It happens when i come to stop at a light or after i stop (for gas) and crusing down the highway it starts to cut off and i have to restart on road.
i know it is some sensor because i replaced: fuel pump-It was going bad as it turned out (no fuel pressure - not up to spec), TPS, Ign Coil, Coil, Idle Air Cntrol, rotor/distbtr, plug wires and air filter. It runs much better as these did need changing but, it still stalls. Seems to be no way to predict conditions that occur to cause the engine shutdown. I noticed the lights did go out once when it was about to stall.
I dont have enough $ to replace all the sensors and / or the EMT computer (unless you know that is what is wrong).
The van usually starts back up but sometimes with difficulty. Must turn off the key and try again to get it started. Otherwise, if I start cranking it then it doesnt fire up.
Who knows this problem or has anyone who had the same problem fixed it?
Email me at rrb6699@yahoo.com
thanks Ray
2007-12-15
03:10:48
·
3 answers
·
asked by
R/R B
1
in
Chrysler