Ford

or are they making them elsewere

2006-08-29 08:38:14 · 11 answers · asked by charger_413 2

Can only purchase Ford, VW, Audi, Mercury, Dodge, Jeep & Lincoln. Thought about the Jeep Commander & Liberty - didnt really like. Am thinking about the Jetta Gli but am thinking that the interior is crap. Have also thought about Mustang and Escape. Would appreciate advice.

2006-08-29 07:59:33 · 12 answers · asked by Pa J 1

and a 2006 F-350 King Ranch that needs more rear suspension. I was going to get air bags but someone mentioned the load boosters are better. Just wanted to see if anyone had any experience with these. Thanks

2006-08-29 07:34:37 · 1 answers · asked by ladydreamer24 5

year: a 2001-2003

which is better LX or ZTS?

2006-08-28 18:41:50 · 10 answers · asked by babyblue1725 2

I have 89 mustang coup 5.0 and for I could say 5 years my blinker blinks realy slow and as i stop at a light and using the A/C it will just stay on the blink and thats it. I had the batery checked alternator replaced, replaced all baterie cables, and the actual blinker fues what can the problem be?

2006-08-28 18:41:24 · 12 answers · asked by mustangford302 1

Does anyone know were i can find ford wall posters off the internet? or anywere? (preferably ford EXCURSION) my whole room is ford and i cant find excursion posters anywere, and ive already looked on ebay, please tell me,

thanks,

2006-08-28 16:18:49 · 2 answers · asked by Anonymous

anyone know where to get it i want x pipes

2006-08-28 15:18:20 · 7 answers · asked by Anonymous

2006-08-28 15:13:58 · 36 answers · asked by whyme 1

mustang gt stock or a camaro z28 stock?

2006-08-28 15:11:12 · 22 answers · asked by Anonymous

it is a 91 f150 and in ugly condition
just over 100,000 miles
steering colum is broke and you have to start it with a screw driver
this is because i broke the key off and husband rigged it
back brakes need relaced
has a lot of rust and ugly paint

SOLID motor...it runs really well, i just don't like paying over $100 to fill u both its gas tanks

air conditioner don't work
am/fm sterio with m3 cd player new kenwood speakers


no foul noises, no colored smoke out of the tail, has had the oil changed regularly and tune ups regularly
just had a tune up

it also needs new tires

is $1000 too much for it
how much should i exect to get out of it

2006-08-28 13:37:41 · 5 answers · asked by Cap'n Donna 7

it is a 91 f150 and in bad condition
just over 100,000 miles
steering colum is broke and you have to start it with a screw driver
back brrakes need relaced
has a lot of rust and ugly paint

is $1000 too much for it
how much should i exect to get out of it

2006-08-28 12:38:54 · 20 answers · asked by Cap'n Donna 7

Ok I got it off just cant get it out!!

2006-08-28 06:54:03 · 3 answers · asked by Anonymous

i need a tip on how to get girls

2006-08-28 02:20:54 · 21 answers · asked by iamnotthemadone 1

Mint conditionRed with red interior

2006-08-27 12:56:31 · 7 answers · asked by skip o 1

Clutch wear, as per issued bulletin by Ford, That for best performance the plate, axle, & transmission must be of matching design. There is a mechinal flaw of its current design.

2006-08-27 12:52:17 · 4 answers · asked by mkleinman0823 1

I need to see a full view of the engine in a 1996 crown victoria 4.6 liter engine with a police package interceptor

2006-08-27 10:53:48 · 3 answers · asked by Anonymous

when this lite is blinking my cruse control does not work.

2006-08-27 09:59:51 · 3 answers · asked by ellington1787 1

2006-08-27 09:30:41 · 5 answers · asked by crown vic 1

When motor is cold will start very easy, When motor gets hot it wants to act like a low charged battery is on vehicle.Is timing way off ?

2006-08-27 07:18:15 · 8 answers · asked by jkfarmer862500 1

I have a 2001 Ford F-250 v8 deisel. I want to make it have alot of torque. I want it to be able to have the front end lift off the ground. it has a 6inch lift and 36's... What needed? and I only have about $7,000 left to spend.

2006-08-27 06:01:21 · 5 answers · asked by Anonymous

I have a 1986 5.0 mustang. I have to do head gaskets so since Im in that area I figure I will put rebuilt heads on. So I orderd some old school heads that should be around 60 combustion chamber. Then putting on a edelbrock performer intake and 600 CFM carb. Installing BBK shorty headers too. H pipe is gutted and for a exaust I have flow masters. What do you think this combo would put out for power? No longer the E6 heads so I have better breathing heads and more compression ratio.

2006-08-27 04:13:44 · 5 answers · asked by Anonymous

would taking out a thermistat from a hide a default from a potental buyer of a used car?

2006-08-27 02:20:35 · 20 answers · asked by nola_b 2

2006-08-27 01:14:01 · 5 answers · asked by John Smith 2

2006-08-26 15:16:49 · 7 answers · asked by pokey123 1

2006-08-26 13:13:58 · 15 answers · asked by Krytonite42 1

I dont know if the input/output splines are the same or if the length of the main shaft is the same

2006-08-26 12:55:07 · 4 answers · asked by tattedjoe 2

I have a '93.

2006-08-26 09:34:36 · 23 answers · asked by Anonymous

Are the engines in the 1994 Crown Vic and the Mustang the same? If not what is the difference?

2006-08-26 00:38:14 · 20 answers · asked by Anonymous

does any one know where any one can get a jurassic park ford exelorer like the one in the movie?

2006-08-25 21:31:42 · 5 answers · asked by godzilla man 1

I have a 2004 Mustang with the 40 Annivesary logo on it. I kind of want to upgrade to a 2006 Mustang. I have been told that the year and body of my Mustangs is better then the new ones. Has anyone had a 2004 and up graded to a 2006 and if yes can tell me which is better? There is this pretty dark blue one I have my eye on. Just wants some advice. Thanks!

2006-08-25 21:23:16 · 7 answers · asked by Humming Bird 4