Will 10psi do on a fuel injection system?
2006-09-24 02:59:01 · 4 answers · asked by Peej 1 in Cars & Transportation ➔ Maintenance & Repairs
No I believe it needs to be around 60 psi. Check your fuel pressure regulator and kinked fuel lines. You will probably need to replace the fuel pump and it is located in the tank
2006-09-24 03:09:39 · answer #1 · answered by lvtaride 2 · 1⤊ 0⤋
Pressure
Notes
Key On Engine Off 60-66 psi
Engine - Cranks But Does Not Run Diagnostics Revision
Notes
File In Section: 06 - Engine/Propulsion System
Bulletin No.: 01-06-04-057
Date: January, 2002
SERVICE MANUAL UPDATE
Subject:
Revised Engine Cranks But Does Not Run Diagnostic Table
Models:
2000 Chevrolet and GMC C/K Pickup Models
2000 Chevrolet and GMC S/T Pickup and Utility Models
2000 Chevrolet and GMC M/L G Van Models
2000 Oldsmobile Bravada
This bulletin is being issued to revise the Engine Cranks But Does Not Run diagnostic table in the Engine Controls - 4.3L and Engine Controls - 5.0L, 5.7L sub-sections of the Service Manual. Please replace the current information in the Service Manual with the following information.
The following information has been updated within SI2000. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.
The fuel pressure specification listed in the Values column for Step 7 currently shows 379-413 kPa (55-60 psi). The specification should read 414-455 kPa (60-66 psi).
2006-09-24 10:43:45 · answer #2 · answered by Magikmann 4 · 0⤊ 0⤋
29 - 31 pounds
2006-09-24 10:09:38 · answer #3 · answered by jepa8196 4 · 0⤊ 1⤋
+\- 34psi
2006-09-24 10:01:59 · answer #4 · answered by Mr. KnowItAll 7 · 0⤊ 1⤋