Maintenance & Repairs - February 2007

2007-02-10 15:30:32 · 2 answers · asked by Bobbie B 1

for a 216 engine, straight 6 cylender,gm motor

2007-02-10 15:24:22 · 4 answers · asked by salvador r 1

it has the original v6 3.8 mototer in it

2007-02-10 15:22:58 · 4 answers · asked by hsi_fu_nistal 1

2007-02-10 14:53:50 · 2 answers · asked by wudsman_234 1

A friend of mine parks his car on the street. A couple of nights ago, a watermain broke and coated his car in water. It's really cold here so it froze quickly and just began piling up. Now his car is covered in about a half-inch of ice. Including the wheels which are stuck in about two to three inches.
It looks like a glazed donut.
I suggested (after I stopped laughing) he wait until spring thaw.
Any other ideas? Besides ones involving a blowtorch or a hairdryer and a 300 ft. extension cord?

2007-02-10 14:51:43 · 12 answers · asked by buzzzard 3

2007-02-10 14:51:11 · 1 answers · asked by Gustavo R 1

when my car is cold it just when stay running it idles very roughly and doesn't have a high enough idle the choke wont close completely as it should how can i adjust this so it will idle a bit higher and so the choke will work properly is theres any sites or manuals online or if u just no plz help me

2007-02-10 14:47:06 · 2 answers · asked by Anonymous

2007-02-10 14:47:04 · 4 answers · asked by psychoemet 1

I have a 98 Taurus Se and rove it from a friends house to the grocery store(10 minute drive) and it ran fine. Came out of the grocery store and the car could barely stay running. It is barely idling....very choppy and well below 1000...normally it idles at almost 2000. I drove it home as best I could...if I would let off the gas it would almost die again...but if I keep giving it gas it stays running somewhat....
What does it sound like is the problem? TPS?

2007-02-10 14:45:33 · 8 answers · asked by Anonymous

2007-02-10 14:41:16 · 8 answers · asked by P.H. 1

Truck has 160K, was wondering if I need to replace or repack>?
Many thanks!!!!

2007-02-10 14:35:57 · 6 answers · asked by wwookiee 1

My ac/heat blower does not work on the lowest two settings and I think it is my resistor. How do I get to it and change it..and what exactly will it look like so I will know what I'm looking for.

2007-02-10 14:35:11 · 7 answers · asked by car_lover_42020 2

Engine coolant is from a 2003 Subaru Forester with 60,000 miles.

2007-02-10 14:26:49 · 7 answers · asked by tashley235 3

I have a 1997 Plymouth Neon. When I come to a complete stop the RPMs go down to 500 then most of the time it stutters then goes back up to 1000 RPMs. Sometimes it will die. If I give it gas while in park it helps it go back up or not stop. IT DOES NOT STALL ALL THE TIME. I had a tune up done to it, O2 sensor replaced, an oil leak fixed, and a fuel injection clean up done already. But it still doing this??? Anyone have any other ideas what could be causing it to idle rough????

2007-02-10 14:24:21 · 9 answers · asked by Valerie D 1

Car is a 1992 Dodge Daytona. Drove it for 1.5 hours right after getting new battery. Then left it for 4 hours in a parking lot. Battery and alternator gauge in car look fine.

2007-02-10 14:05:25 · 7 answers · asked by Anonymous

2007-02-10 14:05:18 · 9 answers · asked by kyle s 1

i'm searching for a car.. and extremely cheap car that requires no work at all...and theres this care i have in mind that needs a motor mount.. what is a motor mount, wat does it do, and wheres it located, and how much wud it cost to get one or even replace it?

2007-02-10 13:56:41 · 9 answers · asked by ETay89 3

2007-02-10 13:49:37 · 8 answers · asked by mg5312000 1

ok so i was looking on ebay and i see this think called a velocity tuner and another one called a vortex generator. now they say they help get better gas mileage and i was wondering if they really work. and there were also theese things called a magnetic ionizer that you put on your fuel line and it also says it adds gas mileage i was wondering if they would be work buying or is it just a load of bull? thanks

2007-02-10 13:43:12 · 5 answers · asked by Anonymous

2007-02-10 13:30:34 · 3 answers · asked by Anonymous

I had the car into be serviced in october and they topped off the collant with the other stuff - but my owner manual reallly states to use dex-cool Only. This week I had a problem with it over heating and now the same garage says I need to spend $250 on a manifold gasket repair job.

2007-02-10 13:25:05 · 3 answers · asked by grannym 1

if they do, how often should it be changed?

2007-02-10 13:16:09 · 16 answers · asked by b3nsonx 2

My boyfriend want to have a keyless remote entry installed in a '96 RT 10 Viper. Can it be done and if so how much will it cost?

2007-02-10 13:08:55 · 5 answers · asked by Anonymous

I want to put a hitch on my car so I can pull a trailer. I went to Uhaul's site, but the page fails to load.
(If you can get it to load for you:
1998 Ford contour )
I want to put my make and model in and have it return the exact hitch that I need.
It is a passenger car

2007-02-10 13:02:35 · 2 answers · asked by There you are∫ 6

im removing all the dents on my car to prep it for a new paint job(which i am going to do).

i've got "everything" i need for the whole thing.

i just want some tips, hints, or advice so that this thing comes out great.

just throw me any advice or tips or anything.

thanks

2007-02-10 13:02:33 · 11 answers · asked by Anonymous

G.E. A/C motor model # 5kh45k822

2007-02-10 12:57:42 · 1 answers · asked by Andy N 1

I have a GMC S15 jimmy the left turn signal stays on when I turn the parking lights on but it does not blink or anything including if I hit the brakes. The right side works just fine, any thoughts on this, I have taken it to a shop and they fixed it but then all of a sudden it started doing it again later that night, HELP

2007-02-10 12:52:47 · 5 answers · asked by bigbearcb 1

thang BACK TOGETHER FOR IT TO WORK

=( ANYONE CAN GIVE ME SIMPLE DIRECTIONS TO THIS SIMPLE PROBLEM.

I WOULD GREATLY APPRECIATE IT!!!!! thanx-tahoe driver

2007-02-10 12:50:01 · 2 answers · asked by Mz Laudah 907 2

2007-02-10 12:36:46 · 2 answers · asked by FIREMAN_911 2

when installing cross drilled rotors, which way does the hole pattern turn? I got no instructions from the rotors I bought. Does it really matter with way the hole pattern rotates?

thanks

2007-02-10 12:34:01 · 7 answers · asked by Dennis C 1