Do I dare try this . jackstands, neutral, eyeware, I have a vise , and sockets for the u-joints. both u-joints are tight no play, I have 1" of play at the center support bearing, I have the HB206FF Bearing & Support it has the 2 bolts on the bottom of tunnel. vertical .. unbolt at the flange in rear pull tword rear remove 2 support bolts and pull from trans then out the front of tunnel? both ends painted and marked. is this even close ? remove both u joints or just one ? or none? Help
2007-10-19
13:37:57
·
4 answers
·
asked by
boyde2000
1
in
Maintenance & Repairs