Monitors

2007-02-06 12:01:34 · 2 answers · asked by scott w 1

I am debating on get a high-defintion tv or a lcd monitor

2007-02-06 09:39:45 · 3 answers · asked by pismoru500 1

2007-02-06 08:43:32 · 4 answers · asked by Anonymous

2007-02-06 08:15:15 · 2 answers · asked by Anonymous

2007-02-06 07:35:12 · 3 answers · asked by ghostman 1

he clears the histroy and delets recent web pages and is more PC savy than I?

2007-02-06 06:08:16 · 7 answers · asked by b c 1

I checked the /etc/X11/xorg.conf file and it goes up to 1024x768. I go to System -> Preferences -> Screen Resolution, and the resolutions are 800x600 and 640x480. I can have 60 or 56 hertz for 800x600 and only 60 hertz for 640x480. I can get past 1280x1024 on Windows and I still get 75 hertz. (I have a CRT) I read that I should get a better driver or something, where should I get it, or what should I do?

2007-02-06 05:59:37 · 3 answers · asked by Matt 2

After I leave my PC in the stand by mode for a long time,it does'nt turn on by itself when I press any key or shake the mouse.The LED on the monitor too keeps blinking and nothing happens.I have to restart it all over again.

2007-02-06 04:42:30 · 8 answers · asked by sanjeev saraogi 1

2007-02-06 02:29:46 · 14 answers · asked by mani m 1

i use computer almost daily for more than 5hr's without using any aye protection i.e ANTI GLARE NOR GLASSES

THANX

2007-02-06 00:45:23 · 4 answers · asked by zoom85 2

2007-02-05 22:59:51 · 4 answers · asked by prabin p 2

The monitor has built in speakers it is also an Hp. Sound was working fine the day before then it just stopped. Volume button and mute button still work.

2007-02-05 22:34:20 · 2 answers · asked by Tony F 1

I know, it's probably a very basic question... but when you don't know the answer... thanks in advance if anyone can tell me this.

2007-02-05 21:44:37 · 7 answers · asked by hecarte_1 2

My monitor sometimes goes all stripy and the picture disappears. I squeeze the upper left hand side and the picture comes back as long as I am holding it, then I shake it and hit it and shout at it and squeeze again and then if I'm lucky the picture stays when I stop squeezing it.
What is going on?

2007-02-05 19:56:33 · 5 answers · asked by cigaro19 5

Hi. I ordered a widescreen for my wifes computer. Does windows XP have all the neccessary settings for this to work properly? Is there any forseen problems with this?
How do the wide screens fit a webpage, is it stretched? Anything else you can tell a widescreen newbie? Thanks in advance.

Oh yeah, its an acer widescreen and a sony vaio PCV-RS510 with onboard Intel 82865 G Graphics.

2007-02-05 15:46:31 · 3 answers · asked by eetrapnoel 2

My monitor just gave out. Was working fine, before going to black. It will turn on for a split second before shutting off again. The same thing happened to my tower and it was the power supply, could it be the same thing for my monitor?

2007-02-05 15:19:47 · 5 answers · asked by wimbo5 1

I turned on my laptop this morning and it looks like my screen size has shrunk. There are two black bars to both the left and write of my screen and I need to know how to stretch it back out. I have tried looking in display options but am afraid I am looking in the wrong place.

2007-02-05 09:59:27 · 12 answers · asked by Anonymous

2007-02-05 07:24:18 · 11 answers · asked by Anonymous

All other screens are great. Jim

2007-02-05 06:44:49 · 1 answers · asked by cowboyjim58 1

I have a relatively new flat screen monitor that has suddenly started turning itself into standby mode and won't turn back on. Everything is plugged in ok, the monitor is set to not go into standby mode at all and is turning off while the pc is being used, not during periods of inactivity.

