Ford

The truck has 315,000 miles on it but doesn't burn excessive oil. It has been well maintained. The brake peddle was soft and sometimes leaked down slowly before it got too hard to push with one foot. I replaced the vacumn pump but it is still too hard. What else should I do? It is a good truck and I would really like to get it going again. Thanks for any help you can give. Bill

2006-08-25 10:52:22 · 8 answers · asked by nimitmai 1

2006-08-25 08:42:51 · 13 answers · asked by Kenneth T 1

2006-08-25 08:24:06 · 4 answers · asked by Rodeo, W.J. R 1

How can I know which side of a muffler is the inlet and outlet?

2006-08-25 08:23:50 · 9 answers · asked by kool_ghee 1

I had a 91 mustang LX 2.3. I ripped the fuel injected engine and tranny out and replaced em with an old carb'd 302 and tranny circa 1972. mechanically everything works, but this being the first time i did a project like this, I didnt pay as much attention as i should have to the electrical system, and sensors. None of the gauges register, including the speedometer & tachometer. will things like the oil pressure sensor, etc work on an older engine like this or would i be better off wiring them directly? Also, where would the speedometer and tach hook up on a 91? to the tranny maybe?

thanks

2006-08-25 08:12:59 · 9 answers · asked by Anonymous

2006-08-25 05:52:09 · 3 answers · asked by maotlw 1

Hi,

I want to install a set flowmaster exhausts on my Crown Vic. I know the passenger side uses the dimensions Offset Inlet / Center Outlet. And I guess the driver side uses Opposite Side Offset Inlet / Center Outlet, if thats what that measurement is called. Does anyone know if I can use Offset Inlet / Center Outlet for the driver's side if I overturn the muffler? Is it ok to install it overturned?

I need to know because I don't want to purchase from the local shop. They are charging a fortune. On eBay they're cheap.

Any suggestions would help.

Thanks.

George.

2006-08-25 03:24:44 · 6 answers · asked by kool_ghee 1

fuel problem

2006-08-25 03:04:00 · 6 answers · asked by Anonymous

2006-08-24 16:16:07 · 13 answers · asked by chris barnes d 1

ok here goes..The van wouldn't start. the power windows and locks and all lights didn't work at this point. I replaced the battery, battery cables, starter, and the ignition assembly. Now the van runs, but I have no headlights/running lights, dash lights, interior lights, turnsignal/hazzard lights, radio, door locks, or odometer. The speedometer has a needle, but the odometer is digital and neither work. I have pulled and checked every fuse in the entire van and they were all fine. When i start the van all of the typical warning lights on the dash come on like they are supposed to, but no dash lights after that. Any idea where to look to find my problem?

2006-08-24 16:10:49 · 10 answers · asked by Itu 2

2006-08-24 12:18:59 · 16 answers · asked by Anonymous

In idle the car runs at 2 rpms. When i put it in gear it runs at normal RMPS but is still given gas I do not give it. This problem just started today. For example, I will be driving 55 and the car will keep its speed without me giving it gas. Yes I can brake and the car slows down, but still slightly wants to go forward.
HELP ME I AM POOR

2006-08-24 11:48:50 · 8 answers · asked by slymedude 1

I just got a 2002 F-250 SD supercab diesel! and its stock.
I got it for $14,000! with 68k on it. I want to put a 8" inch lift and like 33"-36" tires and A loud exuast! I have $3500 to spend. I want most the lift. Now i have 17" inch on there, can i use same rims?
Can I do al this, can all this get done at a local garage?

2006-08-24 10:23:06 · 6 answers · asked by Anonymous

I am told by some that to replace ball joints on '98 Expedition, you
must replace the lower control arm. All of the auto parts stores I
have contacted sell ball joints as a replacement part, without the
control arm. Who has information about this? Please help.

2006-08-24 10:02:12 · 5 answers · asked by jobo38 2

2006-08-24 09:44:39 · 10 answers · asked by Anonymous

i was told that an 89 5.0 has 10 less hp than a 1991 5.0 but the engines are exactly the same as far as i can see. what makes the difference.

2006-08-24 09:16:43 · 5 answers · asked by Anonymous

2006-08-24 07:55:59 · 11 answers · asked by Anonymous

2006-08-23 17:25:54 · 8 answers · asked by madhouse 2

OK, I bought a 68 Thunderbird, I only got the door/ ignition key, the seller said if he can get his son to find the other key he would mail it to me. It is a1968 2 door Thunderbird, hardtop. Trunk lock is in the center under the flip up middlesection of the Tbird emblem. I do not want to drill the lock as it is expensive for me right now and hard to get.

2006-08-23 12:23:41 · 5 answers · asked by Anonymous

Does anyone know if the 2003 Ford Ranger had a recall on airbags not properly working? Or, has anyone had a problem with their airbags in a 2003 Ford Ranger?

2006-08-23 11:44:57 · 7 answers · asked by Jacqueline T 1

block casting i.d bore and stroke,con rod length ect

2006-08-23 10:47:55 · 3 answers · asked by Mike B 1

The car I want to import is a 1967 Ford Mustang GT 350, I also would like to to know any companies that do component upgrades for this vehicle. Please also include where I could get decent car insurance for the car and if there are any incurrent taxation costs that I need to know about. Additionally if anyone has any helpful info on Audi quattro S1's that would be nice too.

Thanks everyone

2006-08-23 09:09:46 · 6 answers · asked by Tamboman 1

Hey Guys/Gals,

I have a 1997 2.3L Ranger, but i bought the truck and it doesn't have a owner's manual. Does anybody know what fuse is the one that controls the interior lights?

What happened was I was driving down the road and the door sensor took a dump. So, I was driving with the interior lights on (because the sensor thought the door was open). So when i got home, i had to start pulling fuses until they went off (so the battery doesn't die). Well, it was pitch black out and I can't figure out what port it's supposed to be in now. Any help???

2006-08-23 08:32:10 · 3 answers · asked by bigred8882 4

I want loud exhaust, more horsepower, and better gas mileage.

2006-08-23 07:27:26 · 10 answers · asked by aquamustang 1

My car was running hot - flushed the system ,replaced thermostat, replaced radiator (ouch), replaced electric fan. Now the computer says it is running 219-235 but the gauge pegs on H?

2006-08-23 06:13:05 · 2 answers · asked by bucca 1

2006-08-22 20:41:33 · 2 answers · asked by catajam964 1

just wondering why my head lights would flicker. I have a faily lopey cam in it but it still does it while going down the free way.

2006-08-22 18:29:43 · 8 answers · asked by Anonymous

2006-08-22 15:05:48 · 5 answers · asked by tpereira1959 1

2006-08-22 14:06:45 · 17 answers · asked by PapaBear 3

i love the big three but i like the ford gt better but which on is your favorite?

2006-08-22 13:42:04 · 25 answers · asked by Anonymous