

Got this car used, swapped motor with current 45,000 mls. I think the guy who put motor in didn't adjust distributor correctly. there's alot of ticking comming from under valve cover, and I'm thinking with a low mileage motor it shouldn't be ticking nearly that bad, I'm wondering where the normal setting on the distributor adjustment slot would be set at when you loosen the nut and slide it back and forth etc. It's all the way to one side as of now, but seems to have a hard, slow engine start. could this be the problem...and if so then where should the nut located on the distributor slot normaly be set on this motor...

2007-02-17 07:57:17 · 1 answers · asked by Anonymous

We just bought the vehicle used from a private seller, and now cannot get ahold of him to ask questions about this problem.

We cannot under any combination of button pushing, lever pulling and shifting get the 4WD to engage. The 4WD indicator light is not going on, either. So, we are assuming it's busted somehow.

I've read several other answers on other models that there might be a vaccuum hose or a fuse or some sort of switch that's broken or malfunctioning.

My question is, can you give me a worst case scenario about the most troublesome thing that could be wrong with the 4WD system, and about how much it would cost to fix it at an average dealer repair?

(We plan on taking it to an Isuzu dealer next week. Also, please don't tell me to just get a new car. That defeats the purpose of the question)

Thanks!!

2007-02-17 07:20:20 · 6 answers · asked by rahedberg 2

I am looking for the tank that holds the Engine coolant for a 1993 Dodge Dakota 5.2, i need to know what it is called. I look up at advance autoparts.com and some other website but I need the name, i looked it up for Engine Coolant Tank and nothing was found, but I do not know what it is called. Any help with be greatly apprechiated. Thank You in advance

2007-02-17 07:04:00 · 11 answers · asked by arce2283 3

i have a 91 s10 blazer, 4.3 v6 and when i put oil in it and start it, oil leaks out around the filter, i replaced the filter and it still does it, any ideas???

2007-02-17 06:38:52 · 4 answers · asked by number1turkeyhunter 1

add with antifreeze?
remove antifreeze first?
how long do i leave it in the motor?
we have a fresh small leak on one head gasket.

2007-02-17 06:34:48 · 6 answers · asked by george b 1

Our gpa recently gave me and my cousins a 1986 buick regal to practice driving in, but the ceiling of the roof is like rotted out.. Should we just take it out? Is there something we can replace it with? thanks for the help!

2007-02-17 06:25:08 · 4 answers · asked by cherrie_990 2

New heater core installed.

2007-02-17 06:21:04 · 6 answers · asked by rich boy 2

2007-02-17 06:19:05 · 2 answers · asked by foru2nv1999 1