Maintenance & Repairs - November 2006

drove 80 miles on wrong firing order. fixed firing order , now wont start ? like not turning over ? any clues?

2006-11-18 02:32:59 · 7 answers · asked by theresa m 1

I have a 1982 Malibu wagon. The wipers stop working after about 30 minutes of ENGINE running time. I stress ENGINE because the wipers don't have to be running during this time. That is, I drive for 30 minutes, hit the mist or wiper switch and nothing happens.

Thanks,
Tony

2006-11-18 02:32:43 · 3 answers · asked by Tony P 1

can it be stoped byapplying a woman's hard nail polish to the knick if how do you apply. do apply it than wipe it off with a cloth or what do you do?

2006-11-18 02:32:08 · 5 answers · asked by FRANK C 1

2006-11-18 02:28:01 · 5 answers · asked by jonathan s 1

my firing order was not in its correct order and i had to still drive the car here and there .what kinda of damage could of or was done???

2006-11-18 02:12:40 · 3 answers · asked by theresa m 1

2006-11-18 02:08:08 · 3 answers · asked by jonathan s 1

2006-11-18 02:07:33 · 3 answers · asked by eyegub 3

What other tranny will fit in 1987 Cadillac,rear wheel drive with a factory 5.0 Olds engine and a 200 metric tranny. Would like to put in bigger tranny without changing alot of things. How about a 350 turbo from an Oldsmobile? Kinda stupid to put a small tranny into a big car like Cadillac did from the factory.

2006-11-18 02:05:58 · 4 answers · asked by Anonymous

Basically i'm after 2 x 2" steel end caps and a 7/16” threaded rod with two 7/16” nuts and washers. I haven't got a clue where to get them. Grateful for any help

2006-11-18 02:01:16 · 9 answers · asked by Anonymous

.they say its something other than the extra oil that is the problem but i think they are palming me off.it has just had the engine done as cambelt went and blew the engine and valves.what could be the problem know?

2006-11-18 01:48:55 · 3 answers · asked by l_oatley 1

When the enging is idling its at .5 rpms then goes up to 1 rpms. That happens in about one second. Makes a funny sound also. 2002 Mitshubishi Galant. Original problem was a bad timing belt I think. Thanks

2006-11-18 01:32:21 · 6 answers · asked by Ron54r74 1

my car was being repaired i only had the car for 3 hours there was already a mark on the door the dealer said he was in a rush and had already checked for damage. he phoned later to say i had scratched the bumper. i know for sure i didnt but as i signed for the car im resposnible and the insurance excess is £375! how do i know it wasnt damaged after i dropped it off? any advise on what to do?

2006-11-18 00:23:22 · 13 answers · asked by hellinbear 2

2006-11-18 00:22:20 · 5 answers · asked by eric c 1

2006-11-17 23:53:08 · 5 answers · asked by Anonymous

I need a list of required components (preferably cheaplyl sourced) and tools required. Also any changes that will need to be made to the bike and the motor used. I'm a fast learner and want to try it but I have no technical knowledge. I want a pollution free transport method but I can't afford to buy an expensive new one (cost over GBP500!). Based in UK.

2006-11-17 23:18:19 · 3 answers · asked by Henry R 2

van wont start i need to find out what the code it is flashing meens.

2006-11-17 22:48:09 · 3 answers · asked by JKL 1

I have a 1991 Caprice that my father has given to me the car looks like new however, It has way too much power and I have gotten 14 speeding tickets in the last 2 months driving the car. it goes over 130 mph at only a quarter throttle!. How do I make the car have less power? I want it to run much slower than it does now. Any segestions out there??? the car has a 350 multi port fuel injection system with a turbo charger.If I cant get this car fixed soon I will have to give it away just to stay out of trouble!!!

2006-11-17 22:18:12 · 11 answers · asked by Lots of money but no sense 2

ran a 600 holly then a carter thurmo quad har the same resault run ok not great on heigh to mediam reves then when idoling down starts to shake and pop then booom with the fireball and a little afterburn and will not start till u pore fule down the barrel i have changed the roter and dissy and checked the rockers and valve stems all ok any help will be very helpful. ps. its a 302 clevo.

2006-11-17 21:49:15 · 8 answers · asked by Anonymous

Vauxhall Omega 2.5 V6 oil cooler failure in coolant system.

2006-11-17 19:33:55 · 14 answers · asked by Anonymous

I have a 2004 Chevy classic that i am haveing problems figureing out how to change the headlight on. If anyone can please help me I would appreciate it.

2006-11-17 19:33:21 · 3 answers · asked by smurfettelilblue 1

2006-11-17 19:30:05 · 3 answers · asked by feel_n_learn 3

I'm looking into buying a Mercedes from the years 1969-1979. If it's been sitting in a garage out of the elements, would it really need alot of work to maintain after all these years?

2006-11-17 17:52:31 · 8 answers · asked by Alexandra F 1

I just acquired one and i need some help using it, can someone explain it please?

2006-11-17 17:41:49 · 2 answers · asked by Anonymous

2006-11-17 17:29:04 · 6 answers · asked by BAMA G 1

We have a 2000 Ford Explorer, the other day we went to start it and it would turn on and right back off again, it hasn't stayed on since then and I can't afford a mechanic right now, does anyone know what the problem might be?

2006-11-17 16:59:43 · 7 answers · asked by eviegreenco 2

2006-11-17 16:40:01 · 4 answers · asked by Anonymous

It's a '99 Subaru Outback Legacy Limited 30th Anniversary
I live in a snow belt in the Northeast.

2006-11-17 16:14:21 · 16 answers · asked by answerb4midnight 3

2006-11-17 15:39:21 · 14 answers · asked by Simit S 1

I have a 1995 Ford Windstar, in 2000 I had a rebuilt transmission installed for a broken piston and here we are 74,000 kms later and we need another transmission for the same thing. I E mailed Ford and asked them to help out as I don't feel that we should have to pay twice for the same thing. This van has a total of 206,000 or 123,000 mi. approx. Any suggestions?

2006-11-17 15:26:47 · 3 answers · asked by friar tupper 1

The car turns over but wont start. It gets gas no spark. I have replaced the following: ignition switch, cam sensor, cam interupter, crank sensor, ecm, coils, ignition module. I have checked every fuse even the ones behinde the glove compartment. Can't think of anytrhing else. I have checked the compression and i have good compression. I have no more ideas how about u!

2006-11-17 15:14:11 · 4 answers · asked by wired4lyfe07 1