Ford

2006-08-22 12:17:21 · 4 answers · asked by Raul I 1

Im looking for one hubcap for an 86 ford Crown Vic, 15 inch, apparently its somewhat rare, with a red center and like 48 slots around the outer edge. i can only find a few online for over 65-70 dollars. None of my local salvage yards have one, does anyone have one to sell or know where i can find one cheap?

2006-08-22 10:07:29 · 4 answers · asked by isitabombsir 1

Is there going to be a recall ?

2006-08-22 09:08:26 · 14 answers · asked by Anonymous

went to garage they said i needed a new fuel reley but if put a new one in but its still the same cutting out.could you help me please

2006-08-22 08:26:27 · 13 answers · asked by jaygoodall1988 1

How much should I expect to spend for a normal factory 5.0 and transmission, automatic? Including getting it installed,

And what are some mods I can do to it to give it more HP?

2006-08-22 06:31:26 · 6 answers · asked by cj35453 1

2006-08-22 05:34:54 · 11 answers · asked by Anonymous

i like ford the best, CAN'T STAND CHEVY!!!

2006-08-22 05:23:17 · 14 answers · asked by Anonymous

2006-08-22 05:16:18 · 1 answers · asked by Anonymous

2006-08-22 04:13:20 · 4 answers · asked by Anonymous

Its not stock and it has around 580 hp lol its a bit more i just dont wanna say its full power

2006-08-21 20:33:13 · 17 answers · asked by svTeam Cobra 1

I have heard that the newer Ford Taurus engines are Mazda engines. Is this true?

2006-08-21 19:37:55 · 7 answers · asked by Shane 2

My cobra has been having issues starting up when fully warmed (ie after driving). If I turn the car off and then immediately try to start it back up the car's starter seems to barey turn (or the battery seems weak enough for an unsucessful start). After I let it sit for a while the car starts up perfectly normal. Early morning starts are even better with a quick turn of the key and the engine fires immedately up. So I want to approach this systematically...

*Battery cables are original..could degraded cables cause this symptom?
*Could the starter being going out. I have short tube headers (not long tubes) and I can't see the heat saturating the starter that much.
*The fuel tables and timing tables I have set in my tuner are "stock" numbers for up to 20% load (ie starting areas).
*Supercharger is on the passenger side away from the starter. It does not give off that much heat anyways.
*I have a 200amp alternator (stock is 130), the cable from the alt. to the motor is stock.

2006-08-21 18:47:15 · 6 answers · asked by cobramanphil 2

2006-08-21 15:46:34 · 5 answers · asked by Anonymous

2006-08-21 13:57:10 · 10 answers · asked by mary j 1

1987 f-150

2006-08-21 13:07:39 · 5 answers · asked by thomas l 1

I live in Michigan and i want to bay a 2002 or newer ford focus with less then 85,000 miles on it, does anyone kno where i could get one for under or around 6000.

Thank you very much

The best answer will get 10 pts.!

2006-08-21 12:18:06 · 8 answers · asked by ツ Andrea*♥ 4

my1998 ford tauras has a sick transmission and bad uv joints i can purchase a older 1995 ford tauras for parts my problem is i dont know if they will work if the company changed the car between those years and i havent lined up one specific macanic so i cant really ask anyone and the parts stores are little help

2006-08-21 12:05:41 · 3 answers · asked by igoauto 1

OR all 1973 FORD CARS.If also u can locate a fuel tank that can work on a 1973 FORD FAIRLANE.

2006-08-21 09:01:28 · 8 answers · asked by Anonymous

2006-08-21 08:36:08 · 8 answers · asked by mighty_tounge 2

when i was driving home my clutch went out, when i look under the hood i found a broken line, so i replace it and added more transmission fluid, now what?

2006-08-21 07:07:54 · 3 answers · asked by onalark p 1

2006-08-21 02:34:00 · 14 answers · asked by beer030 2

I have a problem with my 99 ford fiesta, every time I turn a bend (without applying the breaks) the car makes a squeaky noise as though the breaks need oiling but I dont touch them, so like, what's up with her? Any ideas? x

2006-08-21 00:13:54 · 18 answers · asked by Lisa D 2

will a 460 easily fit into the engine compartment of an 85 crown vic? what other engines fit into an 89 thunderbird? im trying to find stuff to do to my crown vic, any ideas?

2006-08-20 14:16:51 · 9 answers · asked by Anonymous

we have 1989 ford escort need to find out what parts may be missing but would still enable it to run.

2006-08-20 13:41:51 · 7 answers · asked by spidermonkey 1

need to know if it would bolt to the transmission too

2006-08-20 11:48:14 · 9 answers · asked by Paulette M 1

Hello, I want to install flowmaster mufflers on my car. I know my pipes are 2.25". My question is what size IN/OUT do I need in order to make them fit? Do I need 2.25" or 2.50" to make the pipes slide in a but then weld them on? Please don't tell me to ask a body shop they will never help me unless I pay them!

2006-08-20 10:43:28 · 2 answers · asked by kool_ghee 1

should i do a 360 thing in memory of dear gurty? will it help the healing process?

2006-08-20 08:08:57 · 10 answers · asked by Anonymous

That just when you get something paid off it falls apart?

2006-08-20 07:46:01 · 5 answers · asked by amylr620 5

I need to figure out how to unlock a truck with out the keys. Ford F-250 Super-Cab.

2006-08-20 07:23:49 · 3 answers · asked by mattascs 2

My teengage daughter drives my old car, a 2000 Ford Taurus. I haven't seen the car yet, but she says that the RPM drops suddenly (or sometimes spikes) when driving and when idling - and then sometimes stalls.

I know she's been buying cheap, no-name gas. Could that be the problem? I also know she doesn't maintain it regularly...

It shouldn't be the transmission (recently rebuilt)

Thanks in advance for any suggestions

2006-08-20 06:41:05 · 9 answers · asked by just_the_facts_ma'am 6