OK, so after two great range trips and 1000 rounds or so I decided it was time to strip and clean my new Mark III. This is a 5.5" bull-barrel model. I sat down with the user manual and started along...
Step 1 says to cock the gun, insert an empty mag, and pull the trigger to uncock the gun. Then, one is to remove the magazine.
Done.
Step 2 says to open the mainspring housing latch. No problem there.
Step 3 says to swing the mainspring housing down and pull it out, including the bolt stop pin. I had to tap out the bolt stip pin with a mallet and dowel, but done and smooth going.
Step 4 says to insert an empty mag, point the gun up, and pull the trigger...and the bolt will fall out...not good here....pulled the trigger, heard nothing...and now the bolt will only go rearward about half an inch. It does not want to come out. Reinstalling the mainspring housing does nothing to change the situation.
What did I miss, and what should I do next? This is a brand-new gun...
2007-11-01
16:20:24
·
5 answers
·
asked by
strangefrogg
3