Maintenance & Repairs - August 2006

ive just replaced a headlight cluster and need to re align them.

2006-08-29 23:54:44 · 8 answers · asked by the little ninja 3

2006-08-29 23:52:53 · 5 answers · asked by racer1couple 1

I fixed a known problems with the fuel pump connector under the driver seat, and it seem to work for a while but then it began to do it again.


Here are the details,

1. no PCM codes, at the beging it had a code for the evaporator system but after fixing the connector problem it went away.
2. Start up, get going and a while later, most of the time after it is warm it starts to sputer and the RPM goes erratic and some times it even dies. It almost acts like when you run out of gas!!!
3. Some times it happens when you try to punch the gas and go fast, other times it does it even if you are nice to it.

Please help!!!!!!

2006-08-29 23:45:22 · 5 answers · asked by F R 1

2006-08-29 23:42:52 · 11 answers · asked by aditya7250 1

2006-08-29 23:34:13 · 4 answers · asked by niti 1

2006-08-29 23:21:39 · 3 answers · asked by Anonymous

i just does clicking noises its a dogde neon

2006-08-29 23:07:29 · 8 answers · asked by Sherry I 1

I'm looking at buying one soon, Just want to know anything about them, Tranny, or outher problems, thank you.

2006-08-29 23:01:51 · 3 answers · asked by Anonymous

how to increase ampereage from 12 volts automotive batteries?

2006-08-29 22:55:07 · 6 answers · asked by vishu s 1

does anyone know if there is any other automatic trans will fit on a h23a1?

2006-08-29 22:51:52 · 1 answers · asked by Mike E 1

If I sustain speed of 130mph for more that a few seconds (5-10) I loose my power steering. Also if I reach 150+ even for an instant the same occours. Ocasionally the power steering will start working again but most of the time not until the car has set (not running ) for at least 20 min. I have no water in the pump, have not changed pulley sizes, and the pump does not cavitate.

2006-08-29 22:25:55 · 7 answers · asked by wzzrd 5

Also, how much would you buy a car in that condition for?

2006-08-29 21:04:55 · 19 answers · asked by Adam 1

2006-08-29 21:00:07 · 16 answers · asked by grey_wolf54486 3

2006-08-29 20:39:21 · 4 answers · asked by Angel C 1

I've got a Toyota Corollo 1.3 1991, which I've had for about a month.

The car's great, but it consumes way more oil than what's normal. I've checked it for leakage – no oil on the ground.

I admit I know next to nothing about car's, but I sure do know one thing: repairs are expensive.

So, before turning my car in to a garage, I'm asking you guys: What could be wrong?

2006-08-29 19:52:09 · 9 answers · asked by Anonymous

i want to noe what is needes to be changed when u convert a car to using lpg, also what are the parts required.

2006-08-29 19:41:35 · 3 answers · asked by {««мα∂gυу»»} 2

my car also makes this crackling noise when I start it, I'm taking it to the mechanic trow, how much will it cost?

2006-08-29 19:32:35 · 2 answers · asked by KC 2

2006-08-29 19:03:10 · 9 answers · asked by Anonymous

2006-08-29 18:47:00 · 3 answers · asked by OSCAR L A 1

My battery light came on while driving and I read around that it is most likely that my alternator is going bad, already bad or the battery is bad. I am going to go to Auto Zone tomorrow and have them do a voltage reading, over the battery and the alternator itself and also see if they can hear if the bearings inside the alternatnor need to be fixed. (I read that if they are making a metallic noise that's what needs to be done and I think that would be cheaper than having to buy a whole new or refurbished one).
Getting on to the question. I wanted to know where abouts the alternator is located on my 2000 Plymouth Neon in order to take a look and a listen myself. Also I wanted to know if it was possible if I got a step by step instruction of how to replace the alternator if need be if I could just do it myself being a person who knows nothing about cars. Does it take special tools and a lot of work and muscle (I am a small female)?
I hope that the question made sense...

2006-08-29 18:35:03 · 9 answers · asked by Anonymous

2006-08-29 18:33:17 · 9 answers · asked by oreohenry1@sbcglobal.net 1

2006-08-29 17:37:34 · 9 answers · asked by tobagononny 1

I have a 1984 Toyota Liteace van, the front bearing has crushed and I need to know how to take of the brake calliber and get the bearing off, I am doing this with a jack. II do not want the whole thing to fall down or apart. Please help me!

2006-08-29 17:30:31 · 1 answers · asked by maddmummy 2

need to replace crank seal cant get to it dempener came off with puller easy. gear that timing belt runs on wont budge.

2006-08-29 17:21:06 · 4 answers · asked by kates1977 1

Brand new 1776cc engine. 009 distributor. Replaced points with electronic module. New wires, plugs, and coil. Cap and rotor have about 6 hours of run time on them.

2006-08-29 17:12:28 · 8 answers · asked by thbigleg 1

if so how often? and do you need to change the filter too?

2006-08-29 17:09:22 · 7 answers · asked by entalee 2

so it usually takes 3 to 4 cranks to start my car i have a new starter... any suggestions

2006-08-29 17:04:08 · 14 answers · asked by alex v 1

2006-08-29 16:59:03 · 10 answers · asked by crazy8s622 2

I already know PV=nRT, and how to calculate the gas ratios, stoichiometry of the moles of liquid --> gas, the increase in air pressure, and the (pie)(r)^2 Area of the piston. How much gasoline is squirted into each cylinder/stroke ???

2006-08-29 16:51:43 · 7 answers · asked by SmartoGuy 3

2006-08-29 16:46:38 · 2 answers · asked by Anonymous