Chevrolet

My turn signal makes noises after I make my turn when it goes off.My signal light on the dash is off but you can hear it cliking still.It goes off but it seems to get stuck sometimes so I have to try shut the clicking noise off.I checked the lights with a friend and he said there was no turn signal on when I turned it off even when the clicking noise was there it was off when I shut it off and on when I turned it on it seems normal but the noise no what I,m sayin thanks.

2007-04-10 18:14:38 · 2 answers · asked by Anonymous

i need a stronger battery for my 2005 Chevy Aveo 5 LS dose anyone know what the biggest and best battery i could put in my aveo?

2007-04-10 17:40:44 · 4 answers · asked by Raven 2

the question i have is can the pump be turning and not leaking but not pump water??? i know the olden days (the good ole days) as long as the impeller was turning it would pump water! leaking seal is when it went bad,or locked up..like a box fan blade as long as it is turning its moving air...

2007-04-10 16:50:45 · 5 answers · asked by Anonymous

it does not smoke out the tail pipes and the pvc value is not stopped up but its got a lot of blow back and when ur goin down the road it will just spit oil out the dip stick

2007-04-10 16:06:06 · 6 answers · asked by thepope678 2

I need to be able to program the keyless remotes, I already replaced the batteries and they are ready to be programmed but I am unsure as to how to go about doing so, anything will help.. Thanks so much in advance.

2007-04-10 15:29:27 · 2 answers · asked by liz03 1

what do i do with a collant leak in a 1999 chevy blazer? how do i fix it? and or are there are pictorials that show the inside of the engine of a blazer that could help me figure out or an online haynes manual to help me out! thanks so much!!

2007-04-10 11:24:58 · 8 answers · asked by jeanettelynng 1

2007-04-10 09:46:57 · 9 answers · asked by jerry 1

2007-04-10 09:17:57 · 6 answers · asked by ben r 1

2007-04-10 07:26:51 · 9 answers · asked by Anonymous

ok.. heres the deal. my truck was working fine. one day, i hooked up some trailer lights. the next day my brake lights wouldnt work. i checked the bulbs (both) fuses, and the thing that makes then ground out under the dash. there all ok. what do i do?!?!?!?!?!

(91 chevy silverado 1500 5.7 350) I'm not sure that matters.

2007-04-09 20:09:38 · 3 answers · asked by Ebert S 1

2007-04-09 19:04:53 · 5 answers · asked by Austin B 1

My brother recently purchased a 1984 El Camino and i want to find out how can i tell if its a true super sport. It has a decal in the back that says super sport but it just looks like a decal someone just put there.

2007-04-09 19:03:44 · 6 answers · asked by *yeska* 2

The new Camaro is set to be released as a 2009 model. What do you all think about the styling of this car? I'm not referring to engine performance, price, or anything other than how it looks.

2007-04-09 18:25:31 · 17 answers · asked by businessgrad2007 2

2007-04-09 17:37:14 · 2 answers · asked by Anonymous

bored 60 over/ my cam is one step above RV towin cam/ new crank from cloyes/ cast iron vorteck heads/ rpm airgap intake/ holley street avenger carb 670 i think?/ comp cam rods and roller rockers/ what do u think?

2007-04-09 13:39:18 · 8 answers · asked by Anonymous

2007-04-09 11:03:16 · 1 answers · asked by MELANIE J 1

Thanks for all your help. It's a 2001 and I accidentally dropped a pop cap down the vent when it was open. I fear that it will damage my car

2007-04-09 08:21:01 · 5 answers · asked by Dan 1

I was stopped at a light the other day and my car died. Hasnt started since. it has 60, 000 miles on it was running fine up until it took a crap. So far I know i am getting spark, I can hear the fuel pump when i turn the key, its not the starter or the battery. I sprayed some started fluid in the intake duct and it started for a moment then shut off again. So its a fuel problem right? Anyone have any ideas????

2007-04-09 08:20:55 · 8 answers · asked by mark t 1

I have a 1987 z-28, and I just had the front rotor's and brake's changed. Now, It is grabbing after I press the brake. After a couple minutes, they realease. Any suggestions?

2007-04-08 16:32:58 · 4 answers · asked by Shaun S 1

2007-04-08 15:25:17 · 7 answers · asked by michael B 1

No turn signals or e-flashers. Suspect the flasher relay, but can't find it.

2007-04-08 06:11:57 · 6 answers · asked by Searching 1

Speedometer fluctuates to maximum and back to zero with complete power loss (but lights still work) while in motion and sometimes stopped; at times indicator jumps back and forth only slightly while key is turned on or engine still running. Have replaced speed sensor and cleaned ground. The problem is very erratic and comes with no notice at any tiem. No solution yet

2007-04-08 06:10:21 · 3 answers · asked by jibal 1

2007-04-08 05:28:55 · 6 answers · asked by tparedes1964 1

I think my car may have a loose vacuum hose. Whenever I'm at a stop with my foot on the brake pedal, the car vibrates. Then when I accelerate, it goes away. But sometimes there is no vibration at all. It's on & off. If there is a loose hose, will it correct itself on it's own without adjusting it?

2007-04-08 05:21:09 · 2 answers · asked by Anonymous

I want to swap the engine on my 96 S-10 but i want to know if i can put a 350 engine into it.

2007-04-08 04:01:16 · 12 answers · asked by Josh m 1

good spark from coil to dist.-replaced dist cap-rotor-electronic module-pickup coil- whats left ?????

2007-04-08 02:09:40 · 6 answers · asked by banjo5 1

i did oil change 3 months ago problem seemedto go away, oilwas very dirty. Now problem is back,did another oil change wont go away,sounds like a tank ,any answers.

2007-04-07 17:27:09 · 11 answers · asked by JG 1

i have a 1994 chevy s10 blazer 4x4... i was wondering how hard it is to put in a automatic transmission, and do i need a lift to put it in? and if its possible, what are the steps... i have the new trans. i just wanna save some $$$... i know a little about transmissions, but not bout taking one out, and replacing it..... any help would be appreciated.. thanks...

2007-04-07 14:44:24 · 10 answers · asked by fisherkid13 1

They can be the original type but ... anything that fits will be ok. I need at least 2 ....

2007-04-07 10:44:04 · 6 answers · asked by burlingtony 2

I want to find where it is so i can mod it to give better reception. does any one know where it might be located or at least the antenna in jack.

2007-04-07 09:50:32 · 3 answers · asked by Yahoo! User 4