Ford

i know its factory rated at 305 hp, but has anyone ever seen a dyno chart of this car ?

2006-10-11 14:57:58 · 5 answers · asked by no 1

I'm in the market for a new vehicle and am hoping to find out which companies (specifically interested in Toyota, Chevy and Ford) typically have the best incentives and when? Should I hold off now and wait until late December to save money on a brand new 2006?

2006-10-11 13:55:41 · 10 answers · asked by BugsySkybone 3

have checked the dip stick spider gears in rear end transfer case fluid vacum lines and still doesnt run

2006-10-11 12:50:32 · 7 answers · asked by Pearl M 1

I just bought a 2003 Ford Crown VIctoria P71 (Police Interceptor edition) and I need the lower ball joints replaced, and one of the upper ball joints replaced.

No one seems to know where I can find some after market parts for this.

What mechanics are telling me is that Ford stopped making just the ball joints and now I have to buy the entire control arm for the parts I need.

My control arms are good, is it possible just to replace the ball joints if I found a place that had them available?

And if so where could I find them?

So far the quotes I have range from 900 to 1020.08 with $693.00 going toward the control arms.

I am assuming that just getting the two lower ball joints and the one upper ball joint is cheaper than paying for control arms that I dont need.

Also, for the Police Interceptor I was told that the Upper ball joints I could use just the regular Crown Victoria parts but for the Lower Ball joints I need more expensive heavy duty parts.
Is that true?

2006-10-11 12:49:05 · 9 answers · asked by Anonymous

2006-10-11 06:07:34 · 4 answers · asked by Anonymous

2006-10-11 03:22:42 · 14 answers · asked by Weston F 1

What would I need to put an AOD tranny in my sons 76 Granada. I know they are different than the C4 that is in the car,but an AOD out of a early 302 car should bolt right up to the 351 windsor engine in his Granada. That would sure make a difference in his highway gas mileage. I have an 88 Lincoln parts car with a good AOD but I understand the earlier ones were a little different

2006-10-10 18:26:30 · 5 answers · asked by fairlane66gta 3

...looks goofy with it's current tail lights? They seem a little big to me and kind of disproportional to the rest of the car.

2006-10-10 13:10:28 · 8 answers · asked by jdm 6

Ive heard that 289's and 302's heads are interchangable but I just wanted to make sure that heads from a 65 will fit a 70.

2006-10-10 11:46:17 · 5 answers · asked by Anonymous

2006-10-10 10:40:08 · 7 answers · asked by Anonymous

Tell me your fav ford model of the 60's and 70's more then one model is great!! thanks

2006-10-10 09:13:10 · 12 answers · asked by kane_rosebud 2

It's the green wire with yellow stripe that should be hot all the time and goes to fuse 1. The fuse is good, but the wire's not hot. I need a hot wire for memory on my CD PLayer.

2006-10-10 07:29:45 · 3 answers · asked by AWArulz 2

I have had all the glow plugs changed last year and the car has been recently serviced.

2006-10-10 03:16:45 · 14 answers · asked by spireman 1

cause i got higher distance readings on my escape compared to my nissan sentra super saloon also i only get 20-25mpg while my sister's escape can reach to about 27mpg - me driving, same routes, driving habits etc. - thanks for your answers...

2006-10-10 02:01:04 · 12 answers · asked by John Smith 2

2006-10-09 21:12:00 · 0 answers · asked by eject911 3

if you can get one... i think you can though

2006-10-09 14:13:06 · 9 answers · asked by Anonymous

eng changed from 289 auto to a built 351 w with a top loader body wheel house area front and rear have been cut and rolled and front seats have been switched out

2006-10-09 13:42:00 · 3 answers · asked by bondo_dean 1

2006-10-09 10:11:48 · 5 answers · asked by Anonymous

I've had my oil changed once, and was told I had too much oil in it to begin with, checked my oild level again about 2 weeks later and had about a quart too much again. Change it myself this time, and the same thing happened .

2006-10-09 09:37:34 · 11 answers · asked by Emu 1

2006-10-09 05:41:11 · 13 answers · asked by Anonymous

they are both pretty powerful but the contour has 200bhp while the probe has 164 also i think the contour looks better but is a lot more expensive, but i can still kind of-hopefully afford it... can i get some help wif dis issue????

2006-10-09 04:30:45 · 7 answers · asked by dean! 1

My car always breaks down. It always overheats, electronical problems, many many problems. Does anyone have this car and have the same problems? whyyyyyyyyyyyyyyyyyyyyyyyyyy

2006-10-08 20:53:29 · 8 answers · asked by Keith 2

The car Eleanor in Gone in 60 seconds. I was just wondering how many were made throughout the world.

2006-10-08 18:34:35 · 5 answers · asked by luckyarb 1

My Taurus could not start today. When I turned the key, I heard the crank( lasting for about 1 second), but shortly I heard some noise like "da da da da...". It sounded like coming from starter(but not 100% sure). Of course, I tried to jump it but did not work out. I am wondering what is the problem. Could it be a bad battery or bad starter(with bad gear)?

2006-10-08 18:15:30 · 8 answers · asked by Play 1

2006-10-08 17:13:35 · 5 answers · asked by zela3 1

there is a 114 gal propane tank in the bed. i reaks of propane and has more power than it does with regular unleaded gas. the gas milage also decreases by 50% so i get about 5mpg

2006-10-08 16:39:49 · 13 answers · asked by Anonymous

2006-10-08 15:50:08 · 8 answers · asked by meyers1211 1

We have to push really, REALLY hard on the brake pedal, and pull even harder to get it out of park. Getting it back into park is difficult as well, but once we get beyond that point, shifting between other gears is smooth. Anyone else having this problem? And if so, did you find a solution?

2006-10-08 15:15:33 · 8 answers · asked by Shayna 5

2006-10-08 12:08:13 · 4 answers · asked by articatatv 2

2006-10-08 10:01:07 · 9 answers · asked by DONNA M 4