After a few hours s10 will start up, run 4 awhile then do it agian. Not sure what it is, computer shows nothing, fuel pump & filter are ok,
2006-09-24 03:55:05 · 7 answers · asked by fljrrl 1 in Cars & Transportation ➔ Maintenance & Repairs
The s-10 is a 93', 4.3, vortec v6,
2006-09-24 06:17:44 · update #1
Kind of thinking its the central port injector (CPI)
2006-09-24 06:22:23 · update #2
look into the distributor, it sounds like the chip might be opening up as it heats up. they are not that expensive and relatively easy to install
2006-09-24 03:58:12 · answer #1 · answered by george m 3 · 0⤊ 0⤋
If its the vortec v6 they have a real problem with the injection unit in the intake manifold. Could cause a no start issue.
2006-09-24 11:57:03 · answer #2 · answered by ThisJustin 5 · 0⤊ 0⤋
You have a bad ignition module under the distributor cap.
GM sucks for that.
There are two screws holding it on to the advance plate, I think they're 1/4"
Take the scews out, un plug it, and have it tested.
They're about $22.
2006-09-24 11:00:36 · answer #3 · answered by Mr. KnowItAll 7 · 0⤊ 0⤋
REPLACE THE ING MOGULE IN THE DIST.DID YOU CK. FOR SPARK.IF NO SPARK CK FOR POWER AT COIL.W/SOME ONE IN TK HAVE THEM CRANK THE ENGINE OVERONE SIDE SHOULD BLINK IF NOTAND U HAVE POWER THERE REPLACE W/ABOVE PART
2006-09-24 11:02:16 · answer #4 · answered by hotwrench215 2 · 0⤊ 0⤋
You have an ignition malfunction, not fuel.
2006-09-24 11:11:38 · answer #5 · answered by Anonymous · 0⤊ 0⤋
what year? Engine/ CFI or TBI ? Do You have spark when it doesn't start?
2006-09-24 11:00:49 · answer #6 · answered by Magikmann 4 · 0⤊ 0⤋
if it is fuel injected ,check your crankshaft sensor
2006-09-24 11:07:08 · answer #7 · answered by cedarlogger 1 · 0⤊ 0⤋