2007-03-03 03:52:19 · 5 answers · asked by Adam H 1 in Cars & Transportation ➔ Maintenance & Repairs
I have drums in the front, I want to convert them but disks brake kits cost alot. I have taken off the tires and the drum from my front tires but I can't seem to get the cylinder out.
2007-03-03 04:22:34 · update #1
easy job
2007-03-03 03:55:39 · answer #1 · answered by Anonymous · 0⤊ 0⤋
ok.pull the drums off and loosen the top of the shoes and pull them from the cylinders and take off the line(it will probably break,spray the line fitting)once the line is off,i think that car either has 2 bolts or a clip to hole the cylinder in place,take them out and the cylinder will come off,and its just in reversre to install the new one,but make sure when your done,bleed the brakes.
2007-03-03 03:59:39 · answer #2 · answered by Anonymous · 0⤊ 0⤋
Front? rear? master? which one??
Undo the brake line, take out the bolts holding it in, replace it with a new one you bolt back in place, reconnect the Brake line, then bleed the Cylinder (after you re-assemble the brake) as to make it work.
2007-03-03 03:58:27 · answer #3 · answered by occluderx 4 · 0⤊ 0⤋
ok after you get the drum off ,in the back you see 2 bolt,thar hold the ci=yin, on, now remove the brake line, the with i belive it a 7/16thy, wrech, you can remove the blot, may sure all spring are of be fore doing this
2007-03-03 09:39:50 · answer #4 · answered by ghostwalker077 6 · 0⤊ 0⤋
it would help to know which one,i have one working on it now,I'm converting it over to disc brakes i could help if i knew which one. good luck.
2007-03-03 04:00:22 · answer #5 · answered by dodge man 7 · 0⤊ 1⤋