Maintenance & Repairs - September 2006

2006-09-08 16:28:08 · 3 answers · asked by fredrico 1

2006-09-08 16:07:24 · 3 answers · asked by martins wrangler ? 1

About how much does it cost to repair a leek in an A/C in a '98 Buick?
How much does it cost to get the A/C charged up?

2006-09-08 15:53:52 · 11 answers · asked by nicole 6

When I push down on the clutch pedal, I am unable to switch gears, it stays on nuetral. Can this be the clutch? Also, I switch gears when the car is off.

2006-09-08 15:47:10 · 8 answers · asked by ravyn_heart 1

And what should i do with it??? How do I make the light go off???

2006-09-08 15:43:19 · 7 answers · asked by slt012 2

When i accelerate it jolts really bad and sometimes i step on the gas and it doesnt accelerate. The Other issue is when i have been running it for a while it begins to putt-putt and then it turns off i think it might have something to do with the oxygen somethine or another but would someone give me something to head in the right direction please...

2006-09-08 15:19:21 · 9 answers · asked by Anonymous

2006-09-08 15:16:12 · 6 answers · asked by outshined_81 1

Last week I had the cover off of the fusebox to replace a 25w fuse for the "power plug" in the van. After replacing that fuse, i noticed the battery warning light "on". This was not before, but after. It actually did completely drain 2 batteries within 2 days, and finally shut down(not within walking distance either, lol) I can recharge batteries, but it appears that the alternator is just not working at all. Haven't had it cked yet, is it a coincidence, or did I accidently short a fuse that affected this? Is there a wire under the hood that i can check before going to expense of replacing alternator???? Any help is appreciated. Thanks!

2006-09-08 15:14:45 · 6 answers · asked by pictureman3120 1

it got hit by a foul ball at a baseball game. the crack is pretty big. goes from the middle bottom of the window to the top right.

2006-09-08 15:09:39 · 15 answers · asked by Mitch 3

2006-09-08 15:04:50 · 2 answers · asked by gerald p 1

The new gasket is paper-like in compostion, it is not metal.
2000 Daewoo Lanos
4cyl 1.6 L

2006-09-08 15:02:52 · 4 answers · asked by Ray B 1

It will turn over but it wont start. It died as I was driving which it's done before about a year ago it did that I had some work done to the pick up unit in the dist. and it has'nt done that since. The oil light came on also????????

2006-09-08 15:01:21 · 4 answers · asked by Monicadoll 1

I try to push the clutch down on my 95 Hyundai Accent, however it takes a lot of force to push it down at times. This just started happening when i placed a new exhaust system and a new oxygen sensor within my car. So, does n e one know how this can be fix, or how this happened??

2006-09-08 15:01:09 · 7 answers · asked by ravyn_heart 1

The car was recently serviced and a new starter was put in. That was 2 days ago and I've driven the car a number of times since then with no problems. Now the engine cranks but the car won't start. I tried spraying starting fluid onto the air cleaner, and when I tried to start it immediately afterwards it felt like it was going to start (although weakly) but I couldn't get the engine to rev and it just konked out. Please help!

thanks

2006-09-08 14:56:13 · 6 answers · asked by brian g 1

SHE CRANKS OVER LIKE A CHAMPION BUT WONT START INTERMITTENLY !!!!!!!!!!!My camshaft sensor in my 1996 subaru imprezza keeps going out .When this happens my car cranks like a Champion but doesnt start (spark plugs , battery wiress, battery , plug wires all good) I replaced it one time but by the time i did the stater which cranked like a champion had too much stress and finaly gave out.

2006-09-08 14:54:06 · 2 answers · asked by bolounit1 2

air conditioning off, from a dead stop it just doesn't have any off- the-line power. is there any thing i can do to gain a little more get up and go? say for around $200 to $300.....

2006-09-08 14:24:20 · 14 answers · asked by shreck 2

OK, I heard that there are sets of 2 wires under the dash, like, 2 green, 2 blue, 2 yellow, and all you have to do is find the 2 wires that have no match up and cross them. is this true?

2006-09-08 14:19:27 · 13 answers · asked by AJ S 1

I have an older truck with a good air conditioning system, that just needs a recharge.

2006-09-08 14:13:56 · 8 answers · asked by Ron R 2

2006-09-08 14:02:52 · 22 answers · asked by Anonymous

I am driving down the road with a flock of geese it seems, it is a 99 wrangler...is this a loose belt or something more....poor jeep it has close to 190,000 miles on it, but she is will loved

2006-09-08 13:56:54 · 7 answers · asked by ticonderoga1186 4

Upon the mechanic driving my car they noticed I had a leaking radiator, and now that needs replaced. Do you think installing any of the above mentioned things caused this? My car has never leaked before and now there is a small puddle on my garage floor. I have a Taurus.

2006-09-08 13:56:39 · 8 answers · asked by Reaper 1

2006-09-08 13:55:10 · 14 answers · asked by rachelle 1

have replaced distrib. cap, coil.............truck rotates but no start.tried shooting throotle body staring fluid, but nada.this is on a chevy 94 350. thanks gentlemen...and ladies if there are any.

2006-09-08 13:55:00 · 2 answers · asked by nickolaus c 2

2006-09-08 13:54:56 · 10 answers · asked by pompasom 1

2006-09-08 13:42:43 · 6 answers · asked by mark b 1

2006-09-08 13:41:27 · 6 answers · asked by Anonymous

I have a 2002 chevy malibu with a bad transmission but i have a new 2003 malibu transmission.

2006-09-08 13:33:35 · 8 answers · asked by Confused 1

I don't know the terminology here so I'll try... I drive a manual 5 speed. Connected to my shifter handle is a rod, that rod is connected to a mechanism that holds it tight (the cable runs inside it) so I can shift. That rod has disconnected from the mechanism, so now when I try to shift into 2nd, 4th or Rev instead of pushing into this mechanism the rod misses its mark and I can't shift. I'm pretty sure the rod is supposed to be attached and I'm only supposed to me boving a piece that slides inside it. What kind of repair am I going to need and how serious is it?

2006-09-08 13:23:16 · 4 answers · asked by kingofmyboxfort 1

2006-09-08 13:22:20 · 11 answers · asked by Anonymous

These were getting popular on diesels a few years ago. Have they made it to cars yet. I would think being able to affect the inner volume of the turbo on the fly might make it build up pressure faster.

2006-09-08 13:21:37 · 3 answers · asked by isx650 2