English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Maintenance & Repairs - March 2007

[Selected]: All categories Cars & Transportation Maintenance & Repairs

The mechanism is the part which moves the wiper

2007-03-03 05:51:53 · 8 answers · asked by Anonymous

I hit a curb while sliding on ice and now the passenger side tire is pushed back and in so now it rubs against the wheel well... it is front wheel drive the tire spins and turns but is "out of place" please tell me its just the tie rod?

2007-03-03 05:38:01 · 10 answers · asked by Matt 1

I have an 84 Chevy Suburban 6.2 Diesel engine. I had a starter put on a while back and the shop that had it, I had to take it back a couple times, and it turned out they used a bolt that was too long and they never bothered to check how tight it held, so it shook and stripped out the holes in the block. After they completely messed it up again, and ate up yet another starter, I decided to do it myself, I knew I HAD to get it fixed because I am moving across the country in 2 months and using the truck to tow a trailer. After I figured out that they had a bolt that was too long, I managed to get 1 small piece of a shim kit between the block and the starter, and put 4 washers on the bolt that is too long, since the HeliCoils they put in had been stripped out, I knew they wouldnt hold for a long time on their own, so I put JB weld in holes to keep it, it turns now and seems ok, my issue is I am trying to decide between rebuilding an old 6.2 myslef or buying a crate engine. Advice?

2007-03-03 05:04:32 · 6 answers · asked by Anonymous

When I turn key forward I can hear the fuel pump kick on but isn't it supposed to shut off eventually? Also I had just filled it and the gauge say's empty.Is my fuel pump shot or maybe frozen?

2007-03-03 04:45:45 · 3 answers · asked by Anonymous

I think on some models, there are resistors or reostats that look like a spring that reduces the voltage for low speed. Could this be my problem and if so where would it be located?

2007-03-03 04:41:47 · 4 answers · asked by dannywilliams9 1

answers please!

2007-03-03 04:31:08 · 6 answers · asked by Chevy 1

where can i buy flashing amber strobe lights for abnormal loads the type that go in the grill must be in yorkshire

2007-03-03 03:53:21 · 3 answers · asked by orphan boy 5

2007-03-03 03:52:19 · 5 answers · asked by Adam H 1

2007-03-03 03:40:23 · 4 answers · asked by scottm1211@verizon.net 2

When it doesnt statr i get no lights no turn in starter its almost like the battery is not hooked up or something then when it does start i get a clikcking for a second then it starts. All the lights take turns going on each time it is started check engine, anti-lock,low tire,ect.

2007-03-03 03:37:43 · 3 answers · asked by jesse k 1

2007-03-03 03:35:28 · 2 answers · asked by brian b 1

How do you get to it?

2007-03-03 03:31:43 · 3 answers · asked by Black126 2

i've been spraying plastic car interior parts but i think i put the paint on a bit thick and its ran and has dried with drip trails in it. how can i remove them to get it all smooth again to respray it?

2007-03-03 02:30:21 · 6 answers · asked by Danny M 1

My mph was going haywire as I was driving down the street and then the car stalled, I tried to start it again,And with alot of hesitation it started; but then again it stalled. And now it won't start at all.It does sound lik it wants to start but does'nt . I stuck I tried alot of things, maybe you can help!!! I do work on my car myself!!!!

2007-03-03 02:28:59 · 4 answers · asked by Anonymous

it runs, but leaks trans. fluid.....could it be a front trans. seal, or a trans. line???

2007-03-03 02:26:14 · 3 answers · asked by fisherkid13 1

if my clear coat is spraying an orange peel through my HVLP, no matter the settings on the gun, can I reduce or add the amount of hardner to fix this? And how much change?

The temp is correct for the product, thanks.

2007-03-03 02:17:17 · 2 answers · asked by Anonymous

I just bought a new G5 yesterday and I am trying to find a billet grille for it. Preferably one that would go in the top two peice grille and on the bottom three part grille!!! I found one on Ebay but it doesn't cover all the bottom! Any help would be greatly appreciated but please dont say TRY EBAY! Cause I already have and dont like what i found there...Thanks!

2007-03-03 02:12:31 · 2 answers · asked by Brown_Eyed_Girl 4

and is this the turbo boost pressure sensor also?

2007-03-03 02:11:25 · 1 answers · asked by heavyhauldad 3

2007-03-03 02:07:51 · 9 answers · asked by BAH 1

my son needs to know how

2007-03-03 01:52:01 · 3 answers · asked by emarston@btinternet.com 2

I am looking for used steel rims from the auto bone yard

2007-03-03 01:49:47 · 1 answers · asked by mdsaco 1

Has anyone fitted the Eibach or Intrax lowering springs for their FX35 and what was the result, look and ride quality.
Which one would you recommend and why?
Let me know A.S.A.P...Thanx

2007-03-03 01:42:55 · 1 answers · asked by Anonymous

My windshield broke over the winter and some moisture seeped in and sat for at least a month before it was repaired. Now, although the car interior looks immaculate, it has a strong musty mildewy smell. I don't know where to begin to clean it. Any suggestions?

2007-03-03 01:37:46 · 8 answers · asked by Anonymous

2007-03-03 01:11:40 · 2 answers · asked by shaun w 1

The truck has 195.000 miles.
The trans is locked in a high gear. The truck can be driven by riding the clutch.
The shifter stick fells totally disconnected but still in place and can moved around freely. I cannot shift out of that high gear 3rd, 4th or maybe even 5th gear. I'm 60 years old, mechanically inclined and am planning to repair this myself. What is the most common reason for this happening? Could it be something as simple as a worn-out washer or spacer? Is there a chance I may be able to repair it without removing the trans from the vehicle?

2007-03-03 00:55:38 · 4 answers · asked by hop-a-longmd 1

2007-03-03 00:55:32 · 10 answers · asked by Anonymous

fedest.com, questions and answers