the belt that drives the beater bar keeps falling off its pin. I have to keep unscrewing the whole bottom of the chassis and putting the belt back on the pin. I think there should have been a flange on the end of the pin to hold the belt on, but we bought the vaccum brand new, and there isn't one. The drive belt itself isn't warped and seems to run properly, but then it just slips off for no apparent reason. Has anyone else had this problem? The vacuum isn't (of course!) under warranty any more, it's about three years old.
2006-12-13
10:07:45
·
2 answers
·
asked by
sekhtet
3
in
Maintenance & Repairs