Ford

2007-06-01 00:24:38 · 5 answers · asked by Ice 2

I have a Pontiac Sunfire and its slow. I was woundering if i bought a 2001 Ford Mustang V6 would i be alot happier? Or would it be alot faster than my Sunfire?

2007-05-31 18:37:32 · 6 answers · asked by Ryan C 2

AUTO

2007-05-31 15:30:19 · 4 answers · asked by valerie j 1

I need extended parking brake cables for a 1973 Ford F250 with a dana 60 rear, truck has a 4" lift kit in it and the stock brake cables i have do not reach...help!

2007-05-31 15:22:15 · 2 answers · asked by mkoodsi 2

Are there any structural, design, cosmetic, or mechanical differences between the two models?

2007-05-31 14:51:16 · 8 answers · asked by doosley10 2

Does anyone know what a 1965 Ford Mustang 289 engine was rated for Horsepower?

2007-05-31 10:12:19 · 4 answers · asked by The Rage 2

2007-05-31 10:00:48 · 3 answers · asked by Anonymous

2007-05-30 18:54:46 · 10 answers · asked by pleasant 3

i am going to put a brand new turbo kit in my ford focus zx5 and i was wondering if anyone new how much boost the engine can handle without forged pistons

2007-05-30 15:51:26 · 4 answers · asked by ken c 1

i am thinkin of buying 1 cause i like the car itself and its features is it legal to have a if so where can i buy 1

2007-05-30 14:29:48 · 12 answers · asked by Anonymous

On Saturday, I just had all four tie rods replaced, the transmission fluid flushed, the coolant flushed, the oil changed, the AC charged, and the serpentine belt replaced. All in all, it cost over $700, but now the major problem is that the car doesn't start sometimes. I try to start it and it just makes a single click noise. I wiggle the shifter (automatic) a little a couple of times and eventually it starts. However, it doesn't do this every time I try to start the car. It is hit or miss, sometimes even going days without any starting issues. Starter? Neutral Start Switch? Circuit Board? Any ideas as to what the problem really is before I spend a ton of money that may or may not fix the problem??

2007-05-30 14:19:47 · 23 answers · asked by socialwork2010 2

is there a plug or switch too make it on all the time?

2007-05-30 12:53:48 · 9 answers · asked by mike s 1

So...

I have a 97 Taurus GL that is having some alignment issues.

While driving, if I let go of the wheel it pulls left. We tried adjusting the alignment and it seemed to help, but not as much as I would like.

The front drivers side tire is wearing heavily to the inside of the tire. So much that it has about 1/4 inch of tread on the outside and is down to the steel on the inside. I imagine this has much to do with the alignment, and am going to replace the tire after we get the alignment correct. I just wanted to give as many details as I could.

But, THIS is the main issue...

The car has a tendency to shimmy as well. It doesn't seem to be affected by the adjustment we made to the alignment.

The previous owner had hit a parked car on the passenger side. Though there are no signs of damage to the frame, and the impact looks like wasn't much more than 5-10 mph.

Could the shimmy be from the tires wearing unevenly? or is it most likely something deeper?

2007-05-30 11:51:02 · 2 answers · asked by Bjorn 7

I have a 93 crown vic, it is reving high when i hit 30mph and will not kick back down. If it sits overnight and I go out in the morning then it is fine, until I reach 30mph. We have changed the Throttle position sensor, check for vacumm leaks and also check the kick down cable. We are lost.
Any one have any ideas it would be greatly appreciated.
Thank you

2007-05-30 11:38:43 · 4 answers · asked by dribbles777 1

2007-05-30 06:07:33 · 36 answers · asked by Cliveus 3

I Have a Ranger with a 3.0 liter V6 and its passed inspection and at very high rpm's the makes a clicking noise, the only thing i can discripe it as a spark plug wire arching. But i just put in brand new wires and plugs. I dont know if this helps but its a 4wheel drive with 41,000 miles and a Aem short ram intake. and its never abused

2007-05-30 02:18:57 · 6 answers · asked by Katie 5

I have a 92 F-150 with the 302 V8. I was wondering if I could safely cut out 4 cylinders by removing spark plug wires and disconnecting injectors. I don't care the lack of accelaration this would cause, I do a lot of freeway driving anyways. I have been working on cars forever, and have gone to school for it as well. But I have never done anything like this or seen it. I don't see any problems that would arise from it. Because there are 8 cylinders and two are always working together, you just need to cut out half and make a 4 cylinder. Has anybody seen this. There are new cars which cut out 4 when not needed, but this way is a little different. Any input??

2007-05-29 16:34:23 · 9 answers · asked by Vince 2

I have a 2002 F250 crewcab (7.3 L turbo)diesel 4x4. I will be towing a 30ft travel trailer with double axles. I recently purchased a prodigy brake controller for the truck. Is this enough truck to handle the trailer? Is there a website that answers these types of questions? Any help would be greatly appreciated. Thanks!

2007-05-29 14:56:56 · 6 answers · asked by leerwilson64 1

Have any long term problems (10,000 plus miles) appeard on the Ford Fusion line yet? I'm looking to buy one but am worried about long term use and typical Ford problems (tranny, drive shaft, engine, ect ect)

2007-05-29 12:18:39 · 7 answers · asked by tha_g_child_2000 2

2007-05-29 07:51:26 · 5 answers · asked by Choppygutz 2

2007-05-29 01:52:27 · 3 answers · asked by cooldog37 1

Took it to Auto Zone and the OBD Trouble Code is P0402 - Exhaust Gas Recirculation flow Excessive Detected? anyone got an idea on a cure for the problem, that and I guess with the trouble code it won't read whatever they read to pass emissions - at leats that is how it was explained to me?

2007-05-29 00:26:51 · 2 answers · asked by Sean S 1

2007-05-28 18:07:48 · 5 answers · asked by timothyldraughon 1

thank you

2007-05-28 17:28:15 · 6 answers · asked by homero m 2

i already have:
underdrive pully's
CAI
SCT II Tuned
3.73 gear in the rear end

2007-05-28 16:44:54 · 10 answers · asked by BLACKonBLACKSTANG 1

Wanting to put on lambo doors , can't do this if it has an inner fender Thanks for your help

2007-05-28 15:25:48 · 1 answers · asked by Heather M 3

2007-05-28 15:14:22 · 6 answers · asked by dnlyrbrgh13 1

anyone know of a website that could help me diagnose a problem with my ford taurus..thanks

2007-05-28 15:13:24 · 7 answers · asked by radley1009 1

does max use more gas?
is max a colder temp. or a higher fan speed

2007-05-28 14:51:11 · 9 answers · asked by Ahmed Abdul-Wahab 2

2007-05-28 14:03:32 · 7 answers · asked by Anonymous