Maintenance & Repairs - June 2007

2007-06-24 09:07:56 · 7 answers · asked by Robert L 1

2007-06-24 09:02:12 · 20 answers · asked by ? 4

2007-06-24 08:57:15 · 6 answers · asked by Anonymous

2007-06-24 08:44:36 · 7 answers · asked by pokerplayer 2

i am fitting a power shower and want to fit a residual current device. i do not have access to the main fuse board and am intending to run a spur fitted with a 3 or 5 amp fuse to the shower .is there a self contained rcd that i can fit with out setting up another consumer unit

2007-06-24 07:55:24 · 6 answers · asked by benjie 1

I am in Minnesota and looking for a place to sell my heat radiators from my house I have all sizes and colors. Looking for a buisness or site?

2007-06-24 07:37:36 · 1 answers · asked by Sara C 2

2007-06-24 07:18:22 · 6 answers · asked by babe with an attitude 6

Ok my fan motor went out in my ac unit and I had that fixed and changed filter it got a little cool last night but not it's getting hot again and no air is blowing through the vents and when it does it's only hot air any suggestions on wat to do now?

2007-06-24 07:11:32 · 4 answers · asked by taffy2513 4

I have no idea what kind of riding lawn mower it is, but I was wondering not only in a car but the also a lawnmower what would cause a starter to keep going bad? I buy a new starter for the 3rd time and it is about to go out again. i know it has to be something more. Any suggestions????

2007-06-24 07:10:14 · 6 answers · asked by chrystalbryeans 3

2007-06-24 07:07:37 · 2 answers · asked by wdennise 1

I have a new water heater , it is sealed to keep vapors out. It has ran fine till yesterday when the drain in my basement got plugged and left about 1 foot of water in my basement.

It has a pizaro to relight it with, but it will not work ( possible, because striker is wet). I want to just remove part of the plate and relight it with a lighter , but there is a warning that saysto not remove the front plate.

I bleed off the gas and valed it off for over 24 hours, while I had a space heater next to it, it still does not want to light.


Any ideas will be appriciated.

2007-06-24 06:18:48 · 3 answers · asked by clone_marshal_bacara 2

I have 3 Kidde smoke alarms, one for each floor. Every now and then one will give out one short, very loud, BEEP and do this once every approx. 30 secs for about a day. They are all wired up to the mains, so it couldn't be a low battery. One started last night, so I could hardly sleep. Does anyone know what's wrong?

Thanks, I'd really appreciate any sensible suggestions.

2007-06-24 06:18:22 · 26 answers · asked by Luke M 3

We just redid the a/c system in our condo.. new duct work and all- everything is brand new. We have a humidity meter, and i put it directly over the vents, b/c im trying to find out why my allergies are bad, and was advised to keep humidity down in my house. Our humidity ranges from 45-60 in the house, but the vents emit something different and Im trying to conclude if this is normal before we go investigate. The A/C is down in a crawl space, and it is somewhat damp. The Ductwork might need to be sealed up also (hubbie hasnt gotten to it yet).

When the A/C is "ON" and circulating- the humidity ranges from 60-65%.

When the system is on "Circulate" (which is a feature i really wanted to keep air running through our IQ Air hepa system) it is REALLY humid, registering around 75-80% (WET) on our meter.

Im guessing the coils are wet, and the air circ's over and brings moisure with it upstairs.

What, if anything, can we do about this?

System is American Standard 16 Seer w/ Air handelor.

2007-06-24 05:35:11 · 4 answers · asked by 3Diamonds 1

i have an exam in a few weeks & dont understand what points on an electrical system to test for the above
if any good egg sparkeys or lecturers can put in laymans term please help
regards

2007-06-24 05:29:13 · 5 answers · asked by R I P 2

We are having our hardwood removed and the floor inspected again. I am thinking that the builder did a poor job of installing the subfloor. So any other info on sub floors would be greatly appreciated as well. I live in VA if that makes a differnce with standards (which I don't think it should).

2007-06-24 05:27:06 · 9 answers · asked by italian499 1

2007-06-24 04:56:02 · 4 answers · asked by maddenplaya64 1

How long and how often should you run a pool pump on above ground/above pool?

2007-06-24 04:51:18 · 5 answers · asked by Brezzy 3

2007-06-24 04:34:46 · 4 answers · asked by melly 4

2007-06-24 04:31:40 · 4 answers · asked by stevem309 1

Right now, the condesation from my AC leads to a pipe on the side of my house. This drips into a bucket, which in turn drips onto the grass creating a swamp. What is the best method to get rid of this water so it doesn't lead to a soggy yard and risk damaging my foundation? Thanks.

2007-06-24 04:21:55 · 3 answers · asked by Tim 1

2007-06-24 03:53:50 · 5 answers · asked by david b 1

I just had a concrete driveway poured (no staining, stamping, etc). When asked if I needed to keep it moist (I had heard this helps the curing process) they guy said no. I'm seeing on various internet sites that I should. I just had it done less than 48 hours ago and I'm wondering what I should do.

2007-06-24 03:09:52 · 7 answers · asked by AlexPKeatonJr 2

I'm talking about light bulbs for the rooms in the house.

2007-06-24 03:06:50 · 8 answers · asked by Anonymous

Which is better?

2007-06-24 03:06:01 · 4 answers · asked by Gary L 2

2007-06-24 02:25:11 · 4 answers · asked by Matthew M 1

samsung double door.how to check auto defrost is funtioning.location pune.peculiar to high humidity??????

2007-06-24 02:13:32 · 5 answers · asked by Anonymous

2007-06-24 01:55:14 · 5 answers · asked by Curious mind 2

my son left the water running, and the sink overflowed.

2007-06-24 01:29:12 · 5 answers · asked by ajflgrl 2

I have had my 19.2v craftsman cordless set for about two years now and the batteries are not holding a charge as long. I have seen on Ebay these repair manuals that claim you can repair them and I do not know if that is true. Has anyone repaired there cordless battery and does it work. Would you tell me how to repair my 19.2v craftsman cordless battery?

2007-06-24 01:19:44 · 5 answers · asked by Rere 1

2007-06-23 23:59:30 · 6 answers · asked by Anonymous