recently looks as if new circuit breaker panel was installed, i can see both hot wires , ground and neutral all hooked to panel but no ground wire to outlets so i am assuming the conduit acts as a ground instead, the problem is i cant see where ground wire is going to in wall to see where it ends up and the wire on water meter also, is there a way to check to see if my ground is good comming into panel or any ideas how i go about getting a proper ground, this house was built in 1960 and has 3 prong outlets already.
2007-08-01
23:56:25
·
7 answers
·
asked by
tlfranklin61
1
in
Maintenance & Repairs