Maintenance & Repairs - January 2007

why?? is this usual?

2007-01-08 19:05:50 · 3 answers · asked by peter g 1

they are AllData Disk LLC/and on the disk itself is printed AFW DISK with a semi-circle ending with an arrow. Also as an example of one of these disks' is a long number which turns out to be a part number we believe. the container they came in says software installation disk/140 piece set/dated from 1999 and back. We are curious to know if we got a good deal or not and what to do with them and how to use them if needed. such as do we need some sort of password or code to use them or what? I know this is a big order, but hopefully someone out there is smart to know what they are.

2007-01-08 18:47:23 · 4 answers · asked by granmasunflower 2

The clutch works fine when driving. It pushes down very easy like normal when starting the car. But once it is fully depressed I then have to wedge myself against the seat and continue to push with all my strength to get the engine to turn over. Now my husband has to do it because I'm not strong enough. I have looked behind the pedal and everything seems normal. Can somebody please tell me what I need to do?

2007-01-08 18:35:01 · 9 answers · asked by Hannah H 1

I am taking the truck to ford this week, but do not want to go in blind. I would like to see what the flash cose I have is so Ford does not take me for my pants and shoes.

I don't have the truck now, else I would let youall know the specific code.

Thanks in advance Dave

2007-01-08 17:57:05 · 1 answers · asked by dave996063 2

oil is good every 2800ml

2007-01-08 17:33:38 · 12 answers · asked by FROSTY DA GREATFUL 1 2

1993 Ford Taurus GL 3.0 V6

2007-01-08 17:29:49 · 13 answers · asked by HorribleDeath18 1

Had one burn out after only 2 weeks in my Acura.

2007-01-08 17:19:47 · 5 answers · asked by John71 3

We have replaced the water pump and seals on the car a few months ago.my husband took the car on a long drive and when he came back i can smell the anitfreeze inside the car.When it starts and the hearter is on but, the floor is not wet the heater is not misting anything and the widows are not foggin up so i assume that its not the heater core. also i Do not see any leaks on the ground. The car will start to get warm on the guage but then it goes back down to normal and the smell will clear up after a while but comes back? Anyone have any idea what it is or where to check for leaks. again the seals are not leaking there is no antifreeze in oil and i havent had to add any antifreeze so if its a leak its not a big one.

2007-01-08 17:16:39 · 8 answers · asked by me 3

2007-01-08 16:55:33 · 5 answers · asked by Greg8325 2

I have a chevy prizm, and I have to pass emissions with gateway clean air and I have three OBD codes
P0300 Random/Multiple Cylinder Misfire detected
P0303 Cylinder 3 Misfire Detected
P0171 System Too Lean Bank 1
P0420 Catalyst System Efficency Below Threshold Bank 1

car is sputtering and shaking, have replaced sparkplugs,air filter just wondering what it could be?

2007-01-08 16:54:32 · 1 answers · asked by chrissybe26 2

So, I have a 1997 honda accord with a small little engine and an 1987 buick V6 2.8 with low millage. The body of my Buick is dying but performence remain strong. is it possible to take that Buick engine and stick it in Honda Accord??? if it is, would it be worth it and how much would it cost? Thanks.

2007-01-08 16:50:07 · 8 answers · asked by boygenis 3

2007-01-08 16:41:22 · 11 answers · asked by karla m 1

I had litertaure on a addative that was added to the engine that would seal miner leaks in the head gasket. It been lost

2007-01-08 16:34:34 · 5 answers · asked by MONK 1

Hi
I have 1997 dodge 3500 with a cummins turbo diesel 5 speed stardard. I found a 1996 computer for a 2500 dodge cummins with a 5 speed stardard tranny. Is there any one who could tell me if I could use the 2500 computer?

Thanks.

2007-01-08 16:33:14 · 3 answers · asked by trippykat666 2

please help, i dont wanna tell my dad or he will flip

2007-01-08 16:29:52 · 6 answers · asked by Anonymous

2007-01-08 16:27:06 · 1 answers · asked by Ray Misses his daugther 1

Someone backed out of a parking spot as I was driving by and raked the side door and rear panel of my 93 Honda Civic Coupe. In my opinion, the door is repairable with some good "stucco" or whatever they call it, but the damage to the panel behind it goes in a number of inches. It's not a part that can be simply removed and replaced.

Does anyone have any rough estimate as to what it could cost as I'm concerned this will cause the insurance to total the car which I don't want because the car is worth way more to me to keep it. I'm going to get estimates myself, but would like to have some sort of general idea.

2007-01-08 16:01:16 · 5 answers · asked by currious 4

2007-01-08 15:45:08 · 10 answers · asked by papashamo 1

I was recently in a car accident and damaged the front drivers side of the car...front bumper replaced, side quarter panel replaced...back from body shop..car looks like new, does not feel like new...The day after I get my car back I went out to the store, came out to leave and the car turned over for about 7 seconds before it started. Today I went out again and when I came out of the store my car would not even turn over...click click click click nothing. Hooked up one of those portable jump packs to the battery and the car started up IMMEDIATELY. I drove the car immediately to the garage that fixed my car from the accident. They took it in and looked at it, got some print out and is telling me the alternator is bad. Do you really think its the alternator thats bad? If it is, is it possible that the alternator some how got damaged because of the accident? I find it really hard to believe that the alternator just happened to go bad at the same time as accident. R the 2 related somehow?

2007-01-08 15:38:13 · 12 answers · asked by wackowarner2001 2

2007-01-08 15:33:37 · 11 answers · asked by David S 1

2007-01-08 14:56:27 · 1 answers · asked by John L 5

Is there a special tool to use for holding the pulley from slipping while tight down the nut?

2007-01-08 14:53:56 · 4 answers · asked by k2000 1

Also would anyone have a 1981 holden jackaroo workshop manual they are willing to part with.

2007-01-08 14:53:08 · 2 answers · asked by lily 1

2007-01-08 14:50:23 · 5 answers · asked by sabian404 2

My Service Engine Soon light came on? I had the dealer run a diagnosis and he said it was a bad Oxygen Sensor? What is it? And what does it do? PLEASE HELP?!?

2007-01-08 14:31:24 · 8 answers · asked by Tyler 2

How do you check the OBD on 1994 buicks? Would it be the same as a 1994 Chevy pickup? I have a book for the truck, and the buick isnt mine, so im not getting a book for it. I hope someone has a website that can help me ( and my friend ) out.

2007-01-08 14:30:12 · 3 answers · asked by Anonymous

2007-01-08 14:21:54 · 5 answers · asked by landtwl 2

Alright well heres my BIG problem. Up until recently it was driving ok, but now it takes forever to start, and while that is happening all I hear is it stumbling, and make a noise similar to something like a tin can being hit, then it starts, I reverse and it will stop again, I turn it on and have to drive around awhile to make sure it wont stop while I get on the main street, at red lights or a long stop it takes awhile for it to get up to the speed limit, I can't even go uphill or it will stop if its that high, I know I can repair it myself but am stumped at where the problem may lie and I dont want to try fixing something and mess it up, (if it can mess up anymore >:/) Any advice or idea what is causing this?

2007-01-08 14:14:51 · 5 answers · asked by Summer 4

okay i pretty sure i need a full service tune up.. what parts can i buy on my own to help reduce the price.. like spark pugs and what else?

2007-01-08 14:03:59 · 23 answers · asked by teddy bear 2

Okay let us hear all of your spark plug war stories...

What brand is best and why?

What brand gave you no end of trouble...

Everyone has a right to express themselves.

2007-01-08 14:01:04 · 14 answers · asked by Anonymous