English Deutsch Français Italiano Español Português 繁體中文 Bahasa Indonesia Tiếng Việt ภาษาไทย
All categories

Chevrolet

[Selected]: All categories Cars & Transportation Car Makes Chevrolet

2006-12-14 16:54:20 · 2 answers · asked by spankysmom01 2

I have a 1990 Camaro RS. I want to put 19 inch rims on it, what offset do i need to get and what is my bolt pattern measurement?

2006-12-14 16:25:06 · 5 answers · asked by Jason M 1

2006-12-14 13:00:37 · 6 answers · asked by Cf Precious 3

I recently came across a 70 chevelle that had what looked like holes (that the chrome molding went on) on the top side of each fender going across the length of the car on both sides.My question was this a special edition chevelle or were all those holes just man-made?I've only seen the malibu's with the moldings on the side but they were always in the middle and these holes were extremely precise and exact(on both sides)to be man-made unless my vision is going.Thanks.

2006-12-14 12:32:05 · 8 answers · asked by sjb990002 1

it drives me crazy.....starts up no problem in the morning, if i run into a store or get gas or anything and shut the car off im killin my starter for like 5 seconds!!!

2006-12-14 08:56:35 · 7 answers · asked by Anonymous

stalls, new sensors, new fuel filter, has fuel pressure, no codes in ecm, could it be the ecm??, heard they have troubles.

2006-12-14 01:50:45 · 5 answers · asked by Aaron L 1

starts sometimes better have changed the fuel filter to no evale any ideas would be helpful

2006-12-13 11:41:42 · 8 answers · asked by dogma12155 1

2004 Blazer has recurring "check engine light" problem with only 33,000 miles on it. Each time it happens the dealer sells him a new gas cap and resets the light. He's already bought 4 new gas caps, and now the light is on AGAIN. Can anybody tell us what the problem really is, and how to fix it? Thank you very much!

2006-12-13 07:08:45 · 5 answers · asked by nachtmann2 5

On the Z28 Camaro, there are two tubes that come off the top of each exhaust manifold and go under the engine. Are these tubes supposed to connect to something under the engine, or do they just connect to eachother?

2006-12-13 06:04:28 · 3 answers · asked by jeff_is_sexy 4

2006-12-13 05:17:46 · 3 answers · asked by roatandmp 1

2006-12-13 02:56:31 · 4 answers · asked by BRIAN P 1

2006-12-13 00:25:37 · 6 answers · asked by Anonymous

Looking for a complete rear cabin wall for 1300 (3100)
New or used.
Thanks

2006-12-12 20:41:20 · 6 answers · asked by darksideofthemoon 1

I have a 1967 chevy c20 2wd heavy 3/4 ton pickup truck. It has 4 wheel drum brakes and power assist steering from the factory. I want to change the front drum brakes to disk, and change the power assist steering to true power steering. I have access to a 1995 Chevy 1 ton truck for parts. I plan on using all of the steering linkage, p.s. pump, control arms, gearbox, spindles, steering shaft, brake booster, and all brake materials from the 1995 to retrofit the 1967. I know you can accomplish this interchange with Chevy trucks up to 1987, but I don't know if the newer body styles will also interchange. Any info would be greatly appreciated!

2006-12-12 15:59:20 · 3 answers · asked by JJ 1

the truck runs great but every now and then every 60 miles or so it just cuts out. every now and then ill have to restart it but it is always while im under way. any ideas ? if it was gas powered i would say it was electrical but its not.

2006-12-12 12:52:21 · 4 answers · asked by Anonymous

400 smallblock

2006-12-12 11:33:45 · 5 answers · asked by ricer killa 1

this is on my 1994 chevy s10 truck the truck runs and on occasion it decides to stop running, its not throwing any trouble codes at all but the vehicles computer will not talk to my scanner and when in self diagnostic mode it only sends acknowledgment code,and that is all when it dies it usualy after being driven.ive replaced pugs,cap,rotorcap and ignition modual.fuel pressure is supposed to be good as stated this is intermitent,because there is no warning when it does it and it stays down for at a minimum of a half an hour to a hole day

2006-12-12 10:06:01 · 5 answers · asked by billy w 1

2006-12-12 07:46:46 · 21 answers · asked by Anonymous

The switch on the passenger side of my suburban doen't work.
I can open the window from the Master panel on the drivers side.
I changed the switch but it still doesn't work. Any ideas.

2006-12-12 07:26:16 · 2 answers · asked by gary b 3

and what else it looks like a plant of some kind Help!!!!!

2006-12-12 05:44:17 · 5 answers · asked by j_greystoke 2

my trunk lock is broken and i need to change the bulds in my tailigts cuss thier burnt out and i keep getting pulled over. is there a way i can change them without opeing the trunk?

2006-12-12 05:25:47 · 4 answers · asked by Anonymous

2006-12-12 04:17:52 · 5 answers · asked by militarygramma 1

fedest.com, questions and answers