Chevrolet

Where would I start checking to find why the heater doesn't work? The Blower motor doesn't spin at all. I think it might be the switch. Is there a way to take the dash apart without breaking it?

2007-04-15 12:50:12 · 7 answers · asked by joshm2k5 2

Well, maybe not flying, but, I replaced my spark plugs and cables recently, all has been well. Before I replaced them I noticed the same thing. I don't know a whole lot about engines but, the arc is located next to the main cable that comes out of the distributor. It looks like a clip type connector. It was rainy today and it took quite a while to get it started. Now I can see the spark and the truck is chugging along. If I give it a lot of gas it seems okay, but when it slows down or I give only a little gas it sort of sputters. Any ideas?

2007-04-15 10:05:49 · 4 answers · asked by Nick O 3

2007-04-15 09:54:29 · 2 answers · asked by Angie C 1

I have a 91 Chevy Silverado with a 350 TBI. It's used as a tow vehicle/ Service truck.

2007-04-15 04:57:00 · 10 answers · asked by djm749 6

2007-04-14 15:58:25 · 7 answers · asked by angelaleman13 1

2007-04-14 14:59:00 · 13 answers · asked by jmhwme 2

i want to buy a Chevy El Camino but im looking for a fuel injected motor. I am not sure which year ELCOS were made fuel injected.

2007-04-14 11:57:54 · 5 answers · asked by b.i.b.l.e@sbcglobal.net 2

have 06 trailblazer 4.2L I currently tow a 23' trailer with it and would like to be able to get a lil more out of engine.
anyone with any successful engine tweeks?. have a cold air intake on order. no aftermarket exhaust exsists for the EXT version. Throttlebody spacer is a thought if anyone can say they have had success. Any other thoughts?

2007-04-14 09:52:22 · 2 answers · asked by tj0744 2

2007-04-14 08:19:10 · 3 answers · asked by Ashley C 1

Its got spark on all cylinders, gas coming out of each spark plug hole. Timing chain checked,crank positioning sensor replaced,cam sensor replaced. Only seems to be firing on number one. And seems to have compression. And does anyone know if it has a roll over switch or inertia switch and if so where is it located at? Any help would be deeply appreciated.

2007-04-14 05:27:07 · 5 answers · asked by wenmanfamily4 1

I want to put a frame from a 2000 s10 standard cab short box 2wd under a 2 door 2000 blazer. will it work? are these frames even close to the same?

2007-04-14 05:01:21 · 6 answers · asked by Anonymous

My husband recently purchased a used 2003 Chevy S10. He's trying to change the wheels out, but for some reason, he can't get the rear wheels off. He removed the lugnuts already, but there seems to be some sort of 'lock' in the center of the rim. He's tried hammering it to loosen it, and also spraying WD-40 on it, but it's not budging. Does anyone know anything about this?!? Thanks in advance for any help!

2007-04-14 05:01:16 · 9 answers · asked by Anonymous

can i put 305 heads on my 350, i hear its good for low end

2007-04-13 18:08:03 · 11 answers · asked by Anonymous

I recently revieced a full tune-up

2007-04-13 17:08:51 · 10 answers · asked by spaz_kadet 1

These cars a notorious for blowing head gaskets and so I figured if I could relieve the system of the 15 psi then it would last longer. Any thoughts? I know on the older vehicles the coolant reservior is mounted 'after' the rad cap, but on this vehicle the rad cap is mounted in the reservior. I used to take an old inner tube and cut a round donut so it fit into where the rad cap sits, and I'd cut a pie shape out of it, and with the rad cap screwed on, the coolant would run unhindered in and out of the reservior as it warmed up and cooled down. These cars are different, as I said the cap is now built-in to the reservior.

2007-04-13 14:18:22 · 10 answers · asked by Vincent J 1

1968 corvettes

2007-04-13 13:17:19 · 13 answers · asked by Carolyn L 1

2007-04-13 09:16:08 · 7 answers · asked by smartnesskills 2

i have a 1989 chevy suburban that until recently has ran fine. the last time i tried to start it, it made a strange noise and then did nothing. i checked the battery and its fine. i have ran through all the fuses and wires and found nothing wrong. it looks like it should run but it does nothing. lights, radio, horn, nothing works.

2007-04-12 17:41:12 · 8 answers · asked by Bigddge78 3

i want to know why people who like fords think they are so bad a** and they always run their mouth to CHEVY owners ( i know tons of answers i just want to hear yours)

2007-04-12 17:15:35 · 22 answers · asked by Anonymous

2007-04-12 13:59:20 · 8 answers · asked by toby c 1

2007-04-12 12:53:52 · 6 answers · asked by artie p 2

I have a 93 Silverado 2 Wheel drive auto with a 350 v8 engine and was wondering how much you can tow with it.
Thanks Gary

2007-04-12 12:18:53 · 7 answers · asked by gr7744@verizon.net 2

2007-04-12 11:22:31 · 3 answers · asked by ? 1

any answer appreciated

2007-04-12 10:35:42 · 5 answers · asked by Anonymous

2007-04-11 17:35:06 · 10 answers · asked by Anonymous

OK!!!


the two cars are:



1) Chevy TAHOE

2) Chevy SUBURBAN

2007-04-11 13:01:54 · 5 answers · asked by ek9506 1

2007-04-11 12:14:14 · 8 answers · asked by ben r 1

2007-04-11 09:06:56 · 5 answers · asked by cbowles05 2

This is a c4 with crossfire engine. The problem always seems to occur when the engine is hot. The starter does not go round, brake warning lamp lights up when ignition key is turned, there are no sounds, headlights not influenced, starter just does not respond. Then, after the car has been sitting for an hour and a half or so, it comes back to life. Should anyone out there have the key to this starting problem, please let me know.

2007-04-11 08:09:38 · 12 answers · asked by Wildvette 1

For example, does a diesel engine need the oil changed every 3 months/3000 miles like a gasoline engine?

2007-04-11 01:32:47 · 6 answers · asked by an_articulate_soul 4