Chevrolet

2006-12-17 16:40:01 · 5 answers · asked by Lil Reg 1

untill it wont go anywhere in any gear. if i restart engine repeats cycle, only one quart atf on install

2006-12-17 15:06:36 · 3 answers · asked by stylestealth 2

I HEARD IT CAN BE DONE AS LONG AS YOU GET THE REAR END INSTALLED BUT THAT WOULD BE A STARTING POINT FOR A HOTROD HOBBY & DO I HAVE PLANS...WHAT DO YOU THINK?

2006-12-17 14:50:56 · 8 answers · asked by MRS.HOTWHEELS 2

If not what do you think of yours? also looking for a 2006-7 chevy/gmc 1500 extended cab 2 wheel drive with a v-6 can anyone help. looking to trade the hhr is an lt1 with 5000 miles, imaculate. Thanks for your time.

2006-12-17 11:39:18 · 2 answers · asked by rhettkuritz 1

the manual says in the rear of the engine on passenger side, but i do not see it.

2006-12-17 10:34:37 · 5 answers · asked by Shawn L 2

where can i get a chevy nova besides ebay?

2006-12-17 07:35:38 · 3 answers · asked by kukinney26 2

i heard that it will....but i dont know for sure.

2006-12-17 07:25:54 · 8 answers · asked by Eric F 1

2006-12-17 04:53:15 · 1 answers · asked by Craig G 1

My camaro (z28 LT1) has six gears. The fifth gear does not work...it only grinds.
number one: is it bad to drive it without fifth gear on the hightway.

number two: How much does it cost "basicallly" to fix it, or is it something that can wait?

2006-12-17 03:23:42 · 6 answers · asked by Anonymous

I’m not sure on what 2 hoses I’m supposed 2 disconnect and attach together!
What part/piece do I need 2 connect the 2 hoses?
I believe I should drain the radiator first, right?

2006-12-17 02:39:24 · 10 answers · asked by lex 77 1

the emblem holes are already there, but most of my fender bolts are either rusted bad or stripped, and i'm afraid if I try to get the fender off I wont be able to get it back on there. so does anybody have any ideas of ways to attach a fender emblem without taking the fender off?

2006-12-16 12:07:05 · 6 answers · asked by wheels47012 3

2006-12-16 11:41:37 · 5 answers · asked by Anonymous

what i want know is can you take a diesel engine out and put a gasoline engine in and have it bolt up to the trans. that is already in there?

2006-12-16 11:36:38 · 4 answers · asked by Anonymous

2006-12-16 11:22:28 · 7 answers · asked by stittgerald 1

I would like to put a big engine in my mudding machine could i possibly put a chevy 383 in my 98 4dr chevy blazer?

2006-12-16 11:05:37 · 5 answers · asked by heavydragon2003 1

I NEED TO KNOW WHICH ONE IS BETTER IN OVERALL BECAUSE I WILL BE FEATURING EITHER ONE IN CHEVY HIGH PERFORMANCE AND SUPER STREET MAGAZINE. SO IT IS YOUR DESISION ON WHICH IS BEST IN PERFORMANCE, STYLING, BALH BLAH

2006-12-16 08:37:57 · 17 answers · asked by Anonymous

I just want to know the names, I am trying to locate one for a friend.

2006-12-16 07:41:00 · 5 answers · asked by stealth5033 3

Out of the blue my car will just not start for no good reason at all. It has managed to get over these spells in the past but we have never gotten a good reason for the occurances. My Impala has been towed into a Chevy dealer various times and for a fee they tell me that they found nothing wrong. The car managed to start on its own. Everything lights etc. that are supposed to come on does while trying to start it...you can hear the starter click..the car just won't crank. It occurs as if there is a shortage in the ignition or somewhere. My husband and I have tried everything even seeking "professional help" on several occassions. In the past after trying to crank the car up about 40-50 cranks it would start but I have had no luck the past couple of days...my car has not started at all.

I would appreciate any suggestions or comments from anyone with any experience or knowledge about the matter discussed above. I am completely frustrated now and out of a ride right now.

Many Thanks

2006-12-16 06:59:37 · 7 answers · asked by M. W 1

I want to see about buying a used one for now, the odometer on the old one is bad. It flashes goofy looking readouts but the correct milage does pop in once in awhile.

2006-12-16 06:46:35 · 5 answers · asked by Bob R 1

I installed everything, i think perfectly, and was driving, and some people pointed out that my taillights don't work, so i stopped and saw that taillights don't work and the lights in my speedometer and rest of panel. I don't know what I did wrong, but i know it's not the fuse, because i replaced them, and the problem still exists. I also took out the lights and put them to the battery, and they still work, so i know the lightbulbs aren't burned out, but yeah... I NEED HELP

2006-12-16 02:52:00 · 4 answers · asked by Anonymous

My husband is getting ready to install fuel injectors into a 1989 chevy astro van and he needs help with installing them.Does anyone know a easier way to install them than what is in the repair manual that he has? He isn't very mechanical inclined. Any help would be greatly appreciated. Or does anyone out there know how to install them and can tell him ? Thanks

2006-12-16 02:42:44 · 3 answers · asked by krazy_woman1970 1

2006-12-15 18:00:20 · 5 answers · asked by Anonymous

I have heard that there is a kill switch for the fuel but I can't find the manual to look it up. Or could it just be the fuel pump?

2006-12-15 13:38:26 · 13 answers · asked by luckysprettykitty 1

2006-12-15 10:32:04 · 20 answers · asked by Anonymous

I surrender. Where does the flasher kit go? It's not the fuse. It's not the switch. It's the flasher kit. I've checked Chiltons and gone on-line and asked friends and co-workers, and we've scoured the car. Anyone know where the flasher kit goes? Brake lights work, signals don't. Fuses are fine. Anyone? Anyone? Please?

2006-12-15 10:14:43 · 2 answers · asked by cavalierix 1

The speedo works part time along with the tranny not shifting too. I know the transmission depends on the speed sensor for shifting so I replaced the speed sensor but no luck. Then a month later heater is cuttin in and out along with radio. The car in question is a 1999 Monte Carlo with the 3.1 V6.

2006-12-15 09:54:15 · 5 answers · asked by gentlegiant255 2

i think it's 69
but thanks

2006-12-15 07:07:16 · 9 answers · asked by Illeagal Alien 3

my blazer is making noises when shifting from the drive shaft and squeaks when starting from first and slowing down

2006-12-15 06:59:44 · 13 answers · asked by hockeyjustin6688 1

I have a 94 Chevy Cheyenne, 2wd.
The stance, which some of you may know, dips in the front.
I want a 3" lift, but I also want both ends to level out.
What & where do I find what I need?

2006-12-15 05:15:00 · 2 answers · asked by sum4182girl 3

2006-12-15 01:23:22 · 9 answers · asked by nirvanarocks75 2