Ford

2007-07-28 12:56:30 · 7 answers · asked by deliciadawn 2

suggestions please

2007-07-28 11:46:42 · 25 answers · asked by HERBS 2

2007-07-28 10:18:59 · 7 answers · asked by Anonymous

Same car, different question:

Mechanic says bad head gasket and diag. misfire codes 1 & 6, tested ign o.k.

I believe I have the standard v-6, 3.0 but will confirm this, (as an earlier answer stated) that the 3.0 vourtec engine would prob. be over my head.

I am thinking about taking off heads myself and take too machine shop for inspection etc... and replacing head gaskets.

I will go too the library for Chilton's info.... I tinker on cars and do basics, have torque wrenches etc... just not much engine experience... I think I want too attempt the head gasket replacement, at least I could open it up and have my fam. relation who is a mechanic take a look at it (not Ford Mech, is V.W. mechanic)

Car has 100,000 but was babied all the way, and looks good also.

What do you think, Go for it?

My Olds Shilloette has 264,000 and never any problem, my 2-subaru's (tinker on) 150,000+ when I bought them and replace bad motor, so a Ford with 100K and bad head gasket suckss

2007-07-28 08:41:45 · 3 answers · asked by Maken trax 4

I have a question about the styling of the Ford Mustang. I was looking at pictures of old mustangs and saw the 1978 Mustang with its bold styling and mini-Trans Am-like styling. Then I saw the 1979 redesign and I didn't even think that it was a Mustang. The design was so bland and so simple. Just hard unintuitve curves and without distinct styling. Why would anyone buy the 1979 version (in record numbers by the way) after seeing how much better the looking the previous version was?

2007-07-28 07:27:21 · 8 answers · asked by spapartiestogo 2

2007-07-28 06:59:02 · 5 answers · asked by nightmarecue 2

I have a 2002 Ford Focus and I took it to a repair shop and explained that it over heats when I use my air conditioner and the Raditator Over flow is continously low. The repair shop did a diagnostic test and stated that nothing was wrong. Help. The car acts as though it does not want to go or pick up speed at certain times.

2007-07-28 05:34:52 · 5 answers · asked by sheilam115 2

My car sat for a week almost on empty. Now it won't start. It makes a rapid clicking sound - I added gas and then it started to turn over but then goes back to the clicking sound. Help!

2007-07-28 04:58:24 · 19 answers · asked by Diana M 1

new distributor set at 14 degrees. new coil ,voltage regulator. nwq alternator, battery.starts fine when it wants.. y not every time...

2007-07-28 03:55:56 · 5 answers · asked by Terry P 1

I don't want to rely on the dealer.

2007-07-28 03:19:25 · 5 answers · asked by plainswalker 3

I have a 1996 Ford explorer with 145k miles on it. When I reach about 60 mph the truck kind of shook and started riding rough, but then it was ok when i got to 70mph. The check gage light came on. Does anyone have any ideas on what the problem would be?

2007-07-28 03:06:03 · 6 answers · asked by timtaylor1986 1

I've got a mk2 P reg Mondeo with damp carpet on the passenger side of my car. its mainly at the back (proper saturated) but also at the front.

After scanning many of the owners club forums and ripping up a bit of carpet i think i've tracked it down to coming from the centre pillar (the A frame?). what ideas can you think of as reasons, and how can i best do a bodge DIY fix?

any ideas? the car was only £400 on ebay, so i don't want to take it to a garage and get charged a quarter of its value to get it fixed.

2007-07-28 03:05:20 · 5 answers · asked by petesaysblimey 1

I sold an old ford when I was 17 and I am now 68. I am curious as to where the tiltle is because I cannot remember if the car was a 37,38,39 or 40 model. Tim Gillis 119 driving park road, wellston, ohio 45692

2007-07-28 02:48:37 · 6 answers · asked by tg56@verizon.net 1

i know its minus the turbo obviously but i was wondering if i just turbo a XR2i will it have the same engine (and performance)as the RS turbo

2007-07-28 01:09:27 · 2 answers · asked by stumpy0781 2

The primary drain is lower in the valley of the block and this second drain is further to the left (facing the block). The std timing chain cover does not cover the drain. Has anyone heard of this? What kind of block is this? Have looked around to find a cover to fit but have not been successful.

2007-07-27 17:13:11 · 4 answers · asked by Big G 1

2007-07-27 16:24:16 · 8 answers · asked by Anonymous

Iv seen this @ https://www.turbonator.com/OrderPage2.html
Also on TV

2007-07-27 13:25:24 · 4 answers · asked by seedless4me 1

2007-07-27 13:07:40 · 5 answers · asked by LORI M 1

i know its a mustang but they go about the same speed of a mini couper(research has shown)

2007-07-27 13:00:39 · 5 answers · asked by Allison W 1

its a 1999 v6 mustang....i was wantin to buy some 4:10 gears for it but idk if the rear end is 8.8 or 7.5...thnx for the links and answers

2007-07-27 12:25:56 · 6 answers · asked by W1CK3D GT 1

2007-07-27 11:39:38 · 9 answers · asked by Anonymous

Help with my first car

2007-07-27 11:29:42 · 13 answers · asked by xxpeachsoftxx 2

2007-07-27 08:54:12 · 4 answers · asked by Ileana B 1

Could someone give me a step by step approach to changing a fuse in my truck?

2007-07-27 07:16:28 · 3 answers · asked by glpuck 1

anybody know how reliable these cars are and if they tend to have problems i n any specific area, seems like a good deal with the low miles compared to hondas that have 150k plus. any boby know

2007-07-27 04:07:20 · 10 answers · asked by Anonymous

Could it be an old greek word, as the word zephyr, the name of another car from a few years ago(made by ford car company in the 1960 s.

2007-07-27 01:45:24 · 6 answers · asked by John j O Connor(farida O Connor 1

I am going to have to drive it and I am afraid of it. I am 5'3" and have to get a running start to get in. It is pretty funny but would I be better off with a smalller car or truck?

2007-07-26 19:41:51 · 10 answers · asked by alexxxa $ o's 4

2007-07-26 18:40:14 · 9 answers · asked by slickrick542003 1

...Besides my nickname in high school? My 2006 Explorer 4x4 with that beautiful 3-valve V-8 and 6 speed is great, but it started to bump forward a bit when I came to a stop. They replaces some throttle body thingy. What does that do, and is it expensive to fix? I was covered under warranty this time, but I am concerned that it may happen again out or warranty since it is only a year old now with 26K miles. Any Ford guys know if there are any known issues with this? Thanks.

2007-07-26 17:06:03 · 6 answers · asked by Cheesetoasto 3

2007-07-26 16:17:04 · 4 answers · asked by Jason M 1