The only common factor is its been doing it since i installed MSN 8.1 beta last week and altho it has turned off while I've been opening other programs 9 times out of 10 its only with messenger, the other programs work fine. I have uninstalled MSN but it continues. I've run a full virus scan too and that came up blank.

Anyone have any suggestions or ideas? Besides a new monitor of course!

2007-02-05 06:08:11 · 7 answers · asked by Andromeda Newton™ 7

This has been happening more frequesntly lately--I have never seen this before on any computer--it's a Dell laptop. The screen just starts moving up and down for about 5-10 seconds, then stops. While it is happening, you cannot close the screen or do any commands

2007-02-05 03:02:43 · 3 answers · asked by stitcher 1

I had a hard time choosing these two monitors but I took the more expensive and older model because it came with a 3 year perfect screen warranty. That means that I can change the monitor anytime the screen has a dead pixels. For the cheaper and newer model, I had to wait for 2 dead pixels within the first year and 3 pixels the following two years before I could change it. Do you think that my choice to pay more and buy the older model was worth it for the "perfect screen" warranty?
-------------------------------------------------------------------------------------
Retailing at US$295
Response Time: 8ms
Contrast Ratio: 700:1
Brightness: 300cd/m2
Dual Input VGA/DVI
Built in Speakers
USB 2.0 port
-------------------------------------------------------------------------------------
Retailing at US$260
Response Time: 5ms
Contrast Ratio: 800:1
16.7M Colors (8bit)
Brightness: 300cd/m2
Dual Input VGA/DVI
Built in Speakers
Dual tone Design

2007-02-05 02:49:45 · 3 answers · asked by Anonymous

The video needs to go to all 4 monitors at once so that you can view a different application in each monitor. (ie monitor 1 - internet explorer, monitor 2 - Microsoft word, Monitor 3 - Microsoft Excel, monitor 4 - Quickbooks)

I am guessing that it will require 2 video cards that each have two video outs.

Does anyone know of a good solution? Specific make / brand info would be most usefull.

Thanks!

Rj

2007-02-05 02:16:33 · 3 answers · asked by rjfoster22 2

Cause my monitor broke down few days ago so i plan to buy an LCD Monitor...But i not sure what brand and whether to buy 17" or 19"...


And what is RSP(like 2MS,4MS,6MS,8MS,16MS)? and its Input A and A+DVI,what's the difference? and its CR (400:1, 600:1, 700:1, 1500:1) Will those thing are important?Anything else important when by an LCD monitor?



Pls help....I appreciate everyone's reply!
Thanks!

2007-02-05 01:35:35 · 9 answers · asked by Kenji 1

2007-02-05 01:29:02 · 3 answers · asked by philbrook1974 2

2007-02-05 00:45:25 · 5 answers · asked by totit73 2

what's the hibernate button on the XP for? and how do you make your computer not hibernate? last queastion... is it bad for your computer?thanks

2007-02-04 17:55:35 · 3 answers · asked by d30f2n 1

I have them set up on the control panel to come on if the computer is idle for 5 minutes and they don't come on. Can anyone help???

2007-02-04 15:49:25 · 1 answers · asked by cwigg 3

Hi! I have just built a new computer with a P5GZ-MX motherboard. Everything was working spiffingly but after less than a week the display suddenly gets these columns of coloured lines through it, I can see the desktop through the lines but I am unable to do anything like move the mouse or use my keybard to shut the computer down. I have tried reinstalling the motherboard drivers, and this seemed to fix the problem temporarily, but then it came back again. I assumed it could be the onboard VGA on the motherboard, so I replaced the motherboard completely with the same model, but the same problem happens again. Any suggestions would be very much appreciated! Thanks!

2007-02-04 15:02:41 · 4 answers · asked by Guitar_Girl 2

i had a ati card on my pc then if fried and i cant use my onbord cuz the monitor doent show any picture, but i can hear the computer start up, could there have been a conflickt with a driver or something cuz i have tried everything and it just dont work

2007-02-04 13:56:51 · 3 answers · asked by Luby 5