Maintenance & Repairs - April 2007

dose it manle when it is warmed up but will die out also at a idel if you stomp on the gas to quick

2007-04-29 11:19:05 · 6 answers · asked by lala4988 1

2007-04-29 11:19:03 · 1 answers · asked by Anonymous

2007-04-29 11:14:02 · 17 answers · asked by ingram 1

Should I use a synthetic engine oil for my 2004 MX-5 Mazdaspeed? If so, what type and if not, what should I use? Car manual says 5-30 or 10-30 and to use oils that have a particular seal.

2007-04-29 11:08:11 · 4 answers · asked by alicebeaching 2

2007-04-29 11:03:19 · 8 answers · asked by Anonymous

The fuses are ok, I check allready.It has swhitches on the sterring weel and other at the left side of driver by the console .Maybe I'm not operating them the rigt way ? please let see who have any knowledge on this case rigt here.Please explain why it has cruise control switches in two different places and why they don't work? I bougt the car like that so I don't know what happend to beging with.

2007-04-29 11:00:06 · 2 answers · asked by Anonymous

2007-04-29 10:40:54 · 11 answers · asked by Grafton C 1

I live in Oklahoma. I'm looking for a place that won't try to over charge you. I went to a jaguar dealer in texas. and it was crazy what they wanted just to program the fob.

2007-04-29 10:32:30 · 4 answers · asked by tina b 1

2007-04-29 10:15:36 · 3 answers · asked by sembrom 1

1995 Chevy Cavalier.
Hello...I'm trying to repair a car that hasn't been running in about a year, I've replaced so far the cylinoid, starter, and timing chain. I am now able to start the car ONLY by crossing over the starter. Car will not start by turning the key. I'm completely lost on this one, Anyone out there have any ideas what could be the problem??? I certainly would appreciate the help...

2007-04-29 09:47:52 · 7 answers · asked by Anonymous

1996 impala ss died yesterday on the road, then it wouldnt start just cranked. today got it started after a few tries but when i pushed the gas it would die.

2007-04-29 09:46:21 · 8 answers · asked by Jay 1

2007-04-29 09:26:17 · 2 answers · asked by Anonymous

Any courses, internships, etc?

2007-04-29 09:24:36 · 4 answers · asked by Z car lover 1

the hose that comes out of the bottom of the radiator and into the water pump is leaking, there are no holes in it, i have drained the radiator and took the clamp off and slid the hose all the way up and re tightened the clamp re filled the radiator, and it still leaks out of the top of the hose

2007-04-29 08:56:53 · 2 answers · asked by trivium332 2

2007-04-29 08:54:45 · 34 answers · asked by Anonymous

2007-04-29 08:53:46 · 6 answers · asked by learch56201 1

i drive a 91 ford escort gt. ive been monitoring the rpms recently and realized that when i turn my head lights on my rpms rise about a grand. does anyone know why?

my car also dies a lot. theres a new battery, the alternator is good yet after starting about three times, it wont stop or the lights wil dim and turn off while driving. any help please?

2007-04-29 08:19:30 · 5 answers · asked by jimbogatu 1

2002 Honda Accord LX V6 with ABS brake system. Took the car to midas for a regular brake pad change after squealers were heard. Right after I got my car back, the brake pedal suddenly felt soft, and if I pushed with a little extra force, the pedal hit the floor. So after bleeding the brakes, Midas said it was a leak in the master cylinder and it was coincidental. After a little arguing, I got them to replace the master cylinder at no charge. However, the pedal feels a little better, but it's still extremely soft. Again, with a little extra force, I could push the pedal until it almost hits the floor. What else could it be? This has been hell. All I initially went for was a routine brake pad change.

2007-04-29 08:19:22 · 4 answers · asked by cali_brazil 1

I have a 96 Ford Taurus GL. Changeing my rear brakes and Someone told me to use needle noses to turn the piston to compress and that isnt working, its just turning and not compressing. C clamp doesnt work. What can I do?

2007-04-29 08:01:24 · 6 answers · asked by Anonymous

Help, Van trouble losing power and backfiring? any suggestions.

2007-04-29 07:53:34 · 4 answers · asked by Anonymous

Could it be something other than the fuel tank

2007-04-29 07:52:01 · 4 answers · asked by saltyboss 1

did test on alternator and it passed, the battery is good it passed, got new terminals but guy said it needs new battery wires. I can jump my car drive it somewhere turn it off and turn it on and it works but if i leave it sit for more than 2 or 3 hours it dies and i have to be jumped again.

2007-04-29 07:39:46 · 4 answers · asked by blueyes_69_49092 1

The lip of my car engine hood has a slight upwards dent. I'm wondering if I gently hammer it to smooth it out... good or bad idea? I don't want to make it worse. The dent was caused when a friend tried to pry my headlight area off to change a headlight. To get a good grip, a screwdriver was inserted between the lip of my hood and the top of the headlight area. Unfortunately, the lip of my hood was slightly dented upwards. It's solid metal, not fiberglass. Any suggestions?

2007-04-29 07:37:01 · 6 answers · asked by ABCD 1

it moves after a few moments but then the same thing when i hit second gear is it my tranny? or my clutch?

2007-04-29 07:19:13 · 12 answers · asked by dunkinkitty4c 1

Back in November I took my car in for several repairs. Since then the guy has asked me for more money twice over and I still don't have my car back. Am I being ripped off?

2007-04-29 07:19:02 · 4 answers · asked by Avatar 4

2007-04-29 06:59:44 · 2 answers · asked by Anonymous

2007-04-29 06:57:21 · 5 answers · asked by Anonymous

Someone Stole My Gator And Took It On A Joy Ride. When I Got It Back The Ignition Was Missing And I Have No Idea Where The 5 Wires Go.

2007-04-29 06:51:21 · 3 answers · asked by Gilbert R 1

and when i how the gas down sometimes the car shakes while im moving backwards

2007-04-29 06:50:48 · 5 answers · asked by quaqua88 1

it is a '95 plymouth grand voyager. also, if i do, how do i do it, or where can i find steps on how to do it (disconnect airbags)?

2007-04-29 06:49:52 · 7 answers · asked by Anonymous