Maintenance & Repairs - September 2006

i was bumped at a light and my habit of keeping my hand on the auto shifter caused it to go into reverse at approx. 15 to 20 mph..now it wont go into reverse and in park it makes a god awefull noise is there a simple solution for this

2006-09-24 04:02:00 · 6 answers · asked by r b 1

2006-09-24 03:58:30 · 7 answers · asked by a&d 2

After a few hours s10 will start up, run 4 awhile then do it agian. Not sure what it is, computer shows nothing, fuel pump & filter are ok,

2006-09-24 03:55:05 · 7 answers · asked by fljrrl 1

im looking for a civic type- R
engine for my 1989 civic hatchback

2006-09-24 03:46:14 · 1 answers · asked by treyjustice11 3

My quad is getting to much air from the air fitler itr bougs down but when i put my havd over the fitler is works and if i put the cover bach onit doesnt work ??

2006-09-24 03:43:28 · 3 answers · asked by JOEY M 1

when i press the brakes the lights they dont brighten up to show that im pushing the brake but the center one on my back winshield lights up. i checked fuses their good the side ones are lit when i turn on my lights so i dont think its the bulbs turn signal works too HELP? b4 i get a ticket.

2006-09-24 03:39:25 · 7 answers · asked by worm 3

The fuse is good and there is NO master switch or lock out controlling all of the buttons.

2006-09-24 03:36:42 · 11 answers · asked by lds 1

NEED TO FIND THE CORRECT VAC DIAGRAM, SO MY TRUCK CAN BE SMOGGED. ENGINE SIZE 7.4 SINGLE EXHAUST CA. CERTIFICATION MODEL C2500 PICK-UP
VIN TCM24AJ506599 AUTO TRANS

2006-09-24 03:26:17 · 2 answers · asked by GBINJT 1

2006-09-24 03:19:53 · 4 answers · asked by randy h 1

2006-09-24 03:15:32 · 5 answers · asked by sharpshoot15 1

i have a 95 jeep cherokee and the light that help u see where u insert
the car key just stay on all the time and its draining my battery i believe when im not using my car, how do i turn it off ? or fix it

2006-09-24 03:14:46 · 7 answers · asked by xemoyx 1

I'm trying to get around changing out another pump at $200+ when they only seem to get 55,000-60,000 miles out of one. It's that way with my buds 2000 S-10 P/U, too. #1ChevyPartsSupporter, Peej

2006-09-24 03:14:24 · 3 answers · asked by Peej 1

2006-09-24 03:10:22 · 4 answers · asked by rl153 5

Will 10psi do on a fuel injection system?

2006-09-24 02:59:01 · 4 answers · asked by Peej 1

2000 Chevy Blazer- backseat floor always soaking wet after rain even when it has not been driven. When I do drive it (after it has rained) I can hear water rushing from somewhere in the back when I turn a corner. Can't tell where it's coming from or how it got there. Driving me crazy! Backseat floor is always wet, just when it starts to dry we get another rain and it starts all over again. Any suggestions would be very much appreciated.

2006-09-24 02:58:16 · 5 answers · asked by jhoward96 1

2006-09-24 02:47:47 · 12 answers · asked by jason g 1

2006-09-24 02:30:07 · 9 answers · asked by jason g 1

2006-09-24 02:09:14 · 5 answers · asked by Woody963 1

It started leaking a few weeks ago...I crawled under it and could not pin-point the problem. Then last evening I was going to check the fluid level and found the problem...No dipstick...Should I just buy another dipstick & add fluid or do I have to flush it , add new fluid and hope for the best. The fluid was just changed last year.

2006-09-24 01:44:26 · 9 answers · asked by B C 2

Ive been told there is a type of transparent sheet of a thick plastic which can be cut-to-shape and stuck on the bonet, bumber etc. of the car.
This is used to protect the paintwork from stone chippings and scratches.
Does anyone know what this is called?
Supposedly very popular for use on luxury cars like ferraris.....

2006-09-24 01:43:35 · 6 answers · asked by enlightened_1 2

2006-09-24 01:30:04 · 7 answers · asked by Kenny 1

2006-09-24 01:29:43 · 11 answers · asked by Mich 3

2006-09-24 00:51:10 · 4 answers · asked by koltontv 1

the waste gate dose not seem to be stuck is the any way to check the vac pipes as you can not see them

2006-09-24 00:35:56 · 4 answers · asked by Anonymous

especially on the inside of the tire, or is that probably just due to it needing an alignment?

2006-09-24 00:33:16 · 7 answers · asked by Anonymous

3 month old 3,000 km run, Nissan X-TRAIL, gasoline engine.
No such a problem when engine is cold.

2006-09-24 00:05:46 · 5 answers · asked by engineer 1

I was told that it was like a transaxle sensor but I wanted to get some more feedback. Thank you

2006-09-24 00:01:57 · 1 answers · asked by chad p 1

when the coil light started flashing the car lost all power the car still runs well the when hot but when cold it starts but miss fires and smokes for a bit can any one help

2006-09-23 23:48:47 · 10 answers · asked by Anonymous

the inlet valve on my clio broke due to water leak in the head which corroded the inlet valve that seized and broke, (not cam belt) the engine was idling when it went, and although there is a small dent in the piston face everything seems ok, apart from that the effected piston is now 0.75mm lower than the other three pistons when at top of the cylender, and when turning the engine over by hand there is a tight spot when all four pistons are midway in the bore. the engine turns perfectly on the starter with no knocking sounds,or signs of binding. can I chance buying just a new head or will the slight damage to the no 3 piston make it better to replace the whole engine, the car is 1991 clio diesel, with 70k, and I live in Spain, where old cars cost a fortune! but spares are cheap.

2006-09-23 23:25:45 · 11 answers · asked by ian g 1

Hi everybody. I have a question regarding the use of unleaded gasoline in older cars. I have a 1994 Mazda Protege I bought back in 1997 and because of sentimental attachment reasons I would like to keep this car. Back then leaded gasoline was not phased out in my country, and this particular car is a carbuerator engine, no cat convertor, designed to run on leaded gasoline. Back in early 2000s, leadd gasoline was phased out in accordance with the EU laws, and now it is impossible to find leaded gasoline anywhere. I have used unleaded gasoline in the car a few times and did not notice any difference in the way it runs.

I was wondering if it is OK to use unleaded gasoline in this type of a car, designed for leaded gasoline ?

2006-09-23 23:18:41 · 5 answers · asked by oralm2 